化工学报 ›› 2015, Vol. 66 ›› Issue (1): 142-148.DOI: 10.11949/j.issn.0438-1157.20140919

• 分离工程 • 上一篇    下一篇

纳米聚苯胺改性聚哌嗪酰胺纳滤膜的制备

李洪懿, 翟丁, 周勇, 高从堦   

  1. 杭州水处理技术研究开发中心有限公司, 浙江 杭州 310012
  • 收稿日期:2014-06-18 修回日期:2014-08-26 出版日期:2015-01-05 发布日期:2015-01-05
  • 通讯作者: 周勇
  • 基金资助:

    国家高技术研究发展计划项目(2012AA03A608)。

Polyamide composite NF membrane modified with polyaniline nanoparticles

LI Hongyi, ZHAI Ding, ZHOU Yong, GAO Congjie   

  1. Development Center of Hangzhou Water Treatment Technology, Hangzhou 310012, Zhejiang, China
  • Received:2014-06-18 Revised:2014-08-26 Online:2015-01-05 Published:2015-01-05
  • Supported by:

    supported by the National High Technology Research and Development Program of China (2012AA03A608).

摘要:

以导电态纳米聚苯胺(PANI)为添加剂, 哌嗪和均苯三甲酰氯(TMC)为反应单体, 通过界面聚合反应在聚砜超滤膜上形成复合层制备纳滤膜。采用扫描电子显微镜(SEM)和原子力显微镜(AFM)等对复合膜的性能和结构分别进行了测试和表征。SEM照片证实PANI含量低时, 可以在复合膜上分布得比较均匀;AFM图像看出膜表面粗糙度的增加;膜性能的测试结果证实了添加PANI的复合膜水通量得到了提高, 同时脱盐率也有变化。最优实验条件下, 膜对Na2SO4、MgSO4、MgCl2和NaCl的截留率分别为99.4%、98.5%、85.4%和59.2%。试验结果表明, 加入PANI能够提高膜的水通量, 并提升了膜的脱盐性能。

关键词: 聚苯胺, 哌嗪, 纳滤膜, 界面聚合, 粗糙度

Abstract:

A composite nanofiltration (NF) membrane was prepared using polyaniline nanoparticles (PANI) as additive by interfacial polymerization between piperazine and trimesoyl chloride (TMC) on the PSF ultrafiltration membrane. The properties and structure of the membrane were characterized with permeation experiment, scanning electron microscopy (SEM) and atomic force microscope (AFM). SEM images showed that PANI was well dispersed in the thin film layer at a low content of PANI. AFM photographs showed the surface of the membrane was rougher than before. NF performance results verified that the flux of the composite membrane was from 45 to 70 L·m-2·h-1, whereas separation performance was improved. Under optimized conditions, the prepared modified composite NF membrane showed that its retentions of Na2SO4, MgSO4, MgCl2 and NaCl were 99.4%, 98.5%, 85.4% and 59.2%, respectively.Water permeation and separation performance of this NF membrane were improved after addition of PANI into composite membrane.

Key words: polyaniline, piperazine, NF membrane, interfacial polymerization, roughness

中图分类号: