机械加工表面多孔管降膜沸腾传热的研究

CIESC Journal

机械加工表面多孔管降膜沸腾传热的研究

王国庆,谭盈科,王世平,崔乃瑛

华南理工大学化学工程研究所,华南理工大学化学工程研究所,华南理工大学化学工程研究所,华南理工大学化学工程研究所广州 ,广州 ,广州 ,广州

出版日期:1990-02-25 发布日期:1990-02-25

A Study of Spray Falling Film Boilng on Horizontal Mechanically Made Porous Surface Tubes

Wang Guoqing, Tan Yingke, Wang Shiping and Cui Naiying (Chemical Engineering Research Institute, South China University of Technology, Guangzhou)

Online:1990-02-25 Published:1990-02-25

摘要/Abstract

摘要： 本文报道了机械加工表面多孔管(JK-1管)水平管外降膜沸腾的传热性能及其分析.实验工质为R-113.结果表明:JK-1管降膜沸腾传热膜系数比其池式沸腾提高11—80%,比光滑管降膜沸腾提高1.7—5.2倍.通过分析,建立了一个预测值与实验值偏差在±8%以内的准则关联式.

Abstract: The present paper describes a study of spray falling film boiling on horizontal mechanically made porous surface tubes (JK-1 tubes). R-113 was used as the working fluid. The results indicated that there was a 11-80% increase of heat transfer coefficients for falling film boiling on the enhanced lubes in comparison with those of their pool boiling; and there was a 2.7-6.2 times increase in comparison with those for falling film boiling on a smooth tube. Based on the analysis, a correlation was proposed which could predict spray falling film boiling heat transfer coefficients for horizontal mechanically made porous surface tubes within a relative deviation of±8%.

王国庆,谭盈科,王世平,崔乃瑛. 机械加工表面多孔管降膜沸腾传热的研究 [J]. CIESC Journal.

Wang Guoqing, Tan Yingke, Wang Shiping and Cui Naiying (Chemical Engineering Research Institute, South China University of Technology, Guangzhou). A Study of Spray Falling Film Boilng on Horizontal Mechanically Made Porous Surface Tubes[J]. .