化工学报 ›› 2016, Vol. 67 ›› Issue (S2): 20-25.DOI: 10.11949/j.issn.0438-1157.20161347

• 热力学 • 上一篇    下一篇

液氢贮箱热力学排气系统建模及控压特性

汪彬1,2, 王天祥1, 黄永华2, 吴静怡2, 雷刚1   

  1. 1. 航天低温推进剂技术国家重点实验室, 北京 100028;
    2. 上海交通大学制冷与低温工程研究所, 上海 200240
  • 收稿日期:2016-06-17 修回日期:2016-09-26 出版日期:2016-12-30 发布日期:2016-12-30
  • 通讯作者: 黄永华
  • 基金资助:

    航天低温推进剂技术重点实验室基金课题项目(SKLTSCP1206-W);国家自然科学基金项目(51676118)。

Modeling and pressure control characteristics of thermodynamic venting system in liquid hydrogen storage tank

WANG Bin1,2, WANG Tianxiang1, HUANG Yonghua2, WU Jingyi2, LEI Gang1   

  1. 1. State Key Laboratory of Technologies in Space Cryogenic Propellants, Beijing 100028, China;
    2. Institute of Refrigeration and Cryogenics, Shanghai Jiao Tong University, Shanghai 200240, China
  • Received:2016-06-17 Revised:2016-09-26 Online:2016-12-30 Published:2016-12-30
  • Supported by:

    supported by the Open Research Fund of the State Key Laboratory of Technologies in Space Cryogenic Propellants (SKLTSCP1206-W) and the National Natural Science Foundation of China (51676118).

摘要:

以低温推进剂液氢贮箱压力控制为目标,建立了热力学排气系统(TVS)和贮箱内流体流动及气液相变过程的数学模型。以18.09 m3液氢贮箱在地面工况充注率75%、漏热量0.76 W·m-2为例,计算了贮箱自增压过程及开启TVS后对贮箱压力控制的效果。结果表明,气枕升压速率远大于液体温度对应的饱和压力的升压速率;TVS运行后可将贮箱压力有效地控制在165.5~172.4 kPa范围内。对比了混合与排气两种不同运行模式下贮箱气枕的升降压特性,发现排气模式下的气枕降压速率为混合模式的7倍,升压速率为混合模式的95%。同时还分析了贮箱内液体的温度变化规律。

关键词: 液氢贮箱, 热力学排气系统, 压力控制, 仿真分析

Abstract:

To study the pressure control of cryogenic propellant container, an analytical lumped parameter model is established to predict the behavior of pressure variation inside a liquid hydrogen tank with TVS installed.Simulations are conducted for the tank with volume of 18.09 m3 initially filled with 75% LH2 and with a heat leak load of 0.76 W·m-2.Calculation results are compared with literature to verify the feasibility of the proposed model.The results show that the ullage pressure rises much faster than the liquid saturation pressure, and TVS is highly effective and feasible in controlling the tank pressure within 165.5-172.4 kPa.The pressure change characteristics under mixing mode and venting mode are compared and analyzed.The pressure decreasing rate under venting mode is found to be 7 times of that under mixing mode.However, the pressure rising rate under venting mode is about 95% of that under mixing mode.The temperature profiles are also studied.

Key words: liquid hydrogen tank, thermodynamic vent system, pressure control, simulation analysis

中图分类号: