化工学报 ›› 2019, Vol. 70 ›› Issue (3): 1152-1162.DOI: 10.11949/j.issn.0438-1157.20180995

• 材料化学工程与纳米技术 • 上一篇    下一篇

乳液法制备聚乙烯醇-石墨烯气凝胶及其对纯有机物的吸附

王振有(),刘会娥(),朱佳梦,陈爽,于安然   

  1. 1. 中国石油大学(华东)重质油国家重点实验室,山东 青岛 266580
  • 收稿日期:2018-09-07 修回日期:2018-12-10 出版日期:2019-03-05 发布日期:2019-03-05
  • 通讯作者: 刘会娥
  • 作者简介:<named-content content-type="corresp-name">王振有</named-content>(1993—),男,硕士研究生,<email>upc_wzy@163.com</email>|刘会娥(1972—),女,博士,教授,<email>liuhuie@upc.edu.cn</email>
  • 基金资助:
    山东省自然科学基金项目(ZR2017MB015);中国石油科技创新基金项目(2017D-5007-0601);重质油国家重点实验室资助项目(SLKZZ-2017002)

Preparation of polyvinyl alcohol-graphene aerogel by emulsion method and its adsorption on pure organics

Zhenyou WANG(),Hui’e LIU(),Jiameng ZHU,Shuang CHEN,Anran YU   

  1. 1. State Key Laboratory of Heavy Oil Processing, China University of Petroleum, Qingdao 266580, Shandong, China
  • Received:2018-09-07 Revised:2018-12-10 Online:2019-03-05 Published:2019-03-05
  • Contact: Hui’e LIU

摘要:

采用氧化石墨烯(GO)稳定的Pickering乳液为软模板,制备聚乙烯醇-石墨烯气凝胶。探究GO浓度、均质转速、油水比、乙二胺(EDA)和聚乙烯醇(PVA)用量等因素对乳液稳定性、粒径分布及气凝胶成型的影响,发现改变乳液配比可控制乳液粒径的大小,进而对气凝胶的密度和孔隙率进行调控。通过SEM、FT-IR、Raman、XRD对最优制备条件下制得的聚乙烯醇-石墨烯气凝胶(PGA)进行表征,可知GO经水热反应后被还原组装形成三维网络气凝胶结构(PGA)且其孔道直径与乳液粒径基本一致。对PGA进行挤压实验发现其具有轴、径双向挤压回弹性,且重复挤压200次以上PGA仍然具良好的弹性。PGA对纯有机物的吸附量最高可达280 g·g?1,且每克PGA吸附的有机物的体积为恒定值。

关键词: 聚乙烯醇, 石墨烯, 气凝胶, 乳液, 弹性, 复合材料

Abstract:

A polyvinyl alcohol-graphene aerogel was prepared by using a graphene oxide (GO)-stabilized Pickering emulsion as a soft template. The effects of GO concentration, homogenization speed, oil/water ratio, the amount of ethylenediamine (EDA) and polyvinyl alcohol (PVA) on the stability, particle size distribution of the emulsion and the formation of aerogel were investigated. It was found that the drop size of the emulsion could be controlled by changing the emulsion composition ratio. Then, the density and porosity of the aerogel also could be controlled. The polyvinyl alcohol-graphene aerogel (PGA) prepared under optimal preparation conditions was characterized by SEM, FT-IR, Raman and XRD. It was found that GO had been reduced and assembled to form a three-dimensional network structure (PGA) after the hydrothermal reaction and the pore size of the PGA was substantially the same as the particle size of the emulsion. The extrusion test of PGA was carried out and it was observed that PGA had both longitudinal and lateral bidirectional extrusion resilience. And the PGA still had good elasticity after more than 200 times repeated extrusion. The adsorption amount of pure organics by PGA was up to 280 g·g?1, and the volume of organics adsorbed per gram of PGA was constant value.

Key words: polyvinyl alcohol, graphene, aerogel, emulsions, elasticity, composites

中图分类号: