流化床颗粒团聚物水分分布测量新技术

doi:10.3969/j.issn.0438-1157.2014.10.018

化工学报 ›› 2014, Vol. 65 ›› Issue (10): 3878-3883.DOI: 10.3969/j.issn.0438-1157.2014.10.018

流化床颗粒团聚物水分分布测量新技术

周云龙, 杨宁

东北电力大学能源与动力工程学院, 吉林省吉林市 132012

收稿日期:2014-03-17 修回日期:2014-05-08 出版日期:2014-10-05 发布日期:2014-10-05
通讯作者: 杨宁
基金资助:
国家自然科学基金项目（51276033）。

A new method for measuring moisture distribution in fluidized bed

ZHOU Yunlong, YANG Ning

School of Energy Resource and Power Engineering, Northeast Dianli University, Jilin 132012, Jilin, China

Received:2014-03-17 Revised:2014-05-08 Online:2014-10-05 Published:2014-10-05
Supported by:
supported by the National Natural Science Foundation of China (51276033).

摘要/Abstract

摘要： 在流化床中团聚物主要以宏观团聚物、微小团聚物、自由颗粒3种形式存在，通过TEB雾化喷嘴制造流化床颗粒团聚物，其中宏观团聚物沉积在流化床的底部位置，微小团聚物和自由颗粒均匀分布在整个流化床中。研究发现本文自主研制开发的多通道电导电路实验装置测量所得电导信号与流化床内水分含量存在线性比例的关系，利用流化床的持续流化效应造成团聚物破裂引发电导信号回升，实现了颗粒团聚物水分分布状态的测量。利用该装置测量了TEB雾化喷嘴气液比在0～4%范围内变化时流化床内颗粒及团聚物的水分分布状态，结果表明随着气液比的增加，微小团聚物、自由颗粒所包含的水分有所增加，宏观团聚物所包含的水分有所减小，即使在气液比增加到4%时，大量的水分仍然被宏观团聚物所吸收。

关键词: 电导信号, 团聚物, 破裂, 水分, 流化床

Abstract: Mainly three groups exist in the fluidized bed: macro-agglomerates, micro-agglomerates, and free-particles. Agglomerates were generated by using TEB nozzles. Macro-agglomerates were distributed at the bottom of the fluidized bed, while micro-agglomerates and free-particles were uniformly distributed in the fluidized bed. The conductance signals measured by the self-developed multi-channel conductance electrical circuit experimental device showed linear relationship with moisture content inside the fluidized bed. Conductance signal was recovered under the influence of agglomerates breakup by continuous fluidization, so that measurement of moisture distribution could be implemented. Measurement of moisture distribution with TEB atomization nozzle gas liquid ratio in the range of 0-4% indicated that with the increase of gas liquid ratio, the moisture content in the micro-agglomerates and free-particles increased, while the moisture content in the macro-agglomerates decreased. But even when gas liquid ratio increased to 4%, most of the moisture content still existed in the macro-agglomerates.

Key words: conductance signal, agglomerates, fracture, moisture content, fluidized bed

中图分类号:

TK121

周云龙, 杨宁. 流化床颗粒团聚物水分分布测量新技术[J]. 化工学报, 2014, 65(10): 3878-3883.

ZHOU Yunlong, YANG Ning. A new method for measuring moisture distribution in fluidized bed[J]. CIESC Journal, 2014, 65(10): 3878-3883.

参考文献 15

[1]	Boduszynski M M, Grudoski D A, Rechesteiner C E, Iwamoto J D.Deep-cut assay reveals additional yield of high-value VGO [J]. Oil and Gas Journal, 1995, 93(37): 39-45
[2]	Chung H K, Xu C M, Hu Y X.Supereritical fluid extraction reveals resid properties [J]. Oil and Gas Journal, 1997, 95(3): 66-69
[3]	Zhang X B. Study on FCC gasoline deep catalytic cracking [D]. Shandong: China University of Petroleum, 2007: 1-23
[4]	Li Qiang(李强), Wang Lei(王雷), Zhang Qihao(张琪皓), Luo Guohua(罗国华), Wei Fei(魏飞). Heavy oil deep catalytic cracking process in downer reactor to produce light olefins [J]. Journal of Chemical Industry and Engineering(China)(化工学报), 2004, 55(7): 1103-1108
[5]	Dougall S M, Saberian M, Briens C.Using dynamic pressure signals to assess the effects of injected liquid on fluidized bed properties [J]. Chemical Engineering and Processing, 2005, 44(7): 701-708
[6]	Jennifer M, Cedric B, Franco B. Flow stability in a downer mixing chamber [J]. Chemical Engineering and Processing, 2006, 45(9): 798-805
[7]	Maryam M, Majid H, Cedric B. The effects of liquid properties and bed hydrodynamics on the distribution of liquid on solid fluidized particles in a cold-model fluidized bed [J]. Powder Technology, 2014, 256: 5-12
[8]	Stefan H, Jan B, Markus H, Matthias I, Mirko P, Lothar M. Study of dynamic multi-dimensional temperature and concentration distribution in liquid-sprayed fluidized beds [J]. Chemical Engineering Science, 2003, 23(58): 5135-5160
[9]	Flora P, Cedric B, Franco B, Jennifer M M. Effect of particle size,liquid content and location on the stability of agglomerates in a fluidized bed [J]. Powder Technology, 2013, 237: 376-385
[10]	Stefan B, Joachim W. An investigation of the mechanism of liquid injection into fluidized beds [J]. AIChE Journal, 2005, 51(3): 766-775
[11]	Korina T, Mirko P, Evangelos T.Kinetics of fluidized bed apray agglomeration for compact and porous particles [J]. Chemical Engineering Science, 2011, 66(9): 1866-1878
[12]	Mills P J T, Seville J P K, Knight P C K, Adams M J.The effect of binder viscosity on particle agglomeration in a low shear mixer/agglomerator [J]. Powder Technology, 2000, 113(1): 140-147
[13]	Saad M M, Barkouti A, Rondet E, Ruiz T, Cuq B. Study of agglomeration mechanisms of food powders: application to durum wheat semolina [J]. Powder Technology, 2011, 208(2): 399-408
[14]	Thomas A, Anette S, Torben S. The effect of droplet size and powder particle size on the mechanisms of nucleation and growth in the fluid bed melt agglomeration [J]. International Journal of Pharmaceutics, 2002, 249(1): 185-197
[15]	Terence E B, Edward W C, Douglas A E, Kennett R D.Nozzle for atomizing liquid in two phase flow[P]: US, 6003789.1999-12-21[16] Steven L M, Mohammad S, Cedric B, Franco B, Edward W C. Characterization of fluidization quality in fludized beds of wet particles [J]. International Journal of Chemical Reactor Engineering, 2004, 2(1): 1542-6580

流化床颗粒团聚物水分分布测量新技术

A new method for measuring moisture distribution in fluidized bed

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 15

相关文章 15

编辑推荐

Metrics

本文评价

[1]	杨峥豪, 何臻, 常玉龙, 靳紫恒, 江霞. 生物质快速热解下行式流化床反应器研究进展[J]. 化工学报, 2023, 74(6): 2249-2263.
[2]	陈巨辉, 张谦, 舒崚峰, 李丹, 徐鑫, 刘晓刚, 赵晨希, 曹希峰. 基于DEM方法的旋转流化床纳米颗粒流动特性研究[J]. 化工学报, 2023, 74(6): 2374-2381.
[3]	张媛媛, 曲江源, 苏欣欣, 杨静, 张锴. 循环流化床燃煤机组SNCR脱硝过程气液传质和反应特性[J]. 化工学报, 2023, 74(6): 2404-2415.
[4]	袁子涵, 王淑彦, 邵宝力, 谢磊, 陈曦, 马一玫. 基于幂律液固曳力模型流化床内湿颗粒流动特性的研究[J]. 化工学报, 2023, 74(5): 2000-2012.
[5]	廖艺, 牛亚宾, 潘艳秋, 俞路. 复配表面活性剂对油水界面行为和性质影响的模拟研究[J]. 化工学报, 2022, 73(9): 4003-4014.
[6]	马语峻, 刘向军. 多孔陶瓷膜烟气水分回收理论与模型研究[J]. 化工学报, 2022, 73(9): 4103-4112.
[7]	王凯玥, 马永丽, 李琛, 刘明言. 气液固微型流化床的气液传质系数[J]. 化工学报, 2022, 73(8): 3529-3540.
[8]	朱莲峰, 王超, 张梦娟, 刘方正, 贾鑫, 安萍, 许光文, 韩振南. 水蒸气/氧流化床两段煤气化制备低焦油合成气工艺实验[J]. 化工学报, 2022, 73(8): 3720-3730.
[9]	张东旺, 杨海瑞, 周托, 黄中, 李诗媛, 张缦. 生物质锅炉对流受热面积灰冷态模拟实验研究[J]. 化工学报, 2022, 73(8): 3731-3738.
[10]	刘新华, 韩振南, 韩健, 梁斌, 张楠, 胡善伟, 白丁荣, 许光文. 基于热解与燃烧反应重构的低NO _x 解耦燃烧原理与技术[J]. 化工学报, 2022, 73(8): 3355-3368.
[11]	王刚, 夏志豪, 李希艳, 张虹, 韩振南, 宋兴飞, 许光文. 不同气氛下流化床菱镁矿轻烧产物特性研究[J]. 化工学报, 2022, 73(8): 3699-3707.
[12]	牛犁, 刘梦溪, 王海北. 密相流化床中介尺度流动结构的流体力学特性研究[J]. 化工学报, 2022, 73(6): 2622-2635.
[13]	范小强, 黄正梁, 孙婧元, 王靖岱, 王晓飞, 胡晓波, 韩国栋, 阳永荣, 吴文清. 气液法流化床乙烯云聚合工艺开发及产品高性能化[J]. 化工学报, 2022, 73(6): 2742-2747.
[14]	马永丽, 刘明言, 胡宗定. 气液固流化床流动介尺度模型研究进展[J]. 化工学报, 2022, 73(6): 2438-2451.
[15]	李铁男, 赵碧丹, 赵鹏, 张永民, 王军武. 气固流化床启动阶段挡板内构件受力特性的CFD-DEM模拟[J]. 化工学报, 2022, 73(6): 2649-2661.