Experimental investigation on FDB starting point in three-side heating narrow rectangular channel

doi:10.11949/j.issn.0438-1157.20180475

Abstract

Abstract:

The deionized water was used as the experimental medium, and the fully developed boiling (FDB) starting point of the three-sided heated narrow rectangular channel with a section of 3 mm×43 mm was studied. The influence of some thermal parameters on FDB starting point is analyzed. Empirical correlation of FDB's heat flux suitable for the three-side heating narrow rectangular channel was obtained by nonlinear regression analysis for experimental data of FDB starting location. The results show that the new empirical correlation can accurately predict heat flux of FDB in the three-side heating narrow rectangular channel. The relative error of predicting value is 15.17%. Besides, the simulation results of new empirical correlation are compared with some existing experimental data. The experimental data obtained from one-side heating narrow rectangular channel are in fairly agreement with new empirical correlation. This shows that new empirical correlation is well suited for one-side heating narrow rectangular channel.

Key words: three-side heating, narrow rectangular channel, FDB starting point, two-phase flow, heat transfer, phase change

摘要：

以去离子水为实验介质，对截面为3 mm×43 mm的三面加热窄矩形通道内饱和沸腾（FDB）起始点进行了实验研究。分析了部分热工参数对饱和沸腾起始点的影响，对三面加热窄矩形通道内饱和沸腾起始点的数据进行非线性回归分析，得到适用于三面加热窄矩形通道饱和沸腾起始点热通量的经验关系式。结果表明：新拟合得到的关系式能较准确地预测三面加热窄矩形通道内饱和沸腾起始点的热通量，其预测值的相对误差为15.17%。将新关系式计算结果与现有实验数据进行比较，源于单面加热窄矩形通道的实验数据与新关系式符合程度较好，表明新关系式可适用于单面加热窄矩形通道。

关键词: 三面加热, 窄矩形通道, 饱和沸腾起始点, 两相流, 传热, 相变

CLC Number:

TK121

ZHOU Yunlong, GUO Xintian, ZHANG Wenchao, CHEN Xu. Experimental investigation on FDB starting point in three-side heating narrow rectangular channel[J]. CIESC Journal, 2018, 69(12): 4972-4978.

周云龙, 郭新田, 张文超, 陈旭. 三面加热窄矩形通道内饱和沸腾起始点的实验研究[J]. 化工学报, 2018, 69(12): 4972-4978.

References 32

[1]	AOKI S, INOUE A, ARITOMI M, et al. Experimental study on the boiling phenomena within a narrow gap[J]. International Journal of Heat and Mass Transfer, 1982, 25(7):985-990.
[2]	RIBATSKI G, THOME J R. Two-phase flow and heat transfer across horizontal tube bundles-a review[J]. Heat Transfer Engineering, 2007, 28(6):508-524.
[3]	HAN J L, SANG Y L. Heat transfer correlation for boiling flows in small rectangular horizontal channels with low aspect ratios[J]. International Journal of Multiphase Flow, 2001, 27(12):2043-2062.
[4]	MIZUTANI Y, TOMIYAMA A, HOSOKAWAS, et al. Two-phase flow patterns in a four by four rod bundle[J]. Journal of Nuclear Science and Technology, 2007, 44(6):894-901.
[5]	FUJITA Y, OHTA H, UCHIDA S, et al. Nucleate boiling heat transfer and critical heat flux in narrow space between rectangular surfaces[J]. International Journal of Heat & Mass Transfer, 1988, 31(2):229-239.
[6]	HSU Y Y. On the size range of active nucleation cavities on a heating surface[J]. Journal of Heat Transfer, 1962, 84(3):207-213.
[7]	黄理浩, 陶乐仁, 郑志皋, 等. 垂直矩形窄通道内饱和沸腾起始点实验研究[J]. 工程热物理学报, 2014, 35(8):1629-1632. HUANG L H, TAO L Y, ZHENG Z G. et al. Experiment study for the FDB starting point of vertical rectangular narrow channels[J]. Journal of Engineering Thermophysics, 2014, 35(8):1629-1632.
[8]	STUAB F W. The void fraction in subcooled boiling-prediction of the initial point of net vapor generation[J]. Journal of Heat Transfer, 1968, 90(1):151-157.
[9]	鲁钟琪. 两相流与沸腾传热[M]. 北京:清华大学出版社, 2002. LU Z Q. Two-Phase Flow and Boiling Heat Transfer[M]. Beijing:Tsinghua University Press, 2002.
[10]	SAHA P, ZUBER N. Point of net vapor generation and vapor void fraction in subcooled boiling[J]. International Journal of Heat Transfer, 1974, 112(3):259-261.
[11]	BARTEL M D, MAMORU I. Interfacial area measurements in subcooled flow boiling[J]. Nuclear Engineering and Design, 2001, 210(1):135-155.
[12]	徐济鋆. 沸腾传热和气液两相流[M]. 北京:原子能出版社, 2001. XU J J. Boiling Heat Transfer and Gas-Liquid Two-Phase Flow[M]. Beijing:Atomic Energy Press, 2001.
[13]	郝老迷, 胡古, 郭春秋. 沸腾传热和气液两相流动[M]. 哈尔滨:哈尔滨工程大学出版社, 2016. HAO L M, HU G, GUO C Q. Boiling Heat Transfer and Gas-Liquid Two-Phase Flow[M]. Harbin:Harbin Engineering University Press, 2016.
[14]	BIBEAU E L, SALEUDEAN M. Subcooled void growth mechanisms and prediction at low pressure and low velocity[J]. International Journal of Multiphase Flow, 1994, 20(5):837-863.
[15]	BIBEAU E L, SALEUDEAN M. A study of bubble ebullition in forced-convective subcooled nucleate boiling at low pressure[J]. International Journal of Heat Mass Transfer, 1994, 37(15):2245-2259.
[16]	阎昌琪, 孙中宁. 流动欠热沸腾通道内净蒸汽产生起始点的确定[J]. 核科学与工程, 2000, 20(2):130-134. YAN C Q, SUN Z N. The determination of the initial point of net vapor generation in flow subcooled boiling[J]. Chinese Journal of Nuclear Science and Engineering, 2000, 20(2):130-134.
[17]	LEE S C, BANKOFF S G. A comparison of predictive models for the onset of significant void at low pressures in forced-convection subcooled boiling[J]. International Journal, 1988, 12(3):504-513.
[18]	QI S, RUICHANG Y, HUA Z. Predictive study of the incipient point of net vapor generation in low-flow subcooled boiling[J]. Nuclear Engineering and Design, 2003, 225(2):249-256.
[19]	杨瑞昌, 王彦武, 唐虹, 等. 自然循环过冷沸腾净蒸汽产生点的实验研究[J]. 工程热物理学报, 2003, 24(2):247-250. YANG R C, WANG Y W, TANG H, et al. Experimental study on the point of net vapor generation in a natural circulation system with subcooled boiling[J]. Journal of Engineering Thermophysics, 2003, 24(2):247-250.
[20]	UNAL H H. Determination of the initial point of net vapor generation in flow boiling system[J]. Heat Mass Transfer, 1975, 18(9):1095-1099.
[21]	ROGERS J T. The onset of significant void in up-flow boiling of water at low pressure and velocities[J]. Heat Mass Transfer, 1987, 30(11):2247-2260.
[22]	LEVY S. Forced convection subcooled boiling-prediction of vapor volumetric fraction[J]. International Journal of Heat and Mass Transfer, 1967, 10(7):951-965.
[23]	孙奇, 杨瑞昌. 低流速净蒸汽产生点模型预测过冷沸腾空泡率[J]. 热能动力工程, 2004, 19(2):124-126. SUN Q, YANG R C. Predictive models of the point of net vapor generation in low-flow subcooled boiling[J]. Journal of Engineering For Thermal Energy and Power, 2004, 19(2):124-126.
[24]	孙奇, 杨瑞昌, 赵华. 低流速过冷沸腾净蒸汽产生点计算模型[J]. 核动力工程, 2003, 24(5):417-420. SUN Q, YANG R C, ZHAO H. Prediction model for initial point of net vapor generation for low-flow boiling[J]. Nuclear Power Engineering, 2003, 24(5):417-420.
[25]	潘良明, 何川, 辛明道, 等. 单面与双面加热时窄缝流道内过冷沸腾气泡行为的比较[J]. 化工学报, 2004, 55(9):1519-1522. PAN L M, HE C, XIN M D, et al. Comparison of bubble behavior for double-side and single-side heating of subcooled flow boiling in narrow channels[J]. Journal of Chemical Industry and Engineering(China), 2004, 55(9):1519-1522.
[26]	BASU N, WARRIER G R, DHIR V K. Onset of nucleate boiling and active nucleation site density during subcooled flow boiling[J]. Journal of Heat Transfer, 2002, 124(4):717-728.
[27]	KANDLIKAR S G. Heat transfer characteristics in partial boiling, fully developed boiling, and significant void flow regions of subcooled flow boiling[J]. Journal of Heat Transfer, 1998, 120(2):395-401.
[28]	周云龙, 侯延栋, 李洪伟. 棒束通道内过冷沸腾起始点的实验研究[J]. 原子能科学技术, 2014, 48(8):1416-1420. ZHOU Y L, HOU Y D, LI H W. Experiment study on onset of nucleate boiling in rod bundle channel[J]. Atomic Energy Science and Technology, 2014, 48(8):1416-1420.
[29]	KANDLIKAR S G. Development of a flow boiling map for subcooled and saturated flow boiling of different fluids inside circular tubes[J]. Journal of Heat Transfer, 1991, 113(1):190-200.
[30]	MCADAMS W H, KENNEL W E, MINDEN C S, et al. Heat transfer at high rates to water with surface boiling[J]. Industrial & Engineering Chemistry, 1949, 41(9):1945-1953.
[31]	JENS W H, LOTTES P A. Analysis of heat transfer, burnout, pressure drop and density data for high pressure water[J]. Boiling, 1951, 9(2):51-59.
[32]	OMAR S, YAHIA A, DAESEONG J. ONB, OSV, and OFI for subcooled flow boiling through a narrow rectangular channel heated on one-side[J]. International Journal of Heat and Mass Transfer, 2018, 116:136-151.