Heat transfer experiment of falling-film evaporation in vertical porous tube

doi:10.11949/j.issn.0438-1157.20150614

Abstract

Abstract:

This paper presents the effect of internal sintered porous tube on the falling-film evaporation heat transfer coefficients. The experiment was performed with a single-tube evaporator, using steam in the shell to heat water in the tube. The falling-film evaporation heat transfer coefficients were calculated under various conditions with heat flux from 13 kW·m^-2 to 90 kW·m^-2, heat transfer temperature difference from 2.87℃ to 9.5℃, and liquid Reynolds number from 4500 to 15000. The experimental results with a smooth tube are compared to those with an internal sintered porous tube. The results show that the falling-film evaporation heat transfer coefficients of an internal sintered porous tube are 2.03 times that of smooth tube, while the overall heat transfer coefficients are 1.78 times. The enhancement effects for heat transfer of internal sintered porous tube are obvious.

Key words: sintered porous tube, falling-film evaporation, heat transfer coefficient, heat transfer enhancement

摘要：

研究了内表面烧结型多孔管对降膜蒸发换热效果的影响。采用单管降膜蒸发器,由壳程的蒸汽加热管程的水降膜传热。在热通量q=13~90 kW·m^-2,传热温差ΔT=2.87~9.5℃,液体Reynolds数Re_L=4500~15000 范围内,求不同工况下管内降膜传热系数,并将其与相对应的光管换热性能进行比较。比较数据可知:多孔管的管内降膜传热系数是光管的2.03 倍,总传热系数是光管的1.78 倍,多孔管强化传热效果明显。

关键词: 烧结型多孔管, 降膜蒸发, 传热系数, 强化传热

CLC Number:

TK124

FAN Yongjian, XU Hong, XU Peng. Heat transfer experiment of falling-film evaporation in vertical porous tube[J]. CIESC Journal, 2016, 67(2): 512-518.

范永坚, 徐宏, 徐鹏. 竖直多孔管降膜蒸发传热实验[J]. 化工学报, 2016, 67(2): 512-518.

References 24

[1]	FAGERHOLM N E, GHAZANFARI A R, KIVIOJA K. Boiling heat transfer performance of plain and porous tubes in falling film flow of refrigerant R114[J]. Heat and Mass Transfer, 1987, 21(6):343-353.
[2]	魏峰. 带螺旋线的管内降膜蒸发器传热性能研究[D]. 天津:河北工业大学, 2005. WEI F. Experimental investigation on heat transfer capability of falling-film evaporator in the vertical tube with spring inserts[D]. Tianjin:Hebei University of Technology, 2005.
[3]	赵鸿汉. 波纹竖管内降落液膜的蒸发传热与流体力学性能[D]. 天津:天津科技大学, 2004. ZHAO H H. Characteristics of heat transfer and hydrodynamics of falling film evaporation in a vertical wavy wall tube[D]. Tianjin:Tianjin University of Science and Technology, 2004.
[4]	SUN P, LIN Z Q. Heat transfer of falling film in vertical tube with superimposed vapor flow[J]. Chemical Engineering, 1993, 21(5):15-19.
[5]	杨冬, 李永星, 陈听宽, 等. 多孔表面管内高沸点工质的强化流动沸腾换热与阻力特性[J]. 化工学报, 2004, 55(10):1631-1637. YANG D, LI Y X, CHEN T K, et al. Enhanced flow boiling heat transfer of high saturation temperature organic fluid in vertical porous tube[J]. Journal of Chemical Industry and Engineering (China), 2004, 55(10):1631-1637.
[6]	GOTO M, INOUE N, ISHIWATARI N. Condensation and evaporation heat transfer of R410A inside internally grooved horizontal tubes[J]. International Journal of Refrigeration, 2001, 24(7):628-638.
[7]	SARBU I, VALEA E S. Water pool boiling heat transfer enhancement for modified surface tubes[J]. International Communications in Heat and Mass Transfer, 2014, 50:61-67.
[8]	HABERT M, THOME J R. Falling-film evaporation on tube bundle with plain and enhanced tubes (Ⅰ):Experimental results[J]. Experimental Heat Transfer, 2010, 23(4):259-280.
[9]	罗林聪. 水平异形管降膜蒸发流动与传热强化机理及实验研究[D]. 济南:山东大学, 2014. LUO L C. Analysis of flow and heat transfer enhancement and experimental research on falling film evaporation on horizontal shaped tubes[D]. Jinan:Shandong University, 2014.
[10]	RAUSCH M H, LEIPERTZ J R A, FRÖBA A P. Dropwise condensation of steam on ion implanted titanium surfaces[J]. International Journal of heat and Mass Transfer, 2010, 53(1/2/3):423-430.
[11]	ROQUES J F, THOME J R. Falling films on arrays of horizontal tubes with R-134a (Ⅰ):Boiling heat transfer results for four types of tubes[J]. Heat Transfer Engineering, 2007, 28(5):398-414.
[12]	RIBATSKI G, THOME J R. Experimental study on the onset of local dry out in an evaporating falling film on horizontal plain tubes[J]. Heat Transfer Engineering, 2007, 28(5):398-414.
[13]	刘阿龙, 徐宏, 王学生, 等. 换热器烧结型表面多孔管综述[J]. 石油化工设备, 2005, 34(1):47-49. LIU A L, XU H, WANG X S, et al. Summarization of sintered surface porous tubes of heat exchanger[J]. Petro-Chemical Equipment, 2005, 34(1):47-49.
[14]	KLINE S J, MCCLINTOCK F A. Describing uncertainties in single-sample experiments[J]. Mechanical Engineering, 1953, 75:3-8.
[15]	HERBERT L S, STERNS U J. An experimental investigation of heat transfer to water in film flow (Ⅱ):Boiling runs with and without induced swirl[J]. The Canadian Journal of Chemical Engineering, 1968, 46(6):408-412.
[16]	LIU Z H, YI J. Falling film evaporation heat transfer of water/salt mixtures from roll-worked enhanced tubes and tube bundle[J]. Applied Thermal Engineering, 2002, 22(1):83-95.
[17]	FUJITA Y, TSUTSUI M. Experimental study of falling-film evaporation on horizontal tubes[J]. Heat Transfer, 1998, 27(8):609-618.
[18]	LEE S, KÖROGLU B, PARK C. Experimental investigation of capillary-assisted solution wetting and heat transfer using a micro-scale, porous-layer coating on horizontal-tube, falling-film heat exchanger[J]. International Journal of Refrigeration, 2012, 35:1176-1187.
[19]	FAGHRI A, ZHANG Y W, HOWELL J. Advanced Heat and Mass Transfer[M]. Washington D.C.:Taylor & Francis, 1995:726.
[20]	沈吟秋,郭宜祜. 水平管外喷淋式降膜蒸发的研究[J]. 化工学报, 1987, 38(4):467-475. SHEN Y Q, GUO Y H. Investigation on the spray film evaporation on the outside of a single horizontal-tube[J]. Journal of Chemical Industry and Engineering (China), 1987, 38(4):467-475.
[21]	陈砺, 陈仲言. 水平椭圆多孔管外降膜沸腾传热的研究[J]. 化学工程, 1990, 18(3):35-40. CHEN L, CHEN Z Y. Falling film boiling heat transfer on horizontal elliptical tube[J]. Chemical Engineering (China), 1990, 18(3):35-40.
[22]	陈振兴, 蔡祺凤. 烧结型表面多孔管的沸腾传热研究[J].轻金属, 1994, (4):10-14. CHEN Z X, CAI Q F. Boiling heat transfer study of sintered porous tube[J]. Light Metals, 1996, (4):10-14.
[23]	戴玉林. 金属表面多孔层制备技术与沸腾强化性能研究[D]. 上海:华东理工大学, 2010. DAI Y L. Study on manufacturing technology and boiling enhancing characteristics of porous metallic layer[D]. Shanghai:East China University of Science and Technology, 2010.
[24]	韩坤, 刘阿龙, 彭东辉, 等. 内表面烧结型多孔管的流动沸腾换热[J]. 热能动力工程, 2011, 26(1):48-52. HAN K, LIU A L, PENG D H, et al. Boiling heat transfer study of internal sintered porous tubes[J]. Journal of Engineering for Thermal Energy and Power, 2011, 26(1):48-52.