基于ANSYS Workbench和FLUENT的超临界二氧化碳萃取釜流场模拟及其结构改进

化工进展

基于ANSYS Workbench和FLUENT的超临界二氧化碳萃取釜流场模拟及其结构改进

郭建章1，赵鹏1，王威强2

1青岛科技大学机电工程学院，山东青岛 266061；2山东大学机械工程学院，山东济南 250061

出版日期:2012-09-05 发布日期:2012-09-25

Flow field simulation of supercritical carbon dioxide extractor based on ANSYS Workbench and FLUENT and its structure improvement

GUO Jianzhang1，ZHAO Peng1，WANG Weiqiang2

1School of Electromechanical Engineering, Qingdao University of Science and Technology, Qingdao 266061，Shandong，China；2School of Mechanical Engineering, Shandong University, Jinan 250061，Shandong，China

Online:2012-09-05 Published:2012-09-25

摘要/Abstract

摘要： 传统超临界萃取釜的不足主要表现在：萃取筐占据筒体容积，造成萃取釜空间利用率降低；萃取筐与筒体内壁存在间隙，造成传质、传热效果不良。本文对萃取釜进行结构改造，采用双封头结构，封头上设置筛网，采用径向进气方式。利用ANSYS Workbench及FLUENT软件，模拟了改进结构在空载和装料两种情况下的温度场和流场，对比分析了两种情况下的温度场和流场。比较结果说明，改进后的萃取釜结构不仅提高了萃取釜的空间利用率，而且改善了萃取釜的温度场均匀性，萃取釜的流场均匀性也有提高。

关键词: ANSYS Workbench, FLUENT, 萃取釜, 流场模拟, 结构改进

Abstract: The shortcomings of the traditional supercritical carbon dioxide extractor are as follows: low space utilization ratio of the extractor owing to the extraction basket occupying the cylinder volume; bad mass transfer and heat transfer owing to the gap between extraction basket and cylinder wall. Aiming at the shortcomings, the extractor structure was improved. Double head structure and radial inlet way were adopted, and a filter screen was set up on the head. Based on ANSYS Workbench and FLUENT, the flow field and temperature field of the improved extractor was simulated at both load and zero load. The simulation results were compared in different situations. The results showed that the improved structure promoted the space utilization ratio and improved the uniformity of flow field and temperature field.

Key words: ANSYS Workbench, FLUENT, extractor, flow field simulation, structure improvement

郭建章1，赵鹏1，王威强2. 基于ANSYS Workbench和FLUENT的超临界二氧化碳萃取釜流场模拟及其结构改进[J]. 化工进展.

GUO Jianzhang1，ZHAO Peng1，WANG Weiqiang2. Flow field simulation of supercritical carbon dioxide extractor based on ANSYS Workbench and FLUENT and its structure improvement[J]. Chemical Industry and Engineering Progree.

[1]	朱俊, 周政霖, 刘作华, 郑雄攀, 刘仁龙, 陶长元, 王运东. 刚柔组合搅拌桨强化流体混合的流固耦合行为[J]. 化工学报, 2015, 66(10): 3849-3856.
[2]	付磊，唐克伦，文华斌，王维慧，付伶. 管壳式换热器流体流动与耦合传热的数值模拟[J]. 化工进展, 2012, 31(11): 2384-2389.
[3]	金丹，付海玲，吴剑华，孙丹. 混合器停留时间分布的研究进展 [J]. CIESC Journal, 2011, 30(7): 1399-.
[4]	刘飞妮, 张国亮, 孟琴, 章宏梓. Performance of Nanofiltration and Reverse Osmosis Membranes in Metal Effluent Treatment[J]. CIESC Journal, 2008, 16(3): 441-445.
[5]	苗晶, 李玲玲, 陈国华, 高从堦, 董声雄. Preparation of N,O-carboxymethyl Chitosan Composite Nanofiltration Membrane and Its Rejection Performance for the Fermentation Effluent from a Wine Factory[J]. CIESC Journal, 2008, 16(2): 209-213.
[6]	赵东胜，刘桂敏，赵艳丽，吴兆亮 . 气升式反应器研究进展 [J]. CIESC Journal, 2007, 26(6): 810-.
[7]	宋健斐;魏耀东;时铭显. 蜗壳式旋风分离器气相流场的非轴对称特性的模拟 [J]. CIESC Journal, 2005, 56(8): 1397-1402.
[8]	邓超;史鹏飞. 密封双极性MH/Ni电池结构改进与研制 [J]. CIESC Journal, 2005, 56(2): 342-345.
[9]	李保红, 樊希山, 姚平经. 一种新的废水处理系统设计方法[J]. CIESC Journal, 2002, 10(3): 273-280.