CIESC Journal ›› 2015, Vol. 66 ›› Issue (7): 2514-2520.DOI: 10.11949/j.issn.0438-1157.20141781

Previous Articles     Next Articles

Hydrodesulfurization performance of TiO2-graphene oxide composite support prepared by electro-spinning

WANG Huaiyuan, XIAO Bo, WANG Chijia, CHENG Xiaoshuang, JIANG Feng   

  1. School of Chemistry & Chemical Engineering, Northeast Petroleum University, Daqing 163318, Heilongjiang, China
  • Received:2014-12-01 Revised:2015-03-30 Online:2015-07-05 Published:2015-07-05
  • Supported by:

    supported by the National Natural Science Foundation of China (51175066) and the Provincial Key Laboratory of Oil & Gas Chemical Technology (PS13H11).

静电纺丝法制备氧化钛-氧化石墨复合载体的加氢脱硫性能

汪怀远, 肖博, 王池嘉, 程小双, 蒋凤   

  1. 东北石油大学化学化工学院, 黑龙江 大庆 163318
  • 通讯作者: 汪怀远
  • 基金资助:

    国家自然科学基金项目(51175066);黑龙江省重点实验室项目(PS13H11)。

Abstract:

Novel TiO2 nanofibers(NF) and TiO2(NF)-graphene oxide (GO) supports were prepared by electro-spinning, and NiMo/TiO2(NF) and NiMo/TiO2(NF)-GO catalysts were obtained by incipient impregnation. The properties of supports and catalysts were characterized by N2 absorption-desorption, X-ray diffraction, SEM, TEM, Raman spectra and NH3-TPD. The effect of different loading of GO was investigated. The results showed that when the mass fraction of GO/TiO2(NF) was 0.5%, the intermediate-strong acid sites increased to the maximum. Under the mild conditions of 280℃, 2.0 MPa, LHSV 4 h-1 and H2/feed ratio 400 (vol), the corresponding catalyst exhibited the excellent HDS performance.

Key words: electro-spinning, TiO2 nanofibers, graphene oxide, hydrodesulfurization, catalyst, support

摘要:

以静电纺丝法制备TiO2纳米纤维(TiO2(NF))和TiO2-氧化石墨(GO)复合纳米纤维(TiO2(NF)-GO)加氢脱硫催化剂的载体,采用等体积浸渍法制备NiMo/TiO2(NF)和NiMo/TiO2(NF)-GO催化剂,运用N2吸附-脱附、X射线衍射、XPS、TEM、Raman光谱和NH3程序升温脱附等表征手段对载体和催化剂进行表征分析,并考察掺杂不同含量GO对催化剂加氢脱硫性能的影响。实验结果表明,当GO/TiO2(NF) 质量分数为0.5%时,复合载体的中强酸增加得最多,在温度280℃、氢气分压2.0 MPa、体积空速4 h-1,氢油体积比400相当温和条件下,对应的催化剂表现出优异的加氢脱硫性能。

关键词: 静电纺丝, TiO2纳米纤维, 氧化石墨, 加氢脱硫, 催化剂, 载体

CLC Number: