组合式相变材料最佳相变温度的热力学分析

doi:10.3969/j.issn.0438-1157.2013.07.003

化工学报 ›› 2013, Vol. 64 ›› Issue (7): 2322-2327.DOI: 10.3969/j.issn.0438-1157.2013.07.003

组合式相变材料最佳相变温度的热力学分析

胡芃, 卢大杰, 赵盼盼, 陈则韶

中国科学技术大学热科学和能源工程系, 安徽合肥 230027

收稿日期:2012-11-25 修回日期:2013-01-03 出版日期:2013-07-05 发布日期:2013-07-05
通讯作者: 胡芃
作者简介:胡芃(1974- ),男,博士,副教授。
基金资助:
国家重点基础研究发展计划项目(2010CB227305)。

Thermodynamic analysis on optimum phase change temperature for multiple phase change materials

HU Peng, LU Dajie, ZHAO Panpan, CHEN Zeshao

Department of Thermal Science and Energy Engineering, University of Science and Technology of China, Hefei 230027, Anhui, China

Received:2012-11-25 Revised:2013-01-03 Online:2013-07-05 Published:2013-07-05
Supported by:
supported by the National Basic Research Program of China (2010CB227305).

摘要/Abstract

摘要： 采用组合式相变材料的蓄热系统较单一相变材料具有更为优越的传热和热力学性能,而相变温度对于蓄热系统性能具有重要的影响。为了使结果更具普适性,以热力学有效能分析为基础并忽略具体换热器形式和传热过程,推导了使用不同相变材料数时每种相变材料最佳相变温度的理论公式,并根据最佳相变温度计算了有效能利用率随着相变材料数的变化,结果表明当PCMs数增加到4种时,理论最大有效能利用率已达80%以上,比使用单一相变材料的理论最大有效能利用率高50%左右。以573.15 K热能蓄能为例,计算了使用1~4种相变材料时相应的最佳相变温度与最大有效能利用率,并以此为依据给出了实际最佳相变材料组合。

关键词: 组合式相变材料, 蓄能, 最佳相变温度, 有效能

Abstract: A thermal storage system using multiple phase change materials (PCMs)has much better heat transfer and thermodynamic properties than that using single PCM.The phase change temperatures of multiple PCMs have an important effect on the performance of the thermal storage system.To obtain generalized results,the analysis method for thermodynamic exergy is employed,with the type of heat exchanger and heat transfer process neglected.The theoretical equation for the optimum phase change temperature of each PCM is derived.The optimum exergy efficiency is calculated for different number of PCMs.The results indicate that the exergy efficiency could be up to 80% with 4 or more PCMs,which is about 50% higher than that using single PCM.With thermal energy at 573.15 K as example,the optimum temperatures and the maximum exergy efficiencies for one to four PCMs are calculated,and the optimum combination of multiple PCMs is given on the basis of theoretical results.

Key words: multiple phase change material, thermal storage, optimum phase change temperature, exergy

中图分类号:

TK512

胡芃, 卢大杰, 赵盼盼, 陈则韶. 组合式相变材料最佳相变温度的热力学分析[J]. 化工学报, 2013, 64(7): 2322-2327.

HU Peng, LU Dajie, ZHAO Panpan, CHEN Zeshao. Thermodynamic analysis on optimum phase change temperature for multiple phase change materials[J]. CIESC Journal, 2013, 64(7): 2322-2327.

参考文献 22

[1]	Farid M M,Kanzawa A.Thermal performance of a heat storage module using PCMs with different melting temperatures:mathematical modeling[J].ASME Journal of Solar Energy Engineering,1989,111:152-157
[2]	Farid M M,Kim Y,Kanzawa A.Thermal performance of a heat storage module using PCMs with different melting temperatures:experimental[J].ASME Journal of Energy Resources Technology,1990,112:125-131
[3]	Adebiyi G A,Hodge B K,Steele W G,Jalalzadeh-Aza A,Nsofor E C.Computer simulation of a high-temperature thermal energy storage system employing multiple families of phase-change storage materials[J].ASME Journal of Energy Resources Technology,1996,118:102-111
[4]	Watanabe T,Kikuchi H,Kanzawa A.Enhancement of charging and discharging rates in latent heat storage system by use of PCM with different melting temperature[J].Heat Recovery Systems & CHP,1993,13(1):57-66
[5]	Watanabe T,Kanzawa A.Second law optimization of a latent heat storage system with PCMs having different melting points[J].Heat Recovery Systems & CHP,1995,15(7):641-653
[6]	Gong Z X,Mujumdar A S.Enhancement of energy charge-discharge rates in composite slabs of different phase change materials[J].International Journal of Heat and Mass Transfer,1996,39(4):725-733
[7]	Wang Jianfeng (王剑锋),Lu Guoqiang (陆国强),Chen Guangming (陈光明).Performance study on TES systems with composite PCMs[J].New Energy Sources(新能源),1997,19(4):7-11
[8]	Wang Jianfeng (王剑锋),Zheng Fei (郑飞),Chen Guangming (陈光明).Study on PCT distribution in thermal energy storage systems using composite phase change materials[J].Acta Energiae Solaris Sinica(太阳能学报),1998,19(3):294-298
[9]	Wang Jianfeng(王剑锋),Chen Guangming (陈光明),Chen Guobang (陈国邦),Ouyang Yingxiu (欧阳应秀).Study on charging and discharging rates of latent heat thermal energy storage systems employing multiple phase change materials[J].Acta Energiae Solaris Sinica (太阳能学报),2000,21(3):258-264
[10]	Wang Jianfeng (王剑锋).Review of latent thermal energy storage (b)LTES with multiple PCMs and potential applications[J].New Energy Sources (新能源),2000,22(4):22-33
[11]	Wang Jianfeng,Chen Guangming,Jiang Haobo. Theoretical study on a novel phase change process[J].International Journal of Energy Research,1999,23:287-294
[12]	Yang Lei (杨磊),Zhang Xiaosong (张小松).Charge performance of packed bed thermal storage unit with phase change material having different melting points[J].CIESC Journal(化工学报),2012,63(4):1032-1037
[13]	Aceves S M,Nkamura H,Reistad G M,Martinez-Frias J.Optimization of a class of latent thermal energy storage systems with multiple phase change materials[J].Journal of Solar Energy Engineering:Transactions of the ASME,1998,112(1):14-19
[14]	Fang Ming (方铭),Chen Guangming (陈光明).Influence of mass fraction of multiple phase change materials on the performance of a latent thermal energy storage system[J].Acta Energiae Solaris Sinica (太阳能学报),2007,28(3):304-308
[15]	Fang Ming,Chen Guangming.Effects of different multiple PCMs on the performance of a latent thermal energy storage system[J].Applied Thermal Engineering,2007,27:994-1000
[16]	Kenisarin M M.High-temperature phase change materials for thermal energy storage[J].Renewable and Sustainable Energy Reviews,2010,14:955-970
[17]	Zhang Yinping (张寅平),Hu Hanping (胡汉平),Kong Xiangdong (孔祥冬),Su Yuehong (苏跃红).Phase Change Thermal Storage:Theory and Application(相变贮能理论和应用)[M].Hefei:Press of University of Science and Technology of China,1996:25
[18]	Sharma A,Tyagi V V,Chen C R,Buddhi D.Review on thermal energy storage with phase change materials and application[J].Renewable and Sustainable Energy Reviews,2009,13:318-345
[19]	Zalba B,Marin J M,Cabeza L F,Mehling H.Review on thermal energy storage with phase change:materials,heat transfer analysis and applications[J].Applied Thermal Engineering,2003,23:251-283
[20]	Sharma S D,Sagara K.Latent heat storage materials and systems:a review[J].International Journal of Green Energy,2005,2:1-56
[21]	Nomura T,Okinaka N,Akiyama T.Technology of latent heat storage for high temperature application:a review[J].ISIJ International,2010,50(9):1229-1239
[22]	Farid M M,Khudhair A M,Razack S A K,Al-Hallaj S.A review on phase change energy storage materials and applications[J].Energy Conversion and Management,2004,45:1597-1615

组合式相变材料最佳相变温度的热力学分析

Thermodynamic analysis on optimum phase change temperature for multiple phase change materials

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 22

相关文章 13

编辑推荐

Metrics

本文评价

[1]	常明慧, 王林, 苑佳佳, 曹艺飞. 盐溶液蓄能型热泵循环特性研究[J]. 化工学报, 2023, 74(S1): 329-337.
[2]	孙苏芮, 王德昌, 张金翠, 刘振, 李延辉. 膜蓄能器放能过程的传热传质特性分析[J]. 化工学报, 2020, 71(S1): 158-165.
[3]	金靓婕, 白鹏, 郭翔海. 带有侧线采出回流的部分透热精馏的节能优化[J]. 化工学报, 2019, 70(5): 1804-1814.
[4]	郑春元, 翟晓强, 吴静怡, 杨干. 基于TRNSYS的冷热电联供系统建模与蓄能策略分析[J]. 化工学报, 2015, 66(S2): 311-317.
[5]	张少鹏, 韩瑞萍, 陈晶晶, 周俊, 陆小华, 王昌松. 沼气工程罐内盘管加热传热速率与效率分析[J]. 化工学报, 2015, 66(11): 4304-4311.
[6]	夏燚, 姚文超, 张小松, 张如意. 双层相变蓄能地板供冷暖末端设计与模拟[J]. 化工学报, 2014, 65(z2): 240-247.
[7]	张晓灵, 石文星, 王宝龙, 李先庭. 基于增压吸收的吸收式蓄能装置的性能分析[J]. 化工学报, 2014, 65(6): 2241-2248.
[8]	董英, 周孑民, 杨晓力, 彭伟. 呼吸蓄能式玻璃幕墙的研究与设计[J]. 化工学报, 2013, 64(6): 2015-2021.
[9]	王春燕，邵方元，朱新，张彩珠，魏顺安. 混合制冷剂液化天然气过程的有效能分析[J]. 化工进展, 2013, 32(11): 2604-2608.
[10]	张彩珠，王春燕，陈珊，魏顺安 . 亚临界燃煤电厂的用能分析[J]. 化工进展, 2013, 32(06): 1278-1282.
[11]	林曦，刘振宇. 天然气水合物的有效能量及CO2排放强度分析 [J]. CIESC Journal, 2010, 29(12): 2265-.
[12]	肖睿, 何世辉, 黄冲, 冯自平, 樊栓狮. 四丁基溴化铵包络化合物浆在铜管内的对流传热特性 [J]. 化工学报, 2007, 58(9): 2205-2210.
[13]	陈敬良;田怀璋;陈林辉. 固液相变数学模型中有效热导率 [J]. CIESC Journal, 2004, 55(7): 1072-1076.