环形喷管水下气体射流夹断过程

doi:10.11949/j.issn.0438-1157.20170666

化工学报 ›› 2017, Vol. 68 ›› Issue (12): 4565-4575.DOI: 10.11949/j.issn.0438-1157.20170666

环形喷管水下气体射流夹断过程

李婷婷^1,2, 胡俊¹, 曹雪洁¹, 于勇¹

1 北京理工大学宇航学院, 飞行器动力学与控制教育部重点实验室, 北京 100081;
2 中航工业第一飞机设计研究院, 陕西西安 710089

收稿日期:2017-05-22 修回日期:2017-08-31 出版日期:2017-12-05 发布日期:2017-12-05
通讯作者: 胡俊
基金资助:
国家自然科学基金项目（11372041）。

Pinch-off process of underwater annular-nozzled gas jet

LI Tingting^1,2, HU Jun¹, CAO Xuejie¹, YU Yong¹

1 Key Laboratory of Dynamic and Control of Flight Vehicle, School of Aerospace Engineering, Beijing Institute of Technology, Beijing 100081, China;
2 The First Aircraft Institute, Aviation Industry Corporation of China, Xi'an 710089, Shaanxi, China

Received:2017-05-22 Revised:2017-08-31 Online:2017-12-05 Published:2017-12-05
Supported by:
supported by the National Natural Science Foundation of China (11372041).

摘要/Abstract

摘要：

对水下竖直环形喷管出口气体射流现象进行了研究，采用高速摄影仪记录了水下气体射流发展过程，并通过MATLAB编程处理图片的方式，对夹断的判定、夹断的位置和频率做了探讨，对环形喷管射流的特性进行了分析。结果表明：环形喷管水下气体射流呈现出持续射流和集中夹断两种阶段；在本文工况下，水下气体射流离喷口越近，夹断次数越多，离喷口越远，夹断次数越少；对于本文所有喷管，其动量射流段发生夹断的频率都随气体流量增加而减小；水下气体射流的回击现象并不是气体反向倒流撞击喷管端面形成的，而是夹断发生后，后续喷入的气体在轴向受阻，进而横向扩张的结果；对于环缝大小一定的喷管，气体流量越大，射流穿透深度越大。

关键词: 水下气体射流, 夹断, 回击, 穿透深度

Abstract:

An experimental study was carried out on basic phenomena, pinch-off characteristics and penetration depth of underwater gas jet ejecting out of a vertical annular nozzle. The process of gas jet development was recorded by a high-speed camera, and jet interfaces were tracked by processing pictures with an edge detection algorithm. The pinch-off spatial distribution was determined by summation of downstream position across all recorded times. The gas jet penetration distance was calculated by counting transient pixel values divided by measured time duration of gas observed for all pixel locations. The color contour was used to indicate time percentage for gas to occupy a certain location in the field of view. The results show that underwater annular-nozzled gas jets exhibit two stages of continuous jet and centralized pinch-off. More pinch-off occurs near nozzle and less pinch-off occurs further away from nozzle in the study conditions. Pinch-off frequency at momentum jet section for all nozzles is reduced with the increase of gas flow rate. Back-attack phenomenon upon pinch-off is the result of axial obstruction and transverse expansion of subsequent gas instead of gas flowing backwards and impinging on nozzle end. The jet penetration distance is proportional to gas flow rate for ring seams of same sizes.

Key words: underwater gas jet, pinch-off, back-attack, penetration depth

中图分类号:

O359⁺.1

李婷婷, 胡俊, 曹雪洁, 于勇. 环形喷管水下气体射流夹断过程[J]. 化工学报, 2017, 68(12): 4565-4575.

LI Tingting, HU Jun, CAO Xuejie, YU Yong. Pinch-off process of underwater annular-nozzled gas jet[J]. CIESC Journal, 2017, 68(12): 4565-4575.

参考文献 35

[1]	YANG Q X, GUSTAVSSON H, BURSTROM E. Erosion of refractory during gas injection. A cavitation based model[J]. Scandinavian Journal of Metallurgy, 1990, 19(3):127-136.
[2]	YANG Q X, GUSTAVSSON H. Effects of gas jet instability on refractory wear. A study by high-speed photography[J]. Scandinavian Journal of Metallurgy, 1992, 21(1):15-26.
[3]	GULAWANI S S, DESHPANDE S S, JOSHI J B, et al. Submerged gas jet into a liquid bath:a review[J]. Industrial & Engineering Chemistry Research, 2007, 46(10):3188-3218.
[4]	MATSUMOTO O, SUGIHARA M, MIYA K. Underwater cutting of reactor core internals by CO laser using local-dry-zone creating nozzle[J]. Journal of Nuclear Science & Technology, 2012, 29(11):1074-1079.
[5]	ROSS C T F. A conceptual design of an underwater missile launcher[J]. Ocean Engineering, 2005, 32(1):85-99.
[6]	WEILAND C J, VLACHOS P P, YAGLA J J. Concept analysis and laboratory observations on a water piercing missile launcher[J]. Ocean Engineering, 2010, 37(11/12):959-965.
[7]	宫建, 何宝培. 气水两相流场观察实验[C]//全国实验流体力学学术会议. 太原, 2004. GONG J, HE B P. Observation experiment of gas-water two-phase flow field[C]//Chinese National Conference on Experimental Fluid Mechanics. Taiyuan, 2004.
[8]	HOEFELE E O, BRIMACOMBE J K. Flow regimes in submerged gas injection[J]. Metallurgical Transactions B, 1979, 10(4):631-648.
[9]	SANO M, MAKINO H, OZAWA Y. Behavior of gas jet and plume in liquid metal[J]. ISIJ International, 1986, 26(4):298-304.
[10]	TAYLOR I F, WRIGHT J K, PHILP D K. Transient pressure and vibration events resulting from high speed gas injection into liquids[J]. Canadian Metallurgical Quarterly, 1988, 27(4):293-301.
[11]	MORI K, OZAWA Y, SANO M. Characterization of gas jet behavior at a submerged orifice in liquid metal[J]. ISIJ International, 1982, 22(5):377-384.
[12]	OZAWA Y, MORI K. Characteristics of jetting observed in gas injection into liquid[J]. Transactions of the Iron & Steel Institute of Japan, 1983, 23(9):764-768.
[13]	MCNALLAN M J, KING T B. Fluid dynamics of vertical submerged gas jets in liquid metal processing systems[J]. Metallurgical and Materials Transactions B, 1982, 13(2):165-173.
[14]	ZHAO Y F, IRONS G A. The breakup of bubbles into jets during submerged gas injection[J]. Metallurgical and Materials Transactions B, 1990, 21(6):997-1003.
[15]	DIMOTAKIS P E, MIAKELYE R C, PAPANTONIOU D A. Structure and dynamics of round turbulent jets[J]. Physics of Fluids, 1983, 26(11):3185-3192.
[16]	戚隆溪, 曹勇, 王柏懿. 水下欠膨胀高速气体射流的实验研究[J]. 力学学报, 2000, 32(6):667-675. QI L X, CAO Y, WANG B Y. Experimental study of under-expanded sonic air jets in water[J]. Chinese Journal of Theoretical and Applied Mechanics, 2000, 32(6):667-675.
[17]	SURIN V A, EVCHENKO V N, RUBIN V M. Propagation of a gas jet in a liquid[J]. Journal of Engineering Physics and Thermophysics, 1983, 45(4):1091-1101.
[18]	WRAITH A, CHALKLY M. Advances in Extractive Metallurgy and Refining[M]. London:Institute of Mining and Metallurgy, 1972.
[19]	OZAWA Y, MORI K. Effect of physical properties of gas and liquid on bubbling-jetting phenomena in gas injection into liquid[J]. Transactions of the Iron & Steel Institute of Japan, 1986, 26(4):291-297.
[20]	EPSTEIN M, FAUSKE H K, KUBO S, et al. Liquid entrainment by an expanding core disruptive accident bubble-a Kelvin/Helmholtz phenomenon[J]. Nuclear Engineering & Design, 2001, 210(1):53-77.
[21]	王柏懿, 戴振卿, 戚隆溪, 等. 水下超音速气体射流回击现象的实验研究[J]. 力学学报, 2007, 39(2):267-272. WANG B Y, DAI Z Q, QI L X, et al. Experimental study on back-attack phenomenon in underwater supersonic gas jets[J]. Chinese Journal of Theoretical and Applied Mechanics, 2007, 39(2):267-272.
[22]	AOKI T, MASUDA S, HATANO A, et al. Characteristics of submerged gas jets and a new type bottom-blowing tuyere[M]//Injection Phenomena in Extraction and Refining. WRAITH A E. Newcastle:Department of Metallurgy and Engineering Material(Univemity of Newcastle upon Tyne), 1982:A1-A36.
[23]	KORIA S C. Principles and applications of gas injection in steelmaking practice[J]. Scandinavian Journal of Metallurgy, 1993, 22:271-279.
[24]	TSUCHIYA Y, HORIKOSHI C. On the spread of rectangular jets[J]. Experiments in Fluids, 1986, 4(4):197-204.
[25]	LOZANOVA M, STANKOV P. Experimental investigation on the similarity of a 3D rectangular turbulent jet[J]. Experiments in Fluids, 1998, 24(5/6):470-478.
[26]	胡俊, 姜建玉, 于勇, 等. 环形喷管喷口气泡演化的实验研究[J].力学学报, 2016, 48(1):86-94. HU J, JIANG J Y, YU Y, et al. Experimental investigation of bubble evolution on annular nozzle[J]. Chinese Journal of Theoretical and Applied Mechanics, 2016, 48(1):86-94.
[27]	LARSON L R, TEIGLAND G L, ANDERSON N, et al. Concentric canister launcher[P]:US6230604. 2001.
[28]	YAGLA J J, BUSIC J, KOSKI S, et al. Launch dynamics environment of a water piercing missile launcher[J]. Journal of Hepatology, 2013, 52(10):S406.
[29]	DAI Z, WANG B, QI L, et al. Experimental study on hydrodynamic behaviors of high-speed gas jets in still water[J]. Acta Mechanica Sinica, 2006, 22(5):443-448.
[30]	刘沛清. 自由紊动射流理论[M]. 北京:北京航空航天大学出版社, 2008. LIU P Q. Free Turbulent Jet Theory[M].Beijing:Beihang University Press, 2008.
[31]	FISCHER H, LIST E, KOH R, et al. Mixing in Inland and Coastal Water[M]. New York:Academic Press, 1979.
[32]	TROSS S. Characteristics of a turbulent, two-phase, submerged, free jet[D]. Pennsylvania:The Pennsylvania State University. 1974.
[33]	LOTH E, FAETH G M. Structure of under expanded round air jets submerged in water[J]. International Journal of Multiphase Flow, 1989, 15(4):589-603.
[34]	CASTILLEJOS A H, BRIMACOMBE J K. Measurement of physical characteristics of bubbles in gas-liquid plumes(Ⅰ):An improved electroresistivity probe technique[J]. Metallurgical Transactions B, 1987, 18(4):649-658.
[35]	ITO K, KOBAYASHI S, TOKUDA M. Mixing characteristics of a submerged jet measured using an isokinetic sampling probe[J]. Metallurgical Transactions B, 1991, 22(4):439-445.

环形喷管水下气体射流夹断过程

Pinch-off process of underwater annular-nozzled gas jet

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 35

相关文章 1

编辑推荐

Metrics

本文评价