不同增压方式对空气源吸收式热泵性能影响的模拟分析

doi:10.3969/j.issn.0438-1157.2013.07.008

化工学报 ›› 2013, Vol. 64 ›› Issue (7): 2360-2368.DOI: 10.3969/j.issn.0438-1157.2013.07.008

不同增压方式对空气源吸收式热泵性能影响的模拟分析

吴伟, 石文星, 王宝龙, 李先庭

清华大学建筑学院建筑技术科学系, 北京 100084

收稿日期:2012-11-29 修回日期:2013-03-30 出版日期:2013-07-05 发布日期:2013-07-05
通讯作者: 李先庭
作者简介:吴伟(1988- ),男,博士研究生。
基金资助:
国家杰出青年基金项目(51125030);国家重点基础研究发展计划项目(2010CB227305)。

Simulation on performance of air source absorption heat pumps with different compression-assisted approaches

WU Wei, SHI Wenxing, WANG Baolong, LI Xianting

Department of Building Science, School of Architecture, Tsinghua University, Beijing 100084, China

Received:2012-11-29 Revised:2013-03-30 Online:2013-07-05 Published:2013-07-05
Supported by:
supported by the National Basic Research Program of China(2010CB227305).

摘要/Abstract

摘要： 我国建筑采暖和生活热水能耗较大,基于空气源吸收式热泵的供热系统是北方寒冷地区具有较大节能潜力的解决方案。由于单效空气源吸收式热泵无法运行在气温较低的环境下,提出采用增压循环来提高空气源吸收式热泵的低温性能,并根据增压方式的不同分为低压增压和高压增压两种形式。以NH₃-LiNO₃作为工质对,对不同形式空气源吸收式热泵进行了对比分析。结果表明:两种增压方式均能有效提高吸收式热泵的低温性能,在不同的室外气温、热源温度和热水温度下,能够实现20%~45%的节能率;此外,低压增压的一次能源效率比高压增压更高。综合节能性和实现难易程度,低压增压是提高空气源吸收式热泵低温性能的较好手段。

关键词: 空气源吸收式热泵, 增压吸收, 氨-硝酸锂, 寒冷地区, 供热

Abstract: The energy consumption of heating and domestic hot water in China is very large.The heat supply system based on air source absorption heat pump (ASAHP)is a promising alternative solution in cold regions.However,the single-stage ASAHP cannot operate normally under very cold weathers. Compression-assisted absorption cycles,including high-pressure boosting and low-pressure boosting in terms of the position of the pressurizer in the cycle,are proposed to improve the performance of ASAHP under low ambient temperatures.Different kinds of compression-assisted ASAHP using NH₃-LiNO₃ as working fluid have been comparatively simulated and analyzed.The results indicate that both high-pressure and low-pressure boosting can effectively improve the performance of ASAHP in cold conditions.Energy saving rates as high as 20%—45% can be obtained with different outdoor temperatures,driving source temperatures and hot water temperatures.Besides,low-pressure boosting ASAHP can achieve a higher primary energy efficiency than high-pressure boosting cycle in the same condition.Taken energy efficiency as well as difficulty of realization together,it can be concluded that the low-pressure boosting is a better choice for the improvement of ASAHP in cold regions.

Key words: air source absorption heat pump, compression-assisted absorption, ammonia-lithium nitrate, cold region, heating

中图分类号:

吴伟, 石文星, 王宝龙, 李先庭. 不同增压方式对空气源吸收式热泵性能影响的模拟分析[J]. 化工学报, 2013, 64(7): 2360-2368.

WU Wei, SHI Wenxing, WANG Baolong, LI Xianting. Simulation on performance of air source absorption heat pumps with different compression-assisted approaches[J]. CIESC Journal, 2013, 64(7): 2360-2368.

参考文献 20

[1]	Tsinghua University Building Energy Saving Research Center(清华大学建筑节能研究中心).2011 Annual Report on China Building Energy Efficiency[M].Beijing:China Architecture and Building Press,2011
[2]	Li X T,Shi W X,Dong L Y,Zhang X L,Wu W,Li X. Heat multiple heat exchanger unit[P]:CN,201029166006.0.2010-11-10
[3]	Wu W,Zhang X L,Li X T,Shi W X,Wang B L.Exergy analysis of air source absorption heat pump used for heating and domestic hot water//The 6th Asian Conference on Refrigeration and Air Conditioning[C].Xi'an,China,2012
[4]	Li X T,Wu W,Zhang X L,Shi W X,Wang B L.Energy saving potential of low temperature hot water system based on air source absorption heat pump[J].App. Therm. Eng.,2012,48:317-324
[5]	Wu W,Zhang X L,Li X T,Shi W X,Wang B L. Comparisons of different working pairs and cycles on the performance of absorption heat pump for heating and domestic hot water in cold regions[J].Appl. Therm. Eng.,2012,48:349-358
[6]	Xie Guozhen(解国珍),Fa Xiaoming (法晓明).A novel lithium bromide absorption chiller with enhanced absorption pressure[J].CIESC Journal(化工学报),2010,61(S2):164-167
[7]	Herold K E,Radermacher R,Klein S A.Absorption Chillers and Heat Pumps[M].Florida:CRC Press,1996
[8]	Karamangil M I,Coskun S,Kaynakli O,Yamankaradeniz N.A simulation study of performance evaluation of single-stage absorption refrigeration system using conventional working fluids and alternatives[J].Renew. Sust. Energ.Rev.,2010,14 (7):1969-1978
[9]	Wu W,Zhang X L,You T,Li X T,Shi W X,Wang B L.Analysis on heating performance of ground source absorption heat pump system with direct cooling in summer//The Second International Conference on Building Energy and Environment[C].Colorado,USA,2012
[10]	Wu Wei (吴伟),Zhang Xiaoling (张晓灵),Shi Wenxing (石文星),Li Xianting (李先庭).Design and analysis of ammonia-water air source absorption heat pump//The 10th Academic Conference Proceedings of Beijing Association of Refrigeration[C].Beijing,China,2010
[11]	Srikhirin P,Aphornratana S,Chungpaibulpatana S.A review of absorption refrigeration technologies[J].Renew. Sust. Energ.Rev.,2001,5(4):343-372
[12]	Sun D W.Comparison of the performances of NH3-H2O,NH3-LiNO3 and NH3-NaSCN absorption refrigeration systems[J].Energ.Convers.Manage.,1998,39(5/6):357-368
[13]	Karamangil M I,Coskun S,Kaynakli O,Yamankaradeniz N.A simulation study of performance evaluation of single-stage absorption refrigeration system using conventional working fluids and alternatives[J].Renew. Sust. Energ.Rev.,2010,14(7):1969-1978
[14]	Xie G Z,Wu Q P,Fa X M,Zhang L R,Bansal P.A novel lithium bromide absorption chiller with enhanced absorption pressure[J].Appl.Therm.Eng.,2012,38:1-6
[15]	Jelinek M,Levy A,Borde I.Performance of a triple-pressure level absorption/compression cycle[J].Appl. Therm. Eng.,2012,42:2-5
[16]	Kim J S,Ziegler F,Lee H.Simulation of the compressor-assisted triple-effect H2O/LiBr absorption cooling cycles[J].Appl.Therm.Eng.,2002,22:295-308
[17]	Ventas R,Vereda C,Lecuona A,Venegas M. Experimental study of a thermochemical compressor for an absorption/compression hybrid cycle[J].Appl. Energy,2012,97:297-304
[18]	Ventas R,Lecuona A,Zacarías A,Venegas M.Ammonia-lithium nitrate absorption chiller with an integrated low-pressure compression booster cycle for low driving temperatures[J].Appl.Therm.Eng.,2010,30:1351-1359
[19]	Yan Q S,Shi W X,Tian C Q.Refrigeration Technology for Air Conditioning[M].4th ed.Beijing:China Architecture and Building Press,2010
[20]	Infante Ferreira C A.Thermodynamic and physical property data equations for ammonia-lithium nitrate and ammonia-sodium thiocyanate solutions[J].Sol.Energy,1984,32 (2):231-236

不同增压方式对空气源吸收式热泵性能影响的模拟分析

Simulation on performance of air source absorption heat pumps with different compression-assisted approaches

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 20

相关文章 8

编辑推荐

Metrics

本文评价

[1]	晁京伟, 许嘉兴, 李廷贤. 基于无管束蒸发换热强化策略的吸附热池的供热性能研究[J]. 化工学报, 2023, 74(S1): 302-310.
[2]	王刚, 赵琰. 土壤源热泵供暖间歇运行时间的计算分析[J]. 化工学报, 2020, 71(S1): 430-435.
[3]	周鹏飞, 张振涛, 章学来, 杨鲁伟, 魏娟, 刘鹏鹏. 热泵干燥过程中低温热泵补热的应用分析[J]. 化工学报, 2018, 69(5): 2032-2039.
[4]	李玮, 刘芳, 陈宝明, 魏茂丰, 郜凯凯, 耿文广. 寒冷地区湿传递对多层墙体热湿性能的影响[J]. 化工学报, 2017, 68(S1): 162-168.
[5]	徐翔, 王远超, 张博. 基于喷射式热泵的热电联产供热系统[J]. 化工学报, 2014, 65(3): 1025-1032.
[6]	梁彩华, 文先太, 张小松. 基于热源塔的热泵系统构建与试验 [J]. 化工学报, 2010, 61(S2): 142-146.
[7]	王中贤, 张红, 陈兴元, 庄骏. 热管式生物质气化炉的模拟 [J]. 化工学报, 2008, 59(2): 316-321.
[8]	杜小泽, 吴少融. 核供热堆海水淡化系统的变工况运行特性 [J]. 化工学报, 2003, 54(3): 362-367.