CIESC Journal ›› 2018, Vol. 69 ›› Issue (S2): 500-504.DOI: 10.11949/j.issn.0438-1157.20181113

Previous Articles     Next Articles

Simulation analysis of influence of thermal insulation material breakage on boil-off rate for B type LNG carrier

FU Yunzhun1, LI Pengkui1, JU Yonglin2   

  1. 1 School of Mechanical Engineering, Shanghai University of Engineering Science, Shanghai 201620, China;
    2 Institute of Refrigeration and Cryogenics, Shanghai Jiao Tong University, Shanghai 200240, China
  • Received:2018-10-08 Revised:2018-10-15 Online:2018-12-31 Published:2018-12-31
  • Supported by:

    supported by the Ministry of Industry and Information Technology (Ministry of Industry and Information Department [2012] 534) .

LNG船B型液货舱绝热材料破损对蒸发率的影响模拟分析

傅允准1, 李鹏魁1, 巨永林2   

  1. 1 上海工程技术大学机械工程学院, 上海 201620;
    2 上海交通大学制冷与低温工程研究所, 上海 200240
  • 基金资助:

    工业和信息化部高技术船舶科研项目(工信部联装[2012]534号)。

Abstract:

Based on the analyses of the containment system of a new independent type B liquefied natural gas (LNG) carrier, the distribution of temperature field and heat transfer calculation were analyzed in different kinds of conditions using the method of computational fluid dynamics (CFD) numerical simulation. In addition, the boil-off rate under different conditions was calculated. The results show that the evaporation rate of the LNG carrier is increased by 12% compared with that of the intact insulation layer, when the thickness of the insulating layer was 400 mm, the air temperature was 5℃ and the insulation layer is damaged by 1 m2. The thermal insulation capacity of insulation materials and the insulation layer damage had great influence on the heat transfer and evaporation rate of LNG cargo hold.

摘要:

以B型液化天然气(LNG)船为对象,通过计算流体力学(CFD)数值模拟方法,分析了不同工况下LNG液货舱的温度场分布以及传热量情况,同时计算了各工况的蒸发率。研究结果表明,在绝热层厚度400 mm、空气温度5℃时,绝热层破损1 m2和绝热层完好的情况相比,其蒸发率增加12%;绝热材料保温能力衰减和保温层破损对LNG液货舱传热量和蒸发率影响较大。

CLC Number: