CIESC Journal ›› 2013, Vol. 64 ›› Issue (5): 1797-1802.DOI: 10.3969/j.issn.0438-1157.2013.05.040

Previous Articles     Next Articles

Separation mechanism and application of oil-water microemulsion

QIN Juan1, XIN Yinchang1,2, MA Dehua1   

  1. 1. School of Chemistry, Chemical Engineering and Materials Science, Shandong Normal University, Jinan 250014, Shandong, China;
    2. The Jinan Ke Hui Shale Chemical Technology Co., Ltd., Jinan 250101, Shandong, China
  • Received:2012-09-10 Revised:2012-10-11 Online:2013-05-05 Published:2013-05-05
  • Supported by:

    supported by the Innovation Foundation of National Science and Technology Ministry(01C26213700899).

微乳液的油水分离和机理探讨及应用

秦娟1, 辛寅昌1,2, 马德华1   

  1. 1. 山东师范大学化学化工与材料科学学院, 山东 济南 250014;
    2. 济南科慧页岩化工技术有限公司, 山东 济南 250101
  • 通讯作者: 辛寅昌
  • 作者简介:秦娟(1988-),女,硕士研究生。
  • 基金资助:

    国家科技部创新基金项目(01C26213700899)。

Abstract: A special surfactant can make thermodynamically stable microemulsion liquid change to thermodynamically unstable state, and its complex with a polymer can do the microemulsion separation into a mixture of oil and water.It is found by transmission electron microscopy(TEM)analysis that size of particles dispersed in transparent deinking paper wastewater containing insoluble organic matter is much smaller than visible light wave-length, and this wastewater is at microemulsion state.So, the transparent deinking paper wastewater was taken as test sample, and treated with this complex(a mixture of special surfactant cBPE-2030 and polymer LYPW-301).The chemical oxygen demand(COD)was determined. The results showed that COD value after treatment with this complex was significantly reduced.The mechanism of oil and water separation was explored by TEM analysis for microscopic state change of microemulsion and emulsion liquids.The method separating oil and water of microemulsion could be effectively applied to other transparent wastewater from papermaking and oilfield, whose separation, in general, is difficult.

Key words: special surfactant, microemulsion, emulsion, oil/water separation, transmission electron microscopy(TEM), chemical oxygen demand(COD)

摘要: 用特种表面活性剂使热力学稳定的微乳液变成热力学不稳定的乳状液,并发现该种特种表面活性剂与聚合物复配后能使微乳液油水分离。通过透射电镜(TEM)分析发现含有不溶性有机物的透明脱墨造纸废水的分散颗粒远远小于可见光的波长,呈现微乳液状态,以该种透明废水作为实验对象,用特种表面活性剂与聚合物LYPW-301复配后分离该种微乳液状废水, 通过化学需氧量(COD)测定表明:这种分离方法能够有效降低该种微乳液状废水的COD值。通过TEM分析微乳液和乳状液显微状态的变化探讨了微乳液的油水分离机理。这种分离方法能够有效地应用于其他各种造纸透明废水和油田透明废水的分离中。

关键词: 特种表面活性剂, 微乳液, 乳状液, 油水分离, 透射电镜(TEM), 化学需氧量(COD)

CLC Number: