化工学报 ›› 2015, Vol. 66 ›› Issue (11): 4501-4508.DOI: 10.11949/j.issn.0438-1157.20150517

• 分离工程 • 上一篇    下一篇

羧甲基纤维素钠螯合Cu(Ⅱ)的稳定常数测定及螯合效果分析

冯颖, 王珏程, 郑龙行, 苏辰长, 张建伟   

  1. 沈阳化工大学能源与动力工程学院, 辽宁 沈阳 110142
  • 收稿日期:2015-04-23 修回日期:2015-07-08 出版日期:2015-11-05 发布日期:2015-11-05
  • 通讯作者: 冯颖
  • 基金资助:

    国家自然科学基金项目(21406142)。

Determination of CMC-Cu2+ stability constant and analysis of CMC chelate copper ion effect

FENG Ying, WANG Juecheng, ZHENG Longxing, SU Chenchang, ZHANG Jianwei   

  1. School of Energy and Power Engineering, Shenyang University of Chemical Technology, Shenyang 110142, Liaoning, China
  • Received:2015-04-23 Revised:2015-07-08 Online:2015-11-05 Published:2015-11-05
  • Supported by:

    supported by the National Natural Science Foundation of China (21406142).

摘要:

为了考察羧甲基纤维素钠(CMC)对重金属离子 的螯合能力,利用紫外分光光度法测定了不同c(Cu2+)/c(—COO-)浓度比下CMC与 形成螯合物的吸收光谱,探讨了螯合物的组成,并计算其稳定常数。结果表明:CMC对 有螯合作用,当c(Cu2+)/c(—COO-)小于0.6,螯合物在237 nm处出现最大吸收峰,—COO-为主要配体,与 按物质的量比为2:1进行螯合,此时,螯合物稳定常数为1.88×1010;c(Cu2+)/c(—COO-)为0.6~1.0时,214、237 nm处出现最大吸收峰,—COO-、—OH都参与螯合反应并形成新的螯合物;c(Cu2+)/ c(—COO-)大于1.0时,214 nm存在最大吸收峰,—OH为主要配体。考察了利用CMC螯合去除溶液中 的效果,实验表明,CMC-Cu螯合物可在溶液中直接析出,析出物为絮状沉淀。当c(Cu2+)/c(—COO-)等于0.5时为最佳CMC用量,此时上清液中 去除率可以达到96%以上。

关键词: 羧甲基纤维素钠, 铜离子, 紫外分光光度法, 螯合, 稳定常数

Abstract:

In order to investigate chelating ability of sodium carboxymethyl cellulose (CMC) on copper ions, the absorption spectra of the copper ion complex with CMC were measured via ultraviolet spectrophotometry. The composition of the complex was discussed and its stability constants were calculated. The experimental results show that CMC exhibits adsorption peak at 196 nm. When c(Cu2+)/c(—COO-) is less than 0.6, the absorption peak of the complex appears at 237 nm, —COO- group of CMC is the main ligand and reacts with Cu2+ in a molar ratio of 2:1 to form complex CMC-Cu2+, and the complex stability constant is 1.88×1010. When c(Cu2+)/c(—COO-) is from 0.6 to 1.0, the maximum absorption peak of the complex appears at 214, 237 nm. —COO- and —OH are involved in the complexation reaction to form a new complex. When c(Cu2+)/c(—COO-) is greater than 1.0, the maximum absorption is in 214 nm and —OH is the primary ligand. The paper also investigates the removal effect of Cu2+ by CMC chelating. Experiments show that CMC-Cu directly precipitates to complexes in the solution, with precipitates as floc. c(Cu2+)/c(—COO-) of 0.5 is the optimal usage of CMC in the supernatant, and the removal rate of Cu2+ can reach above 96%.

Key words: CMC, copper(Ⅱ), ultraviolet spectrophotometric method, chelation, stability constant

中图分类号: