CIESC Journal ›› 2012, Vol. 63 ›› Issue (S2): 21-25.DOI: 10.3969/j.issn.0438-1157.2012.z2.004

Previous Articles     Next Articles

Theoretical analysis of uniform flow distribution in vertical radial adsorption bed

LU Junliang, ZHANG Xuejun, QIU Limin, WANG Xiaolei   

  1. Institute of Refrigeration and Cryogenics, Zhejiang University, Hangzhou 310027, Zhejiang, China
  • Received:2012-09-18 Revised:2012-09-27 Online:2012-12-28 Published:2012-12-28
  • Supported by:

    supported by the National Basic Research Program of China(2011CB706501).

立式径向流吸附器中流体均布的理论分析

陆军亮, 张学军, 邱利民, 王晓蕾   

  1. 浙江大学制冷与低温研究所, 浙江 杭州 310027
  • 通讯作者: 张学军
  • 作者简介:陆军亮(1984-),男,博士研究生。
  • 基金资助:

    国家重点基础研究发展计划项目(2011CB706501)。

Abstract: In order to improve adsorption efficiency for air separation,a cone is commonly designed in internal flow passage to keep equal pressure drop gradient along axial direction of internal and external flow passages to ensure that air is distributed uniformly in adsorbent.This paper concludes a dimensionless differential equation that adsorption bed parameters must meet when air is uniformly distributed in adsorbent by pressure drop analysis of vertical radial Π type flow adsorption bed.An experimental radial adsorption bed is also designed in this paper.The variation law of cone section radius along axial height is obtained by solving this dimensionless differential equation,which provides theoretical support for designing this kind of radial flow adsorption bed.

Key words: vertical radial, adsorption bed, uniform distribution

摘要: 为提高空分用吸附器吸附效率,通常在内分布流道布置一锥体使内外分布流道沿轴向压降梯度相等以保证空气在吸附剂中流场均匀。通过对立式径向Z型吸附器内的压降分析,推导出一个可表征当空气在吸附剂中均匀分配时吸附器各参数应满足的量纲1微分控制方程。同时对一个实验径向吸附器进行设计,利用该量纲1微分控制方程获得了锥体截面半径随轴向高度的变化规律,为该类径向吸附器的设计提供了理论依据。

关键词: 立式径向, 吸附器, 均布

CLC Number: