化工学报 ›› 2019, Vol. 70 ›› Issue (12): 4556-4564.DOI: 10.11949/0438-1157.20190523

• 流体力学与传递现象 • 上一篇    下一篇

H型翅片管湿烟气对流冷凝传热的数值模拟研究

何洋(),王利民,唐春丽,车得福()   

  1. 西安交通大学能源与动力工程学院,陕西 西安 710049
  • 收稿日期:2019-05-19 修回日期:2019-09-26 出版日期:2019-12-05 发布日期:2019-12-05
  • 通讯作者: 车得福
  • 作者简介:何洋(1994—),男,硕士研究生,1031786287@qq.com

Numerical simulation of convection condensation heat transfer of H-fixed tubes with wet flue gas

Yang HE(),Limin WANG,Chunli TANG,Defu CHE()   

  1. School of Energy and Power Engineering,Xi’an Jiaotong University,Xi’an 710049,Shaanxi, China
  • Received:2019-05-19 Revised:2019-09-26 Online:2019-12-05 Published:2019-12-05
  • Contact: Defu CHE

摘要:

通过数值计算对湿工况下的H型和圆型翅片管换热器通道内充分发展段的对流冷凝传热特性进行模拟研究。计算采用压力与速度耦合的SIMPLER算法,湿烟气流速范围为1~5 m/s,水蒸气质量分数范围为5%~13%。讨论了不同入口速度、水蒸气质量分数对H型翅片管和圆型翅片管传热传质系数、传热量、冷凝水流量和翅片效率的影响,并进行定量比较分析。计算结果表明,H型翅片管的传热能力强于圆型翅片管,但冷凝生成量较圆型翅片管小,同时H型翅片管的总翅片效率和潜热翅片效率小于圆型翅片管。

关键词: 传热传质, 翅片效率, H型翅片, 圆型翅片, 湿工况

Abstract:

The numerical simulation is used to simulate the convective condensation heat transfer characteristics of the fully developed section of the H-type and round fin-tube heat exchanger channels under wet conditions. The SIMPLER algorithm is used to calculate the pressure and velocity coupling. The wet flue gas flow rate ranges from 1 to 5 m/s, and the water vapor mass fraction ranges from 5% to 13%. The effects of different inlet velocity and water vapor mass fraction on heat and mass transfer coefficient, heat transfer, condensate flow rate and fin efficiency of H-shaped finned tube and circular finned tube were discussed. The calculation results show that the heat transfer capacity of H-type finned tube is obviously stronger than that of circular finned tube, but the condensation production is less than that of circular finned tube. Meanwhile, the total finned efficiency and latent heat finned efficiency of H-type finned tube are less than that of circular finned tube.

Key words: heat and mass transfer, fin efficiency, H-type finned tube, round finned tube, dehumidifying conditions

中图分类号: