CIESC Journal ›› 2018, Vol. 69 ›› Issue (5): 2255-2262.DOI: 10.11949/j.issn.0438-1157.20171276

Previous Articles     Next Articles

Chitin/polyethyleneimine composite as an adsorbent of aqueous Cr (Ⅵ)

LIANG Xingtang, ZHONG Shuming, LIU Zijie, ZHENG Yunying, ZHANG Ruirui, JIAO Shufei, LIAO Riquan, WANG Yun, YIN Yanzhen   

  1. Qinzhou Key Laboratory of Selenium-enriched Functional Utilization of Biowaste Resources, College of Petroleum and Chemical Engineering, Qinzhou University, Qinzhou 535000, Guangxi, China
  • Received:2017-09-19 Revised:2017-11-09 Online:2018-05-05 Published:2018-05-05
  • Supported by:

    supported by the National Natural Science Foundation of China (51303088, 51663020), China Postdoctoral Science Foundation (2015M582482), Project of Guangxi Colleges and Universities Key Laboratory of Beibu Gulf Oil and Natural Gas Resource Effective Utilization (2017KLOG12), and Project of Guangxi Colleges and Universities for the Promotion of Foundation Ability of Young Teachers (2018KY0599).

甲壳素/聚乙烯亚胺复合物对水溶液中Cr(Ⅵ)的吸附

梁兴唐, 钟书明, 刘子杰, 郑韵英, 张瑞瑞, 焦淑菲, 廖日权, 王芸, 尹艳镇   

  1. 钦州学院石油与化工学院, 钦州市生物废弃物资源富硒功能化利用重点实验室, 广西 钦州 535000
  • 通讯作者: 尹艳镇
  • 基金资助:

    国家自然科学基金项目(51303088,51663020);中国博士后科学基金项目(2015M582482);广西高校北部湾石油天然气资源有效利用重点实验室开放课题基金项目(2017KLOG12);广西高校中青年教师基础能力提升项目(2018KY0599)。

Abstract:

The polyethyleneimine (PEI) was homogeneously grafted onto the chitin (CT) with aid of epichlorohydrin to produce CT-based biosorbents (CTP) for removal of Cr(Ⅵ) from water. The structure and morphology of CTP were characterized by FT-IR, XRD, SEM, EDS and Zeta potential. The effects of pH value, contact time, initial Cr(Ⅵ) concentration, treatment temperature and coexisting ions on the Cr(Ⅵ) adsorption were investigated. The results showed that the CTP with a mass ratio of PEI:CT=4:1 (CTP4) presented a maximum adsorption capacity of 330.4 mg·g-1 according to the Langmuir isotherm at 25℃ and pH value 2.0. The adsorption was a spontaneous and endothermal process, which achieved the equilibrium within 60 min and followed the pseudo-second-order kinetic model. After six cycles of adsorption-desorption, the CTP4 remained 89.5% of its original adsorption capacity, suggesting its favorable reusability.

Key words: chitin, polyethyleneimine, homogeneous modification, adsorbent, waste water, Cr (Ⅵ), adsorption

摘要:

均相条件下,通过环氧氯丙烷将聚乙烯亚胺(PEI)接枝于甲壳素(CT)分子上,制备CT基Cr (Ⅵ)生物吸附剂(CTP)。采用FT-IR、XRD、SEM、EDS和Zeta电位表征CTP的结构与形貌。考察了溶液的pH、吸附时间、Cr (Ⅵ)的初始浓度、处理温度和共存离子对吸附的影响。结果表明,PEI与CT质量比为4:1的条件下所制备的CTP4,在pH为2.0和温度为25℃的条件下,根据Langmuir模型计算的最大吸附量为330.4 mg·g–1;吸附过程经过约60 min达到平衡,符合准二级动力学模型,是一个自发、吸热的过程;CTP4可重复使用,经过6次吸附-解吸循环后,其吸附量保持初次吸附量的89.5%。

关键词: 甲壳素, 聚乙烯亚胺, 均相改性, 吸附剂, 废水, Cr (Ⅵ), 吸附作用

CLC Number: