CIESC Journal ›› 2021, Vol. 72 ›› Issue (2): 1018-1025.DOI: 10.11949/0438-1157.20201294

• Catalysis, kinetics and reactors • Previous Articles     Next Articles

Study on catalytic degradation of PCDD/Fs over Mn-Ce-Co-Ox/PPS catalytic filter

LIU Honglei(),PENG Yaqi,TAO Junyi,TANG Minghui,LU Shengyong()   

  1. State Key Laboratory of Clean Energy Utilization, Zhejiang University, Hangzhou 310027, Zhejiang, China
  • Received:2020-09-09 Revised:2020-11-13 Online:2021-02-05 Published:2021-02-05
  • Contact: LU Shengyong

Mn-Ce-Co-Ox/PPS催化滤料催化降解气相二英的研究

刘红蕾(),彭亚旗,陶鋆奕,汤明慧,陆胜勇()   

  1. 浙江大学能源清洁利用国家重点实验室,浙江 杭州 310027
  • 通讯作者: 陆胜勇
  • 作者简介:刘红蕾(1996—),女,硕士研究生,21827050@zju.edu.cn
  • 基金资助:
    国家自然科学基金项目(51976192)

Abstract:

To decompose PCDD/Fs(polychlorinated dibenzo-p-dioxins and dibenzofurans) in flue gas, Mn-Ce-Co-Ox/PPS catalytic filter was prepared by in-situ oxidation method. The effect of catalyst loading on catalytic degradation of furan by Mn-Ce-Co-Ox/PPS catalytic filter was investigated. Furthermore, effect of operating temperature in the range of 140—200℃ on catalytic degradation of PCDD/Fs by Mn-Ce-Co-Ox/PPS catalytic filter was studied. Several physicochemical methods, including SEM(scanning electron microscope), EDS(energy dispersive spectroscopy) and XRD(X-ray diffraction) were employed to characterize the structure and properties of the composite catalytic filter. With the increase of catalyst loading from 81.8 g/m2 to 154.2 g/m2, degradation efficiency of furan by Mn-Ce-Co-Ox/PPS kept increasing, and the monolayer saturated loading of Mn-Ce-Co-Ox/PPS was 120.5 g/m2. Mn-Ce-Co-Ox/PPS catalytic filter can remove more than 90% of PCDD/Fs at 140—200℃. Degradation efficiencies of PCDD/Fs over Mn-Ce-Co-Ox/PPS showed a rapid growth with the increase of reaction temperature, achieving the highest of 78.01% at 200℃. The degradation efficiency of 17 dioxin homologs was analyzed, and it was found that the degradation rate of Mn-Ce-Co-Ox /PPS to low-chlorinated dioxin homologs was higher than that of high-chlorinated homologs.

Key words: in situ oxidation, catalytic filter, PCDD/Fs, degradation, pollution, waste management

摘要:

通过原位氧化法一步制备得到Mn-Ce-Co-Ox/PPS催化滤料,研究了催化剂负载量对Mn-Ce-Co-Ox/PPS催化降解呋喃的影响,进而分析了最优负载量的Mn-Ce-Co-Ox/PPS催化滤料在140~200℃对二英的催化降解规律,同时采用SEM、EDS和XRD等表征手段对复合催化滤料的结构及性能进行表征。结果如下:催化剂负载量由81.8 g/m2增加到154.2 g/m2,Mn-Ce-Co-Ox/PPS对呋喃的降解效率呈增加趋势,催化剂单层饱和负载量为120.5 g/m2。Mn-Ce-Co-Ox/PPS催化滤料在140~200℃对二英的脱除效率高达90%以上,降解效率随着反应温度升高而快速提升,200℃降解效率达到最高,为78.01%,表现出良好的催化降解性能。对17种二英同系物的降解效率进行分析,发现Mn-Ce-Co-Ox/PPS对低氯代二英同系物的降解率高于高氯代同系物的降解率。

关键词: 原位氧化法, 催化滤料, 二英, 降解, 污染, 废物处理

CLC Number: