CIESC Journal ›› 2021, Vol. 72 ›› Issue (4): 2057-2064.DOI: 10.11949/0438-1157.20200915

• Fluid dynamics and transport phenomena • Previous Articles     Next Articles

Study on phase distribution characteristics of gas-liquid two-phase flow in micro-channel flat T-junction

XU Xiaoxiao1(),ZHANG Shijie1,LI Yi1,2,LIU Chao1   

  1. 1.Key Laboratory of Low-grade Energy Utilization Technologies and Systems, Ministry of Education, College of Energy and Power Engineering, Chongqing University, Chongqing 400030, China
    2.Hisense Kelon Electrical Holdings Company Limited, Foshan 528303, Guangdong, China
  • Received:2020-07-07 Revised:2020-09-26 Online:2021-04-05 Published:2021-04-05
  • Contact: XU Xiaoxiao

制冷剂在微通道扁平T型管内的气液两相流相分配特性研究

徐肖肖1(),张世杰1,李怡1,2,刘朝1   

  1. 1.重庆大学能源与动力工程学院,低品位能源利用技术及系统教育部重点实验室,重庆 400030
    2.海信家电集团股份有限公司,广东 佛山 528303
  • 通讯作者: 徐肖肖
  • 作者简介:徐肖肖(1980—),女,博士,教授,xuxiaoxiao@cqu.edu.cn
  • 基金资助:
    国家自然科学基金项目(51776020);中央高校基本科研业务费专项资金(2019CDQYDL035)

Abstract:

The phase distribution characteristics of gas-liquid two-phase flow in conventional T-junction have been fully studied, but few literatures have paid attention to the distribution characteristics of two-phase flow in micro-channel flat T-junction. Using the two-phase refrigerant R134a as the working fluid, the phase distribution characteristics in the flat T-junction are studied experimentally. The results show that the increase of the liquid-phase inlet flow rate of the two-phase flow in the flat T-junction will decrease the liquid-phase separation ratio and increase the gas-phase separation ratio. The increase of the inlet quality will increase the liquid-phase separation ratio and decrease the gas-phase separation ratio. The gas inlet velocity has little effect on the phase distribution of the bubbly flow in the flat T-junction. It can be seen from the comparison between the predicted phase distribution model and the experimental value that the existing phase distribution model cannot accurately predict the gas-liquid separation ratio of the bubbly flow in the flat T-junction. In the experimental conditions, when the inlet dryness is 0.45—0.5, the refrigerant R134a in the flat T-junction has a relatively uniform gas and liquid distribution.

Key words: two-phase flow, phase distribution characteristics, flat tube, T-junction tube, micro-channel, gas-liquid separation ratio

摘要:

气液两相流在常规T型管内的相分配特性已得到充分研究,但少有文献关注微通道扁平T型管内的两相流分配特性。以两相制冷剂R134a为工质,对扁平T型管内的相分配特性进行了实验研究。实验结果表明,气液两相流在扁平T型管内的液相进口流速增加会使液相分离比减小,气相分离比增大;进口干度增加使液相分离比增大,气相分离比减小;气相进口流速对扁平T型管内泡状流的相分配影响较小。由相分配模型预测值与实验值对比可知,现有的相分配模型还无法准确预测扁平T型管内泡状流的气液相分离比。在进口干度为0.45~0.5时扁平T型管内制冷剂R134a气液相分配比较均匀。

关键词: 两相流, 相分配特性, 扁平管, T型管, 微通道, 气液相分离比

CLC Number: