轧钢含油污泥湿式减压蒸馏处理工艺优化

doi:10.11949/j.issn.0438-1157.20170708

摘要/Abstract

摘要：

使用湿式减压蒸馏法分离轧钢含油污泥的油分和残渣。采用二次通用旋转组合设计实验，研究了温度、真空度和水蒸气流量对分离效果的影响。结果表明，相比于简单蒸馏，湿式减压蒸馏能显著减轻对油分的破坏，提高油分回收率。在实验参数范围内，当蒸馏温度为321.4℃、真空度为90 kPa、水蒸气流量为1 ml·min⁻¹时，获得最大油分回收率（57.2%）。回收油分时，过高的温度和水蒸气分压会破坏油分，前者促进油分胶质组分向芳香烃和饱和烃转化，后者则会促进脂类水解，并与Fe₂O₃作用氧化重质油组分，促进胶质组分向芳香烃转化。而对于蒸馏残渣中难以分离的沥青质等大分子有机物，可通过提高温度和水蒸气流量，特别是可以提高温度，促使其分解炭化，以获得较低的残渣含油率，便于残渣中铁金属元素的回收利用。

关键词: 轧钢含油污泥, 蒸馏, 水蒸气, 温度, 油分组成, 废物处理, 回收

Abstract:

Wet vacuum distillation was used to separate oil and residue from one kind of rolling oil sludge. The effects of the three main factors (temperature, vacuum degree and steam flowrate) on the oil yield were studied by using the quadratic general spinning design. The results showed that the wet vacuum distillation could significantly mitigate the oil destruction and promote the oil recovery rate comparing with simple distillation. Within the range of the experimental condition, the optimal conditions were 321.4℃ in temperature, 90 kPa in vacuum degree and 1 ml·min⁻¹ in steam flowrate, at which the oil recovery rate of 57.2% could be reached. Both the excessive temperature and steam flowrate could cause the oil decomposition. If the temperature was too high, it promoted the conversion of oil from resin to aromatics and saturates because of pyrolysis. If the steam partial pressure was too high, oil transformed to aromatics from resin due to the ester-type bonds hydrolysis and the oxidation of heavy oil with co-effect of Fe₂O₃. As for the heavy organic matters, such as asphaltene, which were difficult to be removed from the distillation residuals. By raising the temperature and steam flowrate, especially raising temperature, they can be effectively decomposed and carbonized to achieve a low oil content in the residues, and thus benefitting to their recovery.

Key words: rolling oil sludge, distillation, steam, temperature, oil composition, waste treatment, recovery

中图分类号:

X757

章骅, 鲁文涛, 邵立明, 何品晶. 轧钢含油污泥湿式减压蒸馏处理工艺优化[J]. 化工学报, 2017, 68(12): 4649-4657.

ZHANG Hua, LU Wentao, SHAO Liming, HE Pinjing. Separation of oil and residue from rolling oil sludge by wet vacuum distillation[J]. CIESC Journal, 2017, 68(12): 4649-4657.

参考文献 30

[1]	Integrated Pollution Prevention and Control (IPPC). Reference document on best available techniques in the ferrous metals processing industry[Z]. 2001. http://eippcb.jrc.ec.europa.eu/reference/BREF/fmp_bref_1201.pdf
[2]	SHATOKHA V I, GOGENKO O O, KRIPAK S M. Utilising of the oiled rolling mills scale in iron ore sintering process[J]. Resources Conservation and Recycling, 2011, 55(4):435-440.
[3]	World Steel Association. Steel Statistical Yearbook 2016[EB/OL], 2016. http://www. worldsteel. org/en/dam/jcr:37ad1117-fefc-4df3-b84f-6295478ae460/Steel+Statistical+Yearbook+2016. pdf.
[4]	QIN L B, HAN J, HE X, et al. Recovery of energy and iron from oily sludge pyrolysis in a fluidized bed reactor[J]. Journal of Environmental Management, 2015, 154:177-182.
[5]	LIU B, ZHANG S G, TIAN J J, et al. Recycle of valuable products from oily cold rolling mill sludge[J]. International Journal of Minerals Metallurgy and Materials, 2013, 20(10):941-946.
[6]	MAKKONEN H T, HEINO J, LAITILA L, et al. Optimisation of steel plant recycling in Finland:dusts, scales and sludge[J]. Resources Conservation and Recycling, 2002, 35(1/2):77-84.
[7]	HU G J, LI J B, HOU H B. A combination of solvent extraction and freeze thaw for oil recovery from petroleum refinery wastewater treatment pond sludge[J]. Journal of Hazardous Materials, 2015, 283:832-840.
[8]	ZUBAIDY E A H, ABOUELNASR D M. Fuel recovery from waste oily sludge using solvent extraction[J]. Process Safety and Environmental Protection, 2010, 88(5):318-326.
[9]	巫树锋, 刘发强, 杨岳, 等. 罐底含油污泥萃取溶剂的选择与优化[J]. 环境工程学报, 2013, 7(8):3191-3195. WU S F, LIU F Q, YANG Y, et al. Selection of solvents for extraction of crude oil tank bottom sludge[J]. Chinese Journal of Environmental Engineering, 2013, 7(8):3191-3195.
[10]	赵阳, 戴跃玲, 李晓鸥, 等. 热水洗法处理油田油泥技术的研究[J]. 辽宁石油化工大学学报, 2011, 31(2):14-16. ZHAO Y, DAI Y L, LI X O, et al. Treatment of oily sludge in oil field with hot water washing[J]. Journal of Liaoning Shihua University, 2011, 31(2):14-16.
[11]	杨大正, 刘佳, 徐光, 等. 轧钢污泥综合利用试验[J]. 钢铁, 2015, 50(12):119-123. YANG D Z, LIU J, XU G, et al. Comprehensive utilization of sludge bearing iron scales from rolling process[J]. Iron and Steel, 2015, 50(12):119-123.
[12]	曾宏德. 油泥清洗工艺中的药剂化学研究[D]. 大连:大连理工大学, 2006. ZENG H D. The study of reagent chemistry in oily sludge washing process[D]. Dalian:Dalian University of Technology, 2006.
[13]	李明. 热水洗涤法处理含油污泥研究[D]. 大庆:大庆石油学院, 2010. LI M. Research with hot water washing treatment of oily sludge[D]. Daqing:Daqing Petroleum Institute, 2010.
[14]	陈伟中. 声空化物理[M]. 北京:科学出版社, 2014. CHEN W Z. Cavitation Physics[M]. Beijing:Science Press, 2014.
[15]	XU N, WANG W X, HAN P F, et al. Effects of ultrasound on oily sludge deoiling[J]. Journal of Hazardous Materials, 2009, 171(1/2/3):914-917.
[16]	GAO Y X, DING R, WU S, et al. Influence of ultrasonic waves on the removal of different oil components from oily sludge[J]. Environmental Technology, 2015, 36(14):1771-1775.
[17]	ZHANG J, LI J B, THRING R W, et al. Oil recovery from refinery oily sludge via ultrasound and freeze/thaw[J]. Journal of Hazardous Materials, 2012, 203/204:195-203.
[18]	廖洪强, 赵胜利, 邓德敏, 等. 利用低温蒸馏工艺处理轧钢污泥技术研究[C]//全国能源与热工学术年会. 昆明, 2004:6. LIAO H Q, ZHAO S L, DENG D M, et al. Disposal of rolling mill sludge by the low temperature distillation[C]//National Conference on Energy and Thermal Engineering. Kunming, 2004:6.
[19]	LIU B, ZANG S G, TIAN J J, et al. Strontium ferrite powders prepared from oily cold rolling mill sludge by solid-state reaction method[J]. Rare Metals, 2013, 32(5):518-523.
[20]	鲁文涛, 何品晶, 邵立明, 等. 轧钢含油污泥的热解与动力学分析[J]. 中国环境科学, 2017, 37(3):1024-1030. LU W T, HE P J, SHAO L M, et al. Pyrolyis of rolling oil sludge and its kinetic analysis[J]. China Environmental Science, 2017, 37(3):1024-1030.
[21]	中华人民共和国国家质量监督检验检疫总局, 中国国家标准化管理委员会. 焦化产品水分测试方法:GB/T 2288-2008[S]. 北京:中国标准出版社, 2008. State General Administration of the People's Republic of China for Quality Supervision, Inspection and Quarantine, Standardization Administration of the People's Republic of China. Coking products-determination of moisture:GB/T 2288-2008[S]. Beijing:China Standards Press, 2008.
[22]	KORDA A, SANTAS P, TENENTE A, et al. Petroleum hydrocarbon bioremediation:sampling and analytical techniques, in situ treatments and commercial microorganisms currently used[J]. Applied Microbiology and Biotechnology, 1997, 48(6):677-686.
[23]	MARTINS P F, CARMONA C, MARTINEZ E L, et al. Short path evaporation for methyl chavicol enrichment from basil essential oil[J]. Separation and Purification Technology, 2012, 87:71-78.
[24]	MARTINS P F, CARMONA C, MARTINEZ E L, et al. Evaluation of methyl chavicol concentration by different evaporation processes using central composite experimental design[J]. Separation and Purification Technology, 2012, 98:464-471.
[25]	OZDIKICIERLER O, YEMISCIOGLU F, GUMUSKESEN A S. Effects of process parameters on 3-MCPD and glycidyl ester formation during steam distillation of olive oil and olive pomace oil[J]. European Food Research and Technology, 2016, 242(5):805-813.
[26]	张一安, 徐心茹. 石油化工分离工程[M]. 上海:华东理工大学出版社, 1998:95. ZHANG Y A, XU X R. Separation Engineering of Petrochemical Industry[M]. Shanghai:East China University of Science and Technology Press, 1998:95.
[27]	MASUDA T, KUSHINO T, MATSUDA T, et al. Chemical recycling of mixture of waste plastics using a new reactor system with stirred heat medium particles in steam atmosphere[J]. Chemical Engineering Journal, 2001, 82(1/2/3):173-181.
[28]	FUMOTO E, TAGO T, TOSHIRO TSUJI A, et al. Recovery of useful hydrocarbons from petroleum residual oil by catalytic cracking with steam over zirconia-supporting iron oxide catalyst[J]. Energy & Fuels, 2004, 18(6):1770-1774.
[29]	SONOYAMA N, NOBUTA K, KIMURA T, et al. Production of chemicals by cracking pyrolytic tar from Loy Yang coal over iron oxide catalysts in a steam atmosphere[J]. Fuel Processing Technology, 2011, 92(4):771-775.
[30]	ANTIPENKO V R, GRIN'KO A A, MELENEVSKⅡ V N. Composition of products of analytical pyrolysis of resin and asphaltene fractions of USA oil[J]. Petroleum Chemistry, 2014, 54(3):178-186.