CIESC Journal ›› 2015, Vol. 66 ›› Issue (9): 3518-3528.DOI: 10.11949/j.issn.0438-1157.20151059

Previous Articles     Next Articles

Adsorption and separation of CH4-N2 with different structural MOFs

HU Jiangliang1,2, SUN Tianjun1, LIU Xiaowei1,2, LI Defu1, ZHAO Shengsheng1, WANG Shudong1   

  1. 1 Dalian National Laboratory for Clean Energy, State Key Laboratory of Catalysis, Dalian Institute of Chemical Physics, Chinese Academy of Sciences, Dalian 116023, Liaoning, China;
    2 University of Chinese Academy of Sciences, Beijing 100049, China
  • Received:2015-07-06 Revised:2015-07-17 Online:2015-09-05 Published:2015-09-05
  • Supported by:

    supported by the National Natural Science Foundation of China (21476231).

CH4-N2在MOFs结构材料中的吸附分离性能

胡江亮1,2, 孙天军1, 刘小伟1,2, 李德伏1, 赵生生1, 王树东1   

  1. 1 中国科学院大连化学物理研究所洁净能源国家实验室, 催化基础国家重点实验室, 辽宁 大连 116023;
    2 中国科学院大学, 北京 100049
  • 通讯作者: 王树东, 孙天军
  • 基金资助:

    国家自然科学基金项目(21476231)。

Abstract:

For CH4-N2 separation with high-efficiency, several typical MOFs based on different ligands with high surface areas were synthesized in large scale via the simple solvothermal method, and their CH4/N2 separation performance was investigated experimentally by pure gas adsorption and binary gas breakthrough experiments. The results show that the adsorptive separation selectivity of most MOFs is much higher than that of Si/Al zeolites owing to their lower polarity, and the selectivity of MOFs with multidentate ligands are similar with that of high-quality activated carbon because their wide pore sizes resulted from the long linkers are not good for the separation of CH4/N2. In addition, the open metal sites in MOFs increase channel polarity, which is not conducive to improving the separation selectivity of CH4/N2 mixtures. Fortunately, the ultra-microporous adsorbent (0.5 nm) based on monodentate ligand, namely [Ni3(HCOO)6] synthesized by the short linker of HCOO- and Ni2+, has a much higher selectivity up to 7.0, twice that of conventional adsorbents, such as Si/Al zeolites and actvited carbons. In a word, the knowledge obtained in this work provides a foundation for the design of new nanoporous materials towards the CH4/N2 separation with high-efficiency.

Key words: adsorptive, separation, methane, nitrogen, metal-organic framework

摘要:

针对甲烷氮气的分离难题,通过溶剂热法大量合成了6种典型的由单齿、多齿与多元配体构建的金属有机框架材料,并利用单组分静态与双组分动态吸附法分别研究了甲烷与氮气在材料中的吸附行为。研究结果表明,MOFs材料相对较弱的极性,致使其甲烷氮气的分离选择性明显优于Si/Al分子筛;多齿配体MOFs材料因配体较长,孔道较大,具有与活性炭相当的甲烷氮气分离选择性;MOFs中的不饱和金属位增大了孔道极性,不利于分离性能的提高;单齿甲酸配体构建的超微孔[Ni3(HCOO)6]框架具有非常优异的CH4/N2分离性能,其选择性高达7.0,是Si/Al分子筛与活性炭的2倍。这为高效甲烷氮气分离材料的设计提供了新的参考依据。

关键词: 吸附, 分离, 甲烷, 氮气, 金属有机框架

CLC Number: