蒸发温度对水平正反齿压花齿型肋管池沸腾换热的影响

doi:10.11949/j.issn.0438-1157.20151641

摘要/Abstract

摘要：

随着节能减排的大力推广,管外沸腾强化传热技术得到了广泛的研究和发展。设计建立了水平双侧强化管管外沸腾试验系统,以R134a为循环工质试验研究了不同热通量工况下,蒸发温度对正反齿压花齿型三维肋管池沸腾换热特性影响,并结合试验结果分析探讨了其理论描述方法。结果表明:蒸发传热系数随蒸发温度变化趋势线的斜率随热通量呈现非线性变化;在同一蒸发温度下,管表面传热系数均随热通量单调递增,但增长率随热通量增加而逐步降低;回归分析获得不同热通量下蒸发温度对正反齿压花齿型蒸发管表面传热系数影响的统一表达式;等热通量工况强化传热因子在热通量超过10kW·m^-2后升至2以上,在热通量接近20kW·m^-2时达到极大值2.588,但在热通量接近5kW·m^-2时接近1;蒸发温度及其与热通量合同对正反齿压花齿型蒸发管表面传热系数的作用机理与理论描述方法有待进一步深入研究。

关键词: 强化管, 沸腾, 蒸发温度, 水平管, 传热系数

Abstract:

Under a promotion of energy conservation and emission reduction, efforts on research and development of the technologies related to boiling heat transfer enhancement of outer tube have been conducted extensively. In this article, a testing system for boiling heat transfer outside the horizontal double-side enhanced tubes was established. Using R134a as a cyclic working medium, the effect of evaporation temperature on the characteristics of boiling heat transfer in three-dimensional ribbed and embossing finned tube under conditions of varied heat flux was investigated, on basis of which theoretical descriptive method was discussed. It showed that, the curve slope of evaporation heat transfer coefficient as a function of evaporation temperature is non-linearly related to the heat flux. At the same evaporation temperature, it shows a monotonic increase in the heat transfer coefficient on tube surface with the heat flux, of which the slope gradually decreases with the heat flux. By means of regression analysis, an unified formula for the heat transfer coefficient on ribbed and embossing finned tube surface as a function of evaporation temperature under conditions of varied heat flux was achieved. Under operation condition of the same heat flux, the factor of heat transfer enhancement approaches 1, exceeds 2, and reaches the maximum 2.588 at 5, 10 and 20 kW·m^-2 of heat flux, respectively. The mechanism and theoretic description of the heat transfer coefficient on ribbed and embossing finned tube surface as functions of evaporation temperature and heat flux, need to be further studied.

Key words: enhanced tube, boiling, evaporation temperature, horizontal tube, heat transfer coefficient

中图分类号:

TK124

张吉礼, 陈敬东, 马志先, 王永辉. 蒸发温度对水平正反齿压花齿型肋管池沸腾换热的影响[J]. 化工学报, 2016, 67(6): 2230-2238.

ZHANG Jili, CHEN Jingdong, MA Zhixian, WANG Yonghui. Effect of evaporation temperature on boiling heat transfer in horizontal ribbed and embossing finned tube pool[J]. CIESC Journal, 2016, 67(6): 2230-2238.

参考文献 27

[1]	PIORO I L, ROHSENOW W, DOERFFER S S. Nucleate pool boiling heat transfer(Ⅰ): Review of parametric effects of boiling surface [J]. International Journal of Heat and Mass Transfer, 2004, 47(23): 5033-5044. DOI:10.1016/j.ijheatmasstransfer.2004.06.019.
[2]	张定才, 田松娜, 冀文涛,等. R417A在水平双侧强化管外沸腾换热研究 [J]. 制冷学报, 2014, 35(3): 114-118. ZHANG D C, TIAN S N, JI W T, et al. Study of boiling heat transfer of R417A on horizontal doubly-enhanced tubes [J].Journal of Refrigeration, 2014, 35(3): 114-118. DOI:10.3969/j.issn.0253-4339. 2014.03.114.
[3]	杨少华, 王世平, 高学农. CFCS替代工质R134a、R142b在水平管外池沸腾传热与强化 [J]. 制冷学报, 1997, (3): 6-10. YANG S H, WANG S P, GAO X N. Nucleate pool boiling heat transfer and enhancement of R134a and R142b on horizontal tube [J]. Journal of Refrigeration, 1997, (3): 6-10. DOI:10.3969/j.issn. 0253-4339.1997.
[4]	刘启斌, 何雅玲, 张定才,等. R22在水平双侧强化管外池沸腾换热 [J]. 化学工程, 2008, 36(4): 12-16. LIU Q B, HE Y L, ZHANG D C, et al. Boiling heat transfer of R22 outside single horizontal doubly-enhanced tubes [J]. Chemical Engineering(China), 2008, 36(4): 12-16.
[5]	费继友, 张定才, 李连生. R134a中润滑油对强化管外池沸腾传热影响的实验研究 [J]. 西安交通大学学报, 2008, 42(5): 519-523. FEI J Y, ZHANG D C, LI L S. Experimental study on pool boiling heat transfer of R134a-oil mixture outside single horizontal enhanced tubes [J]. Journal of Xi'an Jiaotong University, 2008, 42(5): 519-523.
[6]	ZHANG B J, KIM K J. Nucleate pool boiling heat transfer augmentation on hydrophobic self-assembly mono-layered alumina nano-porous surfaces [J]. International Journal of Heat and Mass Transfer, 2014, 73: 551-561. DOI: 10.1016/j.ijheatmasstransfer. 2014.02.032.
[7]	JO H J, AHN H S, KANG S H, et al. A study of nucleate boiling heat transfer on hydrophilic, hydrophobic and heterogeneous wetting surfaces [J]. International Journal of Heat and Mass Transfer, 2011, 54(25): 5643-5652. DOI: 10.1016/j.ijheatmasstransfer.2011.06.001.
[8]	张定才, 朱春洁, 张振, 等. R134a/R125 混合工质管外沸腾换热特性研究 [J]. 制冷技术, 2014, 42(7):54-59. ZHANG D C, ZHU C J, ZHANG Z, et al. Characteristic of boiling heat transfer of mixed refrigerant over horizontal tube [J]. Refrigeration, 2014, 42(7):54-59.
[9]	LEE Y, GYU D, KIM J H, JUNG D. Nucleate boiling heat transfer coefficients of HFO1234yf on various enhanced surfaces [J]. International Journal of Refrigeration, 2014, 38:198-205. DOI: 10.1016/j.ijrefrig.2013.09.014.
[10]	SUN Z H, GONG M Q, LI Z J, et al. Nucleate pool boiling heat transfer coefficients of pure HFC134a, HC290, HC600a and their binary and ternary mixtures [J]. International Journal of Heat and Mass Transfer, 2007, 50(1): 94-104. DOI: 10.1016/j. ijheatmasstransfer.2006.06.041.
[11]	NAE H K, EUL J L, HO W B. Pool boiling of R-134a/oil mixtures on enhanced tubes having different pore and gap sizes [J]. International Journal of Heat and Mass Transfer,2013, 66: 118-127. DOI: 10.1016/j.ijheatmasstransfer.2013.07.016.
[12]	EVRAAM G, STEVEN E. Local heat transfer coefficient for pool boiling of R-134a and R-123 on smooth and enhanced tubes [J]. International Journal of Heat and Mass Transfer, 2012, 55(11): 3021-3028. DOI: 10.1016/j.ijheatmasstransfer.2012.02.012.
[13]	刘启斌, 何雅玲, 张定才, 等. R123在水平双侧强化管外池沸腾换热 [J]. 化工学报, 2006, 57(2): 251-257. LIU Q B, HE Y L, ZHANG D C, et al. Boiling heat transfer of R123 outside single horizontal doubly-enhanced tubes [J]. Journal of Chemical Industry and Engineering(China), 2006, 57(2): 251-257.
[14]	JUNG D, LEEB H, BAE D, et al. Nucleate boiling heat transfer coefficients of flammable refrigerants on various enhanced tubes [J]. International Journal of Refrigeration, 2005, 28(3): 451-455. DOI: 10.1016/j.ijrefrig.2004.07.024.
[15]	HUBNER P, KUNSTLER W. Pool boiling heat transfer at finned tubes: influence of surface roughness and shape of the fins [J]. International Journal of Refrigeration, 1997, 20(8): 575-582. DOI: 10.1016/S0140-7007(97)00033-9.
[16]	李东明, 费继友, 张定才. 含油R134a水平强化管外池沸腾换热实验研究 [J]. 工程热物理学报, 2011, 32(2): 269-272. LI D M, FEI J Y, ZHANG D C. Experimental study on pool boiling heat transfer of R134a-oil mixture outside single horizontal enhanced tubes [J]. Journal of Engineering Thermophysics, 2011, 32(2): 269-272.
[17]	RIBATSKI G, THOME J R. Nucleate boiling heat transfer of R134a on enhanced tubes [J]. Applied Thermal Engineering, 2006, 26(10):1018-1031.DOI: 10.1016/j.applthermaleng.2005.09.021.
[18]	刘文毅, 李妩, 陶文铨. 强化管外R123水平强化单管外池沸腾换热实验研究 [J]. 制冷学报, 2005, 26(4): 30-34. LIU W Y, LI W, TAO W Q. Experimental investigation on the pool boiling heat transfer characteristics of R123outside single horizontal tubes [J]. Journal of Refrigeration, 2005, 26(4): 30-34. DOI:10.3969/j.issn.0253-4339.2005.10.030.
[19]	WEBB R L, PAIS C. Nucleate pool boiling data for five refrigerants on plain, integral-fin and enhanced tube geometries [J]. International Journal of Heat and Mass Transfer, 1992, 35(8): 1893-1904. DOI: 10.1016/0017-9310(92)90192-U.
[20]	欧阳新萍, 包琳琳, 邱雪松. 蒸发温度对强化换热管管外核态池沸腾换热性能的影响[J] 制冷学报, 2015, 36(1): 97-100. OUYANG X P, BAO L L, QIU X S. Effects of evaporation temperature on nucleate pool boiling heat transfer characteristics outside the enhanced tube [J]. Journal of refrigeration, 2015, 36(1): 97-100. DOI:10.3969/j.issn.0253-4339.2015.01.097.
[21]	马志先.水平管束外膜状凝结换热试验与理论研究[D]. 哈尔滨: 哈尔滨工业大学, 2012:52-54. MA Z X. Experiment and theory of film condensation heat transfer on horizontal tube bundle[D]. Harbin: Harbin Institute of Technology, 2012: 52-54.
[22]	王玉晗, 周金伟, 周浩平. 国内高效换热铜管传热性能研究现状[C]//中国有色金属加工装备技术论坛. 2011: 323-328. WANG Y H, ZHOU J W, ZHOU H P. Present state on domestic highly efficient heat exchange copper tube[C]//China Nonferrous Metals Process Equipment Technology Forum. 2011: 323-328.
[23]	SEARA J F, UHIA F J, SIERES J T, et al. A general review of the Wilson plot method and its modifications to determine convection coefficients in heat exchange devices [J]. Applied Thermal Engineering, 2007, 27(17): 2745-2757. DOI: 10.1016/j. applthermaleng.2007.04.004.
[24]	杨世铭, 陶文铨. 传热学[M]. 北京: 高等教育出版社, 2006. YANG S M, TAO W Q. Heat Transfer[M]. Beijing: Higher Education Press, 2006.
[25]	COOPER M G. Saturation nucleate pool boiling-a simple correlation [J]. The Institution of Chemical Engineers Symposium Series, 1984, 2(86): 785-793. DOI: 10.1016/B978-0-85295-175-0.50013-8.
[26]	ROSE J W. An approximate equation for the vapour-side heat transfer coefficient for condensation on low-finned tubes [J]. International Journal of Heat and Mass Transfer, 1994, 37(5): 865-875. DOI: 10.1016/0017-9310(94)90122-8.
[27]	BRIGGS A, ROSE J W. Effect of fin efficiency on a model for condensation heat transfer on a horizontal integral-fin tube [J]. International Journal of Heat and Mass Transfer, 1994, 37(1): 457-463. DOI: 10.1016/0017-9310(94)90045-0.