化工学报 ›› 2012, Vol. 63 ›› Issue (10): 3045-3051.DOI: 10.3969/j.issn.0438-1157.2012.10.006

• 流体力学与传递现象 • 上一篇    下一篇

分段组合式厌氧生物反应器流态特性

季军远, 邢雅娟, 郑平   

  1. 浙江大学环境工程系, 浙江 杭州 310058
  • 收稿日期:2012-02-09 修回日期:2012-04-26 出版日期:2012-10-05 发布日期:2012-10-05
  • 通讯作者: 郑 平
  • 作者简介:郑平,季军远(1980- ),男,博士研究生。
  • 基金资助:

    浙江省重大科技专项(2010C13001);国家高技术研究发展计划项目(2009AA06Z311)。

Flow patterns of compartmentalized anaerobic reactor

JI Junyuan, XING Yajuan, ZHENG Ping   

  1. Department of Environmental Engineering, Zhejiang University, Hangzhou 310058, Zhejiang, China
  • Received:2012-02-09 Revised:2012-04-26 Online:2012-10-05 Published:2012-10-05
  • Supported by:

    supported by the High-tech Research and Development Program of China(2009AA06Z311).

摘要: 厌氧生物反应器高效性与稳定性取决于其流态特性的优良,采用示踪剂脉冲刺激响应技术研究了自主研发的分段组合式厌氧生物反应器的流态,以期揭示其高效机理,便于工程化开发与应用。试验结果表明:常负荷下该反应器的流态趋于平推流;以轴向扩散模型表征,不产气与产气工况下的Peclet数分别为7.94和5.66;以多釜串联模型表征,不产气与产气工况下的串联釜数分别为4.55与3.44。高负荷与超高负荷下该反应器的流态趋于全混流,以轴向扩散模型表征,不产气与产气工况下的Peclet数分别为4.02、2.57和3.93、3.77;以多釜串联模型表征,不产气与产气工况下的串联釜数分别为2.66、2.00与2.62、2.51。反应器总死区的平均值为33.58%,其中水力死区的平均值为13.58%。建立了水力死区Vh(%)与容积水力负荷L(m3·m-3·d-1)和容积产气速率G(m3·m-3·d-1)之间的关联式。值得注意的是,在分段组合式厌氧反应器中,容积产气速率对水力死区的影响小于容积水力负荷。

关键词: 厌氧反应器, 流态, 死区

Abstract: The compartmentalized anaerobic reactor(CAR)has outstanding potential in wastewater treatment engineering.The flow patterns of CAR were investigated through pulse stimulus-response technique using sodium fluoride as tracer,and were analyzed by means of the axial dispersion(AD)model and the tanks-in-series(TIS)model.The results showed that back-mixing was small and flow pattern tended to be plug-flow at normal loading rate,Peclet numbers of AD model under the condition with or without biogas production were 5.66 and 7.94 respectively,N numbers of TIS model under the condition with or without biogas production were 3.44 and 4.55 respectively.Back-mixing was large and flow pattern tended to be completely mixed flow at high or super-high loading rate,Peclet numbers of AD model under the condition with or without biogas production were 2.57,4.02 and 3.77,3.93 respectively,N numbers of TIS model under the condition with or without biogas production were 2.00,2.66 and 2.51,2.62 respectively.Average total dead space of CAR was 33.58%,of which average hydraulic dead space was 13.58%.Regression equation was established for parameters of hydraulic dead space(Vh),volumetric hydraulic loading rate(L)and volumetric biogas production rate(G).The effect of volumetric biogas production rate(G)on hydraulic dead space(Vh)was less than that of volumetric hydraulic loading rate(L)in CAR.

Key words: anaerobic reactor, flow pattern, dead space

中图分类号: