CIESC Journal ›› 2014, Vol. 65 ›› Issue (z2): 83-87.DOI: 10.3969/j.issn.0438-1157.2014.z2.013

Previous Articles     Next Articles

Heat transfer performance test and analysis of thermosyphon heat exchanger

ZHANG Shuang1, MA Guoyuan1, ZHANG Sichao1, ZHOU Feng1,2   

  1. 1. College of Environmental and Energy Engineering, Beijing University of Technology, Beijing 100124, China;
    2. Beijing Intelligence Source Technology Co. Ltd, Beijing 100124, China
  • Received:2014-08-26 Revised:2014-09-05 Online:2014-12-30 Published:2014-12-30
  • Supported by:

    supported by the National Natural Science Foundation of China (51376010).

热虹吸管换热器的换热性能测试与分析

张双1, 马国远1, 张思朝1, 周峰1,2   

  1. 1. 北京工业大学环境与能源工程学院, 北京 100124;
    2. 北京工大智源科技发展有限公司, 北京 100124
  • 通讯作者: 马国远
  • 基金资助:

    国家自然科学基金项目(51376010)。

Abstract:

A calculation method of an air-to-air thermosyphon heat exchanger was reported in this paper. The face velocity, number of rows and inclination angle of heat exchanger were tested and studied in an air enthalpy type psychrometric calorimeter including indoor and outdoor chambers. The error of the calculation method and experimental data was within 15%. Thus, the calculation method can be applied in engineering design of the air-to-air thermosyphon heat exchanger.

Key words: thermosyphon heat exchanger, heat recovery, effectiveness of heat exchanger, heat pipe, face velocity

摘要:

为探讨空气-空气整体式热虹吸管换热器的换热性能,利用换热器效能计算公式对其进行计算,并在焓差试验室对空气-空气整体式热虹吸管换热器的迎面风速和换热器管排数进行了测试和研究。结果表明,换热器的计算方法与试验数据最大误差在15%以内,且最大误差出现在温度效率较高时。因此,计算方法适用于工程设计计算。

关键词: 热虹吸管换热器, 热回收, 换热器效率, 热管, 迎面风速

CLC Number: