化工学报 ›› 2013, Vol. 64 ›› Issue (3): 1076-1083.DOI: 10.3969/j.issn.0438-1157.2013.03.041

• 能源和环境工程 • 上一篇    下一篇

活性焦汞吸附特性及动力学机理分析

张海茹, 吴昊, 刘浩, 王萌, 杨宏旻   

  1. 南京师范大学能源与机械工程学院,江苏 南京 210042
  • 收稿日期:2012-06-05 修回日期:2012-11-23 出版日期:2013-03-05 发布日期:2013-03-05
  • 通讯作者: 杨宏旻
  • 作者简介:张海茹(1982—),女,硕士研究生。
  • 基金资助:

    国家自然科学基金项目(50976049);江苏省自然科学基金项目(BK2011788)。

Performance and kinetics of mercury adsorption over Tai-Xi activated coke

ZHANG Hairu, WU Hao, LIU Hao, WANG Meng, YANG Hongmin   

  1. School of Energy and Mechanical Engineering, Nanjing Normal University, Nanjing 210042, Jiangsu, China
  • Received:2012-06-05 Revised:2012-11-23 Online:2013-03-05 Published:2013-03-05
  • Supported by:

    supported by the National Natural Science Foundation of China(50976049)and the Natural Science Foundation of Jiangsu Province(BK2011788).

摘要: 通过固态吸附剂汞吸附效能测定系统进行了太西活性焦吸附单质汞的实验,考察单质汞Hg0入口浓度和温度对太西活性焦脱汞性能的影响并探讨了吸附机理。结果表明:在CO2/N2/O2/NO/Hg0体系中,不同Hg0入口浓度获得的汞脱除效率曲线相似,脱除效率随Hg0入口浓度增大而增加;变入口浓度工况下,汞的吸附全过程遵循准二级动力学反应模型,该吸附过程以化学吸附为主;在反应温度从403 K升高到423 K的过程中,系统发生了化学吸附或者化学反应,423 K可作为活性焦的最佳除汞温度;Bangham方程可对变温工况下活性焦脱除单质汞的吸附过程进行准确描述,并获得不同温度下活性焦脱汞的吸附速率常数存在k423K>k463K>k403K的关系。

关键词: 活性焦, 温度, 单质汞入口浓度, 吸附机理, 除汞

Abstract: The tests of mercury adsorption on Tai-Xi activated coke were conducted in an adsorption system of fixed-bed reactor.The effect of inlet mercury concentration and temperature on adsorption efficiency(removal of mercury)was studied using a simulated flue gas that was prepared by mixing flue gas component CO2,N2,O2,NO and Hg0 vapors came from a permeation tube.The results show that there is similar shape of adsorption curve for different initial mercury concentrations and efficiency of mercury removal increases with increase of inlet mercury concentration.The initial port of breakthrough curve shows that the adsorption rate is rapid,then slow and slow until to adsorption saturation.The uptake process of mercury by activated coke can be well fitted by a pseudo-second order kinetics model,indicating that for CO2/N2/O2/NO/Hg0 system,the adsorption of mercury on the activated coke takes mainly place by chemical adsorption or chemical reaction.The optimal temperature is 423 K for the best mercury removal.The Bangham equation can be applied to describe the adsorption behavior at different operation temperature,and the adsorption rate constants at different temperature follow as k423K>k463K>k403K.

Key words: activated coke, temperature, inlet concentration of Hg0, adsorption mechanism, mercury removal

中图分类号: