亚格子过滤双流体模型的网格依赖性

doi:10.3969/j.issn.0438-1157.2013.03.013

化工学报 ›› 2013, Vol. 64 ›› Issue (3): 877-885.DOI: 10.3969/j.issn.0438-1157.2013.03.013

亚格子过滤双流体模型的网格依赖性

闫小康^1,2, William Holloway², Sankaran Sundaresan², 杨建国¹, 刘炯天¹

1. 中国矿业大学化工学院,江苏徐州 221008;
2. 普林斯顿大学化学工程系,新泽西08544

收稿日期:2012-06-14 修回日期:2012-09-23 出版日期:2013-03-05 发布日期:2013-03-05
通讯作者: 闫小康,Sankaran Sundaresan
作者简介:闫小康(1981—),女,博士研究生。
基金资助:
国家重点基础研究发展计划项目(2012CB214900);国家自然科学基金项目(51204180)。

Grid-independence of sub-grid filtered two-fluid models

YAN Xiaokang^1,2, William Holloway², Sankaran Sundaresan², YANG Jianguo¹, LIU Jiongtian¹

1. School of Chemical Engineering, China University of Mining and Technology, Xuzhou 221008, Jiangsu, China;
2. Department of Chemical Engineering, Princeton University, Princeton, New Jersey 08544, USA

Received:2012-06-14 Revised:2012-09-23 Online:2013-03-05 Published:2013-03-05
Supported by:
supported by the National Basic Research Program of China(2012CB214900)and the National Natural Science Foundation of China(51204180).

摘要/Abstract

摘要： 基于双流体方程和颗粒动力学理论的计算模型被广泛应用于流化床的气固两相流数值计算,高精度网格是其准确计算流动的必要条件。一些经典的微尺度阻力模型,其网格尺度决定其模拟结果的精度。亚格子过滤双流体模型是一种有效的适用于粗糙网格的计算模型,其包含的气固相间作用力和颗粒相应力本构方程是在高精度网格条件下,以微尺度双流体方程和颗粒动力学理论计算得到的气固流场为基础,对计算结果进行小尺度过滤后得出。使用亚格子过滤双流体模型替换基于颗粒动力学理论的双流体模型,针对同一物理问题,在不同网格尺度下进行了数值计算,结果表明此计算模型相比经典阻力模型具有较好的网格无关特性,并且和实验结果较为一致。同时也对颗粒动力学理论与之相结合进行了尝试,即仅使用亚格子过滤阻力模型,颗粒相应力仍然使用颗粒动力学模型,其计算结果的网格无关性及与实验值的吻合程度优于经典模型。

关键词: 亚格子, 过滤气固双流体模型, 网格无关性, 粗网格

Abstract: Fine grid resolution is necessary to fully demonstrate the accuracy of two-fluid model(TFM) in predicting gas-solids flows in the riser section of circulating beds.Insufficient grid resolutions will likely lead to incorrect solutions.In most industrial applications involving large devices,it is impractical to use fine grids,and therefore,constitutive models that are suitable for the coarse-grid TFM simulations are required.It has been reported in some literatures that microscopic drag laws,such as those due to Gibilaro and Gidaspow,did not yield grid-independent solutions over the range of grid sizes investigated in some test problems.Filtered two-fluid models were developed using the results of highly resolved simulations.A filtering procedure was applied to the results of these simulations to deduce the constitutive models for the residual correlations appearing in the corresponding filtered TFM equations.These equations were appropriate for coarse-grid simulations of gas-particle flows.Using the same example studied by Mckeen and Pugsley(2003),it was first demonstrated that grid-independent predictions could be afforded by a filtered TFM,in which filtered drag and particle phase stress models were included.Then grid-independent and experimentally consistent solutions could also be obtained with filtered TFM model when filtered particle phase stress model was replaced with kinetic theory model as long as filtered fluid-particle drag force model was used.

Key words: sub-grid, filtered two-fluid model, grid-independence, coarse grid

中图分类号:

TQ021.1

闫小康, William Holloway, Sankaran Sundaresan, 杨建国, 刘炯天. 亚格子过滤双流体模型的网格依赖性[J]. 化工学报, 2013, 64(3): 877-885.

YAN Xiaokang, William Holloway, Sankaran Sundaresan, YANG Jianguo, LIU Jiongtian. Grid-independence of sub-grid filtered two-fluid models[J]. CIESC Journal, 2013, 64(3): 877-885.

参考文献 22

[1]	Wang X F,Jin B S,Xiong Y Q,Zhong W Q.Flow behaviors of gas-solid injector by 3D simulation with kinetic theory of granular flow[J].Chinese Journal of Chemical Engineering,2008,16:823-831
[2]	Zhong W Q,Zhang M Y,Jin B H,Yuan Z L.Three-dimensional simulation of gas/solid flow in spout-fluid beds with kinetic theory of granular flow[J].Chinese Journal of Chemical Engineering,2006,14:611-617
[3]	Benyahia S.Fine-grid simulations of gas-solids flow in a circulating fluidized bed[J].AIChE J.,2012,58:3589-3592
[4]	Agrawal K,Loezos P N,Syamlal M,Sundaresan S.The role of meso-scale structures in rapid gas-solid flows[J].J.Fluid Mech.,2001,445:151-185
[5]	Wang J W.High-resolution Eulerian simulation of RMS of solid volume fraction fluctuation and particle clustering characteristics in a CFB riser[J].Chem.Eng.Sci.,2008,63:3341-3347
[6]	O'Brien T,Syamlal M.Particle cluster effects in the numerical simulation of a circulating fluidized bed. Circulating Fluidized Bed Technology Ⅳ//Hidden A A,ed.Proceedings of the Fourth International Conference on Circulating Fluidized Beds.Valley Conference Center,Somerset,PA,1993:1-5
[7]	Heynderickx G J,Das A K,De Wilde J,Marin G B. Effect of clustering on gas-solid drag in dilute two-phase flow[J].Ind.Eng.Chem.Res.,2004,43:4635-4646
[8]	McKeen T,Pugsley T. Simulation and experimental validation of a freely bubbling bed of FCC catalyst[J].Powder Technology,2003,129(1/2/3):139-152
[9]	Dasgupta S,Jackson R,Sundaresan S.Turbulent gas-particle flow in vertical risers[J].AIChE J.,1994,40:215-228
[10]	Li J H,Kwauk M.Exploring complex systems in chemical engineering—the multi-scale methodology[J].Chem. Eng. Sci.,2003,58:521-535
[11]	Yang N,Wang W,Ge W,Wang L N,Li J H.Simulation of heterogeneous structure in a circulating fluidized-bed riser by combining the two-fluid model with the EMMS approach[J].Ind.Eng.Chem.Res.,2004,43:5548-5561
[12]	Yang N,Wang W,Ge W,Li J H.Analysis of flow structure and calculation of drag coefficient for concurrent-up gas-solid flow[J].Chinese Journal of Chemical Engineering,2003,11:79-84
[13]	Atsonios K,Nikolopoulos A,Karellas S,Nikolopoulos N,Grammelis P,Kakaras E.Numerical investigation of the grid spatial resolution and the anisotropic character of EMMS in CFB multiphase flow[J].Chem.Eng.Sci.,2011,66:3979-3990
[14]	Igci Y,Pannala S,Benyahia S,Sundaresan S.Validation studies on filtered model equations for gas-particle flows in risers[J].Ind.Eng.Chem.Res.,2012,51:2094-2103
[15]	Igci Y,Andrews A T,Sundaresan S,Pannala S,O'Brien T.Filtered two-fluid models for fluidized gas-particle suspensions[J].AIChE J.,2008,54:1431-1448
[16]	Igci Y,Sundaresan S.Verification of filtered two-fluid models for gas-particle flows in risers[J].AIChE J.,2011,57:2691-2707
[17]	Igci Y,Sundaresan S.Constitutive models for filtered two-fluid models of fluidized gas-particle flows[J].Ind. Eng. Chem. Res.,2011,50:13190-13201
[18]	Gibilaro L G,Difelice R,Waldram S P,Foscolo P U. Generalized friction factor and drag coefficient correlations for fluid particle interactions[J].Chem. Eng. Sci.,1985,40:1817-1823
[19]	Lindborg H,Lysberg M,Jakobsen H A.Practical validation of the two-fluid model applied to dense gas-solid flows in fluidized beds[J].Chem.Eng.Sci.,2007,62:5854-5869
[20]	Lu B,Wang W,Li J.Searching for a mesh-independent sub-grid model for CFD simulation of gas-solid riser flows[J].Chem.Eng.Sci.,2009,64:3437-3447
[21]	Wang J W,van der Hoef M A,Kuipers J A M.Why the two-fluid model fails to predict the bed expansion characteristics of Geldart A particles in gas-fluidized beds:a tentative answer[J].Chem.Eng.Sci.,2009,64:622-625
[22]	Wen C Y,Yu Y H.Mechanics of fluidization[J].Chemical Engineering Progress Symposium Series,1966,62:100-111

亚格子过滤双流体模型的网格依赖性

Grid-independence of sub-grid filtered two-fluid models

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 22

相关文章 1

编辑推荐

Metrics

本文评价