CIESC Journal ›› 2017, Vol. 68 ›› Issue (7): 2722-2729.DOI: 10.11949/j.issn.0438-1157.20161297

Previous Articles     Next Articles

Experimental analysis on heat storage of pulsating heat pipe phase change heat accumulator

LUO Xiaoxue1,2, ZHANG Xuelai1, HUA Weisan1, MAO Fa1   

  1. 1 Cool Storage Technology Institute, Shanghai Maritime University, Shanghai 201306, China;
    2 School of Marine Engineering, Qinzhou University, Qinzhou 535000, Guangxi, China
  • Received:2016-09-18 Revised:2017-03-14 Online:2017-07-05 Published:2017-07-05
  • Contact: 10.11949/j.issn.0438-1157.20161297
  • Supported by:

    supported by the Key Project of Shanghai Municipal Education Commission (12ZZ154), the Graduate Innovation Fund of Shanghai Maritime University(2014ycx051) and Shanghai Science and Technology Commission Project (16040501600).

脉动热管相变蓄热器蓄热实验分析

罗孝学1,2, 章学来1, 华维三1, 毛发1   

  1. 1 上海海事大学蓄冷技术研究所, 上海 201306;
    2 钦州学院海运学院, 广西 钦州 535000
  • 通讯作者: 章学来
  • 基金资助:

    上海市教委重点项目“利用相变蓄热余热回收的移动供热关键技术研究”(12ZZ154);上海海事大学研究生创新基金项目“太阳能高效双温相变集热器理论和实验研究”(2014ycx051);上海市科委项目(16040501600)。

Abstract:

To research actual effect of heat transfer enhancement on pulsating heat pipe of phase change heat storage device, a pulsating heat tube type phase change heat storage device was designed and set up. The phase change thermal storage device has obvious phase change heat storage process; latent heat of phase change heat storage capacity is much greater than the sensible heat storage. Heating fluid flow increases under the same conditions have a role about the heat transfer enhancement, but the flow is not too large. Adjust the heat source temperature, the higher the temperature, the less time required for the phase change heat storage process. Compared with conventional copper tube, the heat storage device of pulsating heat pipe has saved 47% of the heat storage time in the process of heat storage and the heat transfer uniformity of the phase change heat storage device is optimized. It is verified that the heat transfer enhancement of the heat storage system is feasible by using pulsating heat pipe technology.

Key words: pulsating heat pipe, phase change, heat transfer, optimization, experiment

摘要:

为了研究脉动热管对相变蓄热装置传热能力的优化,设计并搭建了脉动热管相变蓄热装置试验台,实验验证相变潜热蓄热量远大于显热蓄热量;在相同工况下改变加热流体流量,流量增大对传热优化有一定作用,但流量不宜过大;调整热源温度,温度越高,相变蓄热过程所需要的时间就越少;与常规铜管进行蓄热实验对比,脉动热管相变蓄热装置在蓄热过程中节省了47%的蓄热时间,同时优化了相变蓄热装置的传热均匀性。实验证明利用脉动热管技术对相变蓄热系统进行传热优化是可行的。

关键词: 脉动热管, 相变, 传热, 优化, 实验

CLC Number: