LNG接收终端工艺流程动态仿真

doi:10.3969/j.issn.0438-1157.2013.03.030

化工学报 ›› 2013, Vol. 64 ›› Issue (3): 1000-1007.DOI: 10.3969/j.issn.0438-1157.2013.03.030

LNG接收终端工艺流程动态仿真

朱建鲁¹, 李玉星¹, 王武昌¹, 多志丽¹, 谢彬², 喻西崇²

1. 中国石油大学(华东)储运与建筑工程学院,山东青岛266580,;
2. 中海石油研究总院,北京 101149

收稿日期:2012-06-24 修回日期:2012-09-11 出版日期:2013-03-05 发布日期:2013-03-05
通讯作者: 朱建鲁(1985—),男,博士研究生。
作者简介:朱建鲁(1985—),男,博士研究生。
基金资助:
国家科技重大专项(2011ZX05026-006-07)。

Dynamic simulation of LNG import terminal process

ZHU Jianlu¹, LI Yuxing¹, WANG Wuchang¹, DUO Zhili¹, XIE Bin², YU Xichong²

1. College of Pipeline and Civil Engineering, China University of Petroleum, Qingdao 266580, Shandong, China;
2. CNOOC Research Center, Beijing 101149, China

Received:2012-06-24 Revised:2012-09-11 Online:2013-03-05 Published:2013-03-05
Supported by:
supported by the National Science and Technology Major Project of China(2011ZX05026-006-07).

摘要/Abstract

摘要： LNG接收终端的主要功能是接收、储存和再汽化LNG,并通过天然气管网向电厂和城市用户供气。通过建立接收终端各设备的动态模型,增加了必要的控制系统,对流程进行了动态仿真,针对接收终端季节调峰、卸船和储罐超压3种工况进行了案例分析,得到了以下结论:接收终端调峰期间,外输泵、罐内泵功耗变化规律与外输天然气流量变化规律一致;卸船工况主要对压缩机功耗、再冷凝器入口BOG及LNG流量有影响,整个卸船过程一般需要13 h左右;储罐超压过程中,由于压缩机负荷的调节,对压缩机功耗、再冷凝器压力、再冷凝器入口BOG及LNG流量有较大影响,整个超压事故持续时间为15.2 h;对接收终端工艺的设计和运行提出了建议。

关键词: LNG接收终端, 动态仿真, 季节调峰, 卸船, 储罐超压

Abstract: The main function of the LNG import terminal is LNG receiving,storage and re-gasification,then supplying natural gas to power plants and city users by pipelines.Through building the dynamic models of each equipment in the LNG import terminal,and adding the necessary control systems,the process was simulated in dynamic mode,and then three operation conditions of the LNG import terminal were analyzed,including seasonal peak shaving,ship unloading and tank overpressure.During the peak shaving of LNG terminal,the power consumption of LNG send-out pump and in-tank pump changed with the same trend as the flow rate of export nature gas.Compressor power consumption and inlet flow rate of re-condenser,including BOG and LNG were affected by the ship unloading condition,which spent 13 h for the entire process.During the tank overpressure accident,which spent 15.2 h for the entire process,compressor power consumption,re-condenser pressure and inlet flow rate of re-condenser changed with the adjustment of compressor load.Finally,some suggestions on the design and operation of the LNG import terminal were proposed.

Key words: LNG import terminal, dynamic simulation, seasonal peak shaving, ship unloading, tank overpressure

中图分类号:

TE646

朱建鲁, 李玉星, 王武昌, 多志丽, 谢彬, 喻西崇. LNG接收终端工艺流程动态仿真[J]. 化工学报, 2013, 64(3): 1000-1007.

ZHU Jianlu, LI Yuxing, WANG Wuchang, DUO Zhili, XIE Bin, YU Xichong. Dynamic simulation of LNG import terminal process[J]. CIESC Journal, 2013, 64(3): 1000-1007.

参考文献 19

[1]	Lu Enxi(陆恩锡),Zhang Huijuan(张慧娟).Chemical process simulation and related high-tech(Ⅱ):Dynamic simulation of chemical process[J].Chemical Industry and Engineering Process(化工进展),2000,19(1):76-78
[2]	Gu Anzhong(顾安忠).Handbook of LNG Technology(液化天然气技术手册)[M].Beijing:China Machine Press,2010:112-122
[3]	Contreras J,Ferrer J M.Dynamic simulation:a case study[J].Hydrocarbon Engineering,2005,10(5):103-107
[4]	Kumar R.Aspen simulation liquefied natural gas import terminal safety and security study.Texas:Lamar University,2006:34-59
[5]	Liu Hao(刘浩),Jin Guoqiang(金国强).Process comparison and energy saving analysis of BOG gas treatment of LNG receiving terminal[J].Chemical Engineering Design(化工设计),2006,16(1):13-16
[6]	Wang Hong(王红),Bai Gailing(白改玲),Li Yanhui(李艳辉),Wang Lin(王林).The simulated calculation on LNG receiving terminal process[J].Natural Gas Industry(天然气工业),2007,27(11):108-109
[7]	Chen Xue(陈雪),Ma Guoguang(马国光).Influence of parameters on recondensation process performance of LNG receiving terminal[J].Chemical Engineering of Oil & Gas(石油与天然气化工),2008,37(2):100-104
[8]	Zhang Xiaobin(张小斌),Peng Shiyao(彭世垚),Liang Jinghua(梁静华).Flow chart design of small experimental facility for LNG receiving terminal[J].CIESC Journal(化工学报),2009,60(12):95-99
[9]	Fu Zihang(付子航).Dynamic boil-off rate(BOR)modeling of LNG receiving and re-gasification terminals[J].Natural Gas Industry(天然气工业),2011,31(6):85-88
[10]	Jang N,Shin M W,Choi S H,Yoon E S.Dynamic simulation and optimization of the operation of boil-off gas compressors in a liquefied natural gas gasification plant[J].Korean J.Chem.Eng.,2011,28(5):1166-1171
[11]	Lee C J,Lim Y,Uyama Y,Han C.Operational strategy to minimize operating costs in liquefied natural gas receiving terminals using dynamic simulation[J].Korean J. Chem. Eng.,2012,29(4):444-451
[12]	Wang Bochun(王伯春).Dynamic simulation of a CO2-based refrigeration system.Nanjing:Nanjing University of Science and Technology,2003:12-16
[13]	Hammer M.Dynamic simulation of a natural gas liquefaction plant.Trondheim:Norwegian University of Science and Technology,2004:55-108
[14]	Yao Feng(姚峰).LNG receiving terminal BOG compressor operation control mode selection[J].Shanghai Gas(上海煤气),2010(3):14-19
[15]	Qiu Li(邱丽),Zeng Gui'e(曾贵娥),Zhu Xuefeng(朱学峰),Sun Peiqiang(孙培强).A comparative study of PID turning methods[J].Industry Control and Application(工业控制与应用),2005,24(11):28-31
[16]	Hu Lianfeng(胡连峰),Li Qiao(李巧),Liu Dong(刘东),Wu Zhaoguang(吴兆光),Qi Juan(戚娟).Injection and production scale design for seasonal-peak-shaving underground gas storage:a case study of Xiangguosi UGS in the eastern Sichuan Basin[J].Natural Gas Industry(天然气工业),2011,35(5):96-98
[17]	Zeng Guangfang(曾光芳).Simulation of liquid cargo handling system of LNG carrier.Shanghai:Shanghai Maritime University,2007:22-23
[18]	Liu Hao(刘浩),Zhou Yongchun(周永春).Design of pressure safety system of LNG cryogenic storage tank[J].Chemical Engineering Design(化工设计),2007,17(1):7-16
[19]	Zhang Linsong(张林松),Xing Guizhu(邢贵柱).Pressure and vacuum relief devices of storage tank at LNG receiving terminal[J].Gas & Heat(煤气与热力),2009,29(7):4-6

LNG接收终端工艺流程动态仿真

Dynamic simulation of LNG import terminal process

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 19

相关文章 15

编辑推荐

Metrics

本文评价

[1]	张思雨, 殷勇高, 贾鹏琦, 叶威. 双U型地埋管群跨季节蓄热特性研究[J]. 化工学报, 2023, 74(S1): 295-301.
[2]	宋嘉豪, 王文. 斯特林发动机与高温热管耦合运行特性研究[J]. 化工学报, 2023, 74(S1): 287-294.
[3]	杨欣, 王文, 徐凯, 马凡华. 高压氢气加注过程中温度特征仿真分析[J]. 化工学报, 2023, 74(S1): 280-286.
[4]	戚子豪, 钟文琪, 陈曦, 周冠文, 赵小亮, 辛美静, 陈翼, 朱永长. 基于混合建模的水泥生料分解过程动态特性研究[J]. 化工学报, 2022, 73(5): 2039-2051.
[5]	张成, 潘立志, 李元. 基于加权统计特征KICA的故障检测与诊断方法[J]. 化工学报, 2022, 73(2): 827-837.
[6]	王佳星, 赵家睿, 李斯特, 付媛, 刘凤杰, 韦昌. 不同放汽阀流量特性对弹射过程的影响规律[J]. 化工学报, 2021, 72(S1): 318-325.
[7]	姜佳彤, 胡斌, 王如竹, 刘华, 张治平, 李宏波. R1233zd（E）高温热泵用卧式冷凝器的换热动态模拟[J]. 化工学报, 2021, 72(S1): 98-105.
[8]	孙浩然, 吕中原, 吴成云, 胡海涛. 机载补气增焓制冷系统动态仿真模型[J]. 化工学报, 2021, 72(5): 2484-2492.
[9]	江锦波, 滕黎明, 孟祥铠, 李纪云, 彭旭东. 基于多变量摄动的超临界CO₂干气密封动态特性[J]. 化工学报, 2021, 72(4): 2190-2202.
[10]	阿嵘, 庞丽萍, 杨东升, 齐玢. 高速飞行器机载综合热管理系统设计与优化[J]. 化工学报, 2020, 71(S1): 315-321.
[11]	齐玢, 段希希, 阿嵘, 江泓升. 载人航天器环热控一体化仿真分析[J]. 化工学报, 2020, 71(S1): 300-306.
[12]	郭晓雨, 田喆, 牛纪德, 祝捷. 基于分时电价的区域管网系统储能应用研究[J]. 化工学报, 2020, 71(S1): 293-299.
[13]	罗坤, 毛晓东, 庞丽萍. 新型直升机热泵空调系统驾驶舱热控性能[J]. 化工学报, 2020, 71(S1): 187-193.
[14]	马双忱, 周权, 曹建宗, 刘琦, 陈文通, 樊帅军, 要亚坤, 林宸雨, 马彩妮. 湿法脱硫系统动态过程建模与仿真[J]. 化工学报, 2020, 71(8): 3741-3751.
[15]	万忠民,全文祥,阎瀚章,陈曦,黄泰明,张焱,张敬,孔祥忠. 无人机用燃料电池系统性能分析[J]. 化工学报, 2019, 70(S2): 329-335.