添加不同纳米颗粒的导热油直接吸收集热实验性能

doi:10.3969/j.issn.0438-1157.2014.z2.043

化工学报 ›› 2014, Vol. 65 ›› Issue (z2): 293-298.DOI: 10.3969/j.issn.0438-1157.2014.z2.043

• 材料化学工程与纳米技术 • 上一篇下一篇

添加不同纳米颗粒的导热油直接吸收集热实验性能

徐国英¹, 李凌志¹, 张小松¹, 孙岳明²

1. 东南大学能源与环境学院, 江苏南京 210096;
2. 东南大学化学与化工学院, 江苏南京 210096

收稿日期:2014-08-22 修回日期:2014-09-01 出版日期:2014-12-30 发布日期:2014-12-30
通讯作者: 徐国英
基金资助:
国家自然科学基金项目(51206027);江苏省自然科学基金青年基金(BK2012339)。

Experimental performance of direct absorption collector using heat-transfer oil added with different nanoparticles

XU Guoying¹, LI Lingzhi¹, ZHANG Xiaosong¹, SUN Yueming²

1. School of Energy and Environment, Southeast University, Nanjing 210096, Jiangsu, China;
2. School of Chemistry and Chemical Engineering, Southeast University, Nanjing 210096, Jiangsu, China

Received:2014-08-22 Revised:2014-09-01 Online:2014-12-30 Published:2014-12-30
Supported by:
supported by the National Natural Science Foundation of China (51206027) and the Natural Science Foundation of Jiangsu Province (BK2012339).

摘要/Abstract

摘要：

提出并探讨了采用导热油基液纳米流体为集热介质的太阳能直接吸收式集热方法。分别对添加纳米CuO、Fe₃O₄、石墨颗粒的导热油基液纳米流体进行了闷晒实验研究。结果显示:添加上述纳米颗粒均可显著提高导热油对太阳辐射的吸收;80℃以内工况下,纳米流体的直接吸收集热效率要高于传统镀膜真空管内导热油间接吸收的集热效率;但在更高温度工况下的对外散热损失增大,效率迅速下降。同时,实验对比分析了纳米颗粒的添加质量分数对导热油-CuO纳米流体集热效率、散热损失系数等性能参数的影响规律,得出了最佳纳米颗粒添加比例范围。

关键词: 太阳能集热, 纳米流体, 导热油, 集热效率

Abstract:

A kind of direct solar heat collection system, in which heat-transfer oil added with nanoparticles as the absorbing medium in vacuum tube without coating was proposed. Different kind of oil based nanofluids respectively added with CuO、Fe₃O₄ and graphite nanoparticles for solar heat collection were experimentally investigated. Results show that a greatly enhancement achieved in the solar radiation absorption capacity when add nanoparticles into the heat-transfer oil. Within 80℃, direct absorption collecting efficiency using nanofluids is higher than that of using traditional film coating vacuum tube solar collector, while the heat loss increased rapidly on a higher temperature condition. Furthermore, efficiencies of oil-based CuO nanofluids with different mass fractions were also comparatively analyzed, and the optimum added mass fraction was obtained.

Key words: solar collection, nanofluids, heat-transfer oil, collection efficiency

中图分类号:

TK512

徐国英, 李凌志, 张小松, 孙岳明. 添加不同纳米颗粒的导热油直接吸收集热实验性能[J]. 化工学报, 2014, 65(z2): 293-298.

XU Guoying, LI Lingzhi, ZHANG Xiaosong, SUN Yueming. Experimental performance of direct absorption collector using heat-transfer oil added with different nanoparticles[J]. CIESC Journal, 2014, 65(z2): 293-298.

参考文献 12

[1]	Das S K, Choi U S, Patel H E. Heat transfer in nanofluids—a review[J]. Heat Transfer Engineering, 2006, 27(10): 3-19
[2]	Xuan Yimin(宣益民), Li Qiang(李强). Investigation on enhanced heat transfer of nanofluids[J]. Journal of Engineering Thermophysics(工程热物理学报), 2002, 23(6): 721-723
[3]	Cheng Bo(程波), Du Kai(杜垲), Zhang Xiaosong(张小松). Influence of stability of carbon black nano-particle suspension of ammonia solution[J]. Journal of Chemical Industry and Engineering(China)(化工学报), 2008, 59(S2): 49-52
[4]	Zhang Q C, Yin Y, Mills D R. High efficiency Mo-A12O3 cermet selective surface for high-temperature application[J]. Solar Energy Materials and Solar Ceils, 1996, 40(1): 43-53
[5]	Yǖncǖ H, Paykoc E,Yener Y. Solar Energy Utilization [M]. Boston:Kluwer Academic, 1987
[6]	Tyagi H, Phelan P, Prasher R. Predicted efficiency of a low temperature nanofluid based direct absorption solar collector[J]. Journal of Solar Energy Engineering, 2009, 131: 4-10
[7]	Otanicar T P, Phelan P E, Prasher R S,et al. Nanofluid-based absorption solar collector[J]. Renewable Sustainable Energy, 2010, 2(3):102-115
[8]	Mao Lingbo(毛凌波), Zhang Renyuan(张仁元), Ke Xiufang(柯秀芳), Liu Zongjian(刘宗建).Photo-thermal properties of nanofluid-based solar collector[J]. Acta Energiae Solaris Sinica(太阳能学报),2009, 30(12): 1647-1652
[9]	Zhao Jiafei(赵佳飞). Study of nanofluids' radiation properties and its utilization in photovoltaic/thermal system[D]. Hangzhou:Zhejiang University, 2009
[10]	Otanicar T P, Phelan P E, Golden J S. Optical properties of liquids for direct absorption solar thermal energy systems[J]. Solar Energy, 2009, 83(7): 969-977
[11]	Wang Zemin(王泽敏),Study on the absorption spectrum of γ-Fe2O3 nanoparicle[J]. Journal of Functional Materials(功能材料),2006,37(2): 284-300
[12]	Li Lingzhi(李凌志). Stability and direct solar radiation absorption collection of heat-transfer oil-based nanofluid[D]. Nanjing: Southeast University, 2014

[1]	赵佳佳, 田世祥, 李鹏, 谢洪高. SiO₂-H₂O纳米流体强化煤尘润湿性的微观机理研究[J]. 化工学报, 2023, 74(9): 3931-3945.
[2]	齐聪, 李可傲, 李春阳. 微肋结构对纳米流体绕流圆柱热性能的影响[J]. 化工学报, 2021, 72(4): 2006-2017.
[3]	刘昌会, 刘红莉, 张天键, 饶中浩. 基于尿素/氯化胆碱低共熔溶剂体系纳米流体制备及其热物性研究[J]. 化工学报, 2021, 72(3): 1333-1341.
[4]	刘昌会,张海悦,李业美,张天键,顾彦龙. 低共熔溶剂在储能与传热方面的研究进展[J]. 化工学报, 2021, 72(10): 4973-4986.
[5]	李富恒. 石墨烯纳米片-乙二醇纳米流体光热转化特性研究[J]. 化工学报, 2020, 71(S1): 479-485.
[6]	田东民, 吴延鹏, 陈凤君. 基于纳米增强相变材料的铜-水热管传热性能分析[J]. 化工学报, 2020, 71(S1): 220-226.
[7]	郎中敏, 吴刚强, 赫文秀, 韩晓星, 苟延梦, 李双莹. 二氧化铈/水基纳米流体核沸腾传热特性[J]. 化工学报, 2020, 71(5): 2061-2068.
[8]	赵佳腾,王增鹏,戴宇成,刘昌会,饶中浩. 两亲性纳米流体太阳能重力热管传热性能研究[J]. 化工学报, 2020, 71(12): 5461-5469.
[9]	陈巨辉, 韩坤, 王帅, 李铭坤, 陈纪元, 马明. 基于反扰动非平衡分子动力学的纳米流体导热增强机理研究[J]. 化工学报, 2019, 70(6): 2147-2152.
[10]	闫鑫, 徐进良. 超疏水表面太阳能加热金-水纳米流体液滴蒸发特性[J]. 化工学报, 2019, 70(3): 892-900.
[11]	金铭, 胡定华, 李强, 范德松. Al₂O₃纳米流体液滴蒸发特性的数值模拟研究[J]. 化工学报, 2019, 70(11): 4199-4206.
[12]	王佳骏, 郎中敏, 于戈文, 吴刚强. CuO/H₂O纳米流体的池沸腾传热及预测[J]. 化工学报, 2018, 69(7): 2944-2955.
[13]	刘珍, 张忠强. 石墨烯纳米通道中富勒烯纳米流体的压力驱动流动特性[J]. 化工学报, 2018, 69(5): 1892-1899.
[14]	李阳, 杜乐, 高若梅, 吴偲, 龚亚辉. 微通道中原位分散技术可控制备氧化铜纳米流体及复合薄膜前体[J]. 化工学报, 2018, 69(11): 4918-4928.
[15]	熊亚选, 王振宇, 徐鹏, 吴玉庭, 丁玉龙, 马重芳. 添加纳米SiO₂对单组分及二元硝酸盐热物性的影响[J]. 化工学报, 2018, 69(10): 4418-4426.

添加不同纳米颗粒的导热油直接吸收集热实验性能

Experimental performance of direct absorption collector using heat-transfer oil added with different nanoparticles

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 12

相关文章 15

编辑推荐

Metrics

本文评价