Prediction of two-phase pressure drop under different operating parameters for once-through steam generator

doi:10.11949/j.issn.0438-1157.20170213

Abstract

Abstract:

The once-through steam generator which was designed by B & W company was simplified. The flow and heat transfer process in the secondary side under different conditions for the once-through steam generator was numerically simulated based on constant heat flux,and the numerical results were compared with the classic correlations of frictional pressure drop. The results show that Martinelli-Nelson correlation can be used to predict the two-phase frictional pressure drop along with the occurrence of dryout. The frictional pressure drop increases with the increasing steam quality,and the frictional pressure drop gradient obviously increases when the dryout happens. The two-phase frictional pressure drop within the tube increases with the increasing mass flow rate and heat flux,while decreases with the rising operating pressure. The effect of mass flow rate and operating pressure on friction pressure drop is obvious,while the heat flux has little effect on the friction pressure drop.

Key words: steam generator, pressure drop, two-phase flow, dryout, heat transfer, phase change

摘要：

将B&W公司的直流蒸汽发生器进行简化，采用常热流边界条件进行不同运行参数下直流蒸汽发生器二次侧流动与换热过程数值模拟，并与经典摩擦压降经验关联式进行对比。结果表明：Martinelli-Nelson关联式更适用于预测蒸干发生时两相流的摩擦压降；摩擦压降随质量含汽率增加整体呈现上升趋势，蒸干发生时摩擦压降的变化率明显增大；管内气液两相流摩擦压降随质量流量和热通量增加而增大，随运行压力增大而减小。其中质量流量、运行压力对摩擦压降的影响较明显，热通量对其影响较小。

关键词: 蒸汽发生器, 压降, 两相流, 蒸干, 传热, 相变

CLC Number:

TL33

WU Wanze, SUN Baozhi, SHI Jianxin, YU Xiang, ZHANG Linlin, DING Hongda. Prediction of two-phase pressure drop under different operating parameters for once-through steam generator[J]. CIESC Journal, 2017, 68(S1): 117-124.

吴宛泽, 孙宝芝, 史建新, 于祥, 张琳琳, 丁宏达. 直管式直流蒸汽发生器不同运行参数下两相流压降预测[J]. 化工学报, 2017, 68(S1): 117-124.

References 29

[1]	刘涛. 直流蒸汽发生器控制系统实验台架设计[D]. 哈尔滨:哈尔滨工程大学,2004. LIU T. Design of experimental platform for DC steam generator control system[D]. Harbin:Harbin Engineering University,2004.
[2]	《蒸汽发生器》编写组. 蒸汽发生器[M]. 北京:原子能出版社,1982:55-60. "Steam Generators" GROUP. Steam Generators[M]. Beijing:Atomic Energy Press,1982:55-60.
[3]	CIONCOLINI A,SANTINI L. Two-phase pressure drop prediction in helically coiled steam generators for nuclear power applications[J]. International Journal of Heat and Mass Transfer,2016,100:825-834.
[4]	LIU W,TAMAI H,TAKASE K. Pressure drop and void fraction in steam-water two-phase flow at high pressure[J]. Journal of Heat Transfer-Transactions of ASME,2013,135:8.
[5]	ZHAO L,GUO L J,BAI B F,et al. Convective boiling heat transfer and two-phase flow characteristics inside a small horizontal helically coiled tubing once-through steam generator[J]. International Journal of Heat and Mass Transfer,2003,46(25):4779-4788.
[6]	HONG W,YAN L,REN J. Investigation on gas-liquid two-phase flow patterns and pressure drop across an in-line tube bundles[J]. Proceedings of the Chinese Society of Electrical Engineering,2011,31(5):84-89.
[7]	俞冀阳,贾宝山. 反应堆热工水力学[M]. 北京:清华大学出版社,2003. YU J Y,JIA B S. Reactor Thermal Hydraulics[M]. Beijing:Tsinghua University Press,2003.
[8]	徐济鋆. 沸腾传热和汽液两相流[M]. 北京:原子能出版社,2001. XUN J Y. Boiling Heat Transfer and Vapor-Liquid Two-phase Flow[M]. Beijing:Atomic Energy Press,2001.
[9]	林瑞泰. 沸腾换热[M]. 北京:科学出版社,1988. LIN R T. Boiling Heat Transfer[M]. Beijing:Science Press,1988.
[10]	阎昌琪. 气液两相流[M]. 哈尔滨:哈尔滨工程大学出版社,2010. YAN C Q. Gas-Liquid Two-phase Flow[M]. Harbin:Harbin Engineering University Press,2010.
[11]	SUN B Z,YANG Y L. Numerically investigating the influence of tube support plates on thermal-hydraulic characteristics in a steam generator[J]. Applied Thermal Engineering,2013,51:611-622.
[12]	WANG K,BAI B,MA W. An improved liquid film model to predict the CHF based on the influence of churn flow[J]. Applied Thermal Engineering,2014,64(1):422-429.
[13]	VINOD V,SIVAKUMAR L S,KUMAR V A,et al. Experimental evaluation of the heat transfer performance of sodium heated once through steam generator[J]. Nuclear Engineering and Design,2014,273:412-420.
[14]	WEI H M,SU G H,TIAN W X,et al. Study on dryout point by wavelet and GNN[J]. Applied Thermal Engineering,2010,30(6):664-672.
[15]	JAYANTI S,VALETTE M. Prediction of dryout and post-dryout heat transfer at high pressures using a one-dimensional three-fluid model[J]. International Journal of Heat and Mass Transfer,2004,47(22):4895-4910.
[16]	LI H,VASQUEZ S A,PUNEKAR H,et al. Prediction of boiling and critical heat flux using an eulerian multiphase boiling model[C]. Colorado:American Society of Mechanical Engineers,2011.
[17]	AZZOPARDI B J. Prediction of dryout and post-burnout heat transfer with axially non-uniform heat input by means of an annular flow model[J]. Nuclear Engineering and Design,1996,163(1):51-57.
[18]	THURGOOD M J,KELLY J M,GUIDOTTI T E,et al. COBRA/TRAC-a Thermal-hydraulics Code for Transient Analysis of Nuclear Reactor Vessels and Primary Coolant Systems[M]. America:The U.S. Nuclear Regulatory Commission,1983:21-38.
[19]	WEISMAN J,PEI B S. Prediction of critical heat flux in flow boiling at low qualities[J]. International Journal of Heat and Mass Transfer,1983,26(10):1463-1477.
[20]	SHI J,SUN B,HAN W,ZHANG G. Numerical simulation of dryout and post-dryout heat transfer in a straight-pipe once-through steam generator[J]. Applied Thermal Engineering,2016,105(1):132-141.
[21]	JALLOUK P A. Two-phase flow pressure drop and heat transfer characteristics of refrigerants in vertical tubes[J]. Nasa Sti/recon Technical Report N,1976:76.
[22]	庞树声,胡修慈. 垂直上升绝热管内汽、液两相流的压降[J]. 化学工程,1990,(6):19-24. PANG S S,HU X C. Pressure drop of vapor-liquid two-phase flow in vertical adiabatic pipe[J]. Chemical Engineering(China),1990,(6):19-24.
[23]	翟建华. 垂直管流中两相流压降计算[J]. 力学与实践,1985,7:32-37. ZHAI J H. Pressure drop calculation of two-phase flow in vertical pipe flow[J]. Mechanics and Practice,1985,7:32-37.
[24]	LOCKHART R W,MARTINELLI R C. Proposed correlation of date for isothermal two-phase,two-component flow in pipes[J]. Chem.Eng.Prog.,1949,45:39-48.
[25]	MARTINELLI R C,NELSON D B. Prediction of Pressure drop during forced circulation boiling of water[J]. Trans. ASME,1948,70:695-702.
[26]	CHISHOLM D. Pressure gradients due to friction during the flow of evaporating two-phase mixtures in smooth tubes and channels[J]. International Journal of Heat and Mass Transfer,1973,16(2):347-358.
[27]	林宗虎,等.气液两相流和沸腾传热[M].西安:西安交通大学出版社,2003:65-106. LIN Z H,et al. Gas-Liquid Two-phase Flow and Boiling Heat Transfer[M].Xi'an:Xi'an Jiaotong University Press,2003:65-106.
[28]	电站锅炉水动力计算方法[M]. 上海:上海发电设备成套设计研究所,1983. Hydrodynamic Calculation Method for Power Plant Boiler[M]. Shanghai:Shanghai Power Equipment Research Institute,1983.
[29]	KONIKOV A S,MODNIKOVA A. Experimental study of the conditions under which heat exchange deteriorates when a steam-water mixture flows in heated tubes[J]. Teploenergetika,1966,10(5):49-52.