CIESC Journal ›› 2018, Vol. 69 ›› Issue (6): 2586-2593.DOI: 10.11949/j.issn.0438-1157.20171393

Previous Articles     Next Articles

pH optimization and control in iron removal process of multi-reactor cascade

LI Yonggang1, MA Lei1, WU Tiebin1,2, ZHU Hongqiu1, YANG Chunhua1   

  1. 1. School of Information Science and Technology, Central South University, Changsha 410038, Hunan, China;
    2. School of Energy and Electrical Engineering, Hunan University of Humanities, Science and Technology, Loudi 417000, Hunan, China
  • Received:2017-10-18 Revised:2018-01-30 Online:2018-06-05 Published:2018-06-05
  • Supported by:

    supported by the National Natural Science Foundation of China(61673400, 61773403), the Natural Science Foundation of Hunan Province(2016JJ3079) and the Foundation for Innovative Research Groups of the National Natural Science Foundation of China (61621062).

多反应器级联的沉铁过程pH优化控制

李勇刚1, 马蕾1, 伍铁斌1,2, 朱红求1, 阳春华1   

  1. 1. 中南大学信息科学与工程学院, 湖南 长沙 410038;
    2. 湖南人文科技学院能源与机电工程学院, 湖南 娄底 417000
  • 通讯作者: 伍铁斌
  • 基金资助:

    国家自然科学基金项目(61673400,61773403);湖南省自然科学基金项目(2016JJ3079);国家自然科学基金创新研究群体科学基金项目(61621062)。

Abstract:

It is difficult to optimize and control pH in iron removal process, due to multi-reactor cascade, delayed detection of ionic concentration, and frequent change of working conditions. A pH optimization control method was proposed for iron removal process of a multi-reactor cascade. This method set pH in each reactor of the cascade according to classification of inlet conditions and amount of oxygen change. Two key factors, i.e. pH and ferrous ion concentration, were used to establish calcine consumption model by chemical reaction mechanism and process material balance. Considered effects of both complex mechanism and delayed detection of ion concentration on accurate addition of calcine, oxidation-reduction potential (ORP) was introduced and combined with pH to build a modified fuzzy model of calcine consumption. Simulation results show effectiveness of the method, which creates foundation for stable operation of amphibolite iron removal process.

Key words: iron removal process, calcine, ORP, pH setpoint, fuzzy rule, process systems, optimization, control

摘要:

针对沉铁过程多反应器级联、离子浓度检测滞后及工况变化频繁导致pH优化控制困难的问题,提出了一种基于多反应器级联的沉铁过程pH优化控制方法。该方法基于入口工况划分与氧气变化量预设定各个级联反应器的pH,并针对影响焙砂添加量的两个主要因素:pH和亚铁离子浓度,建立了基于沉铁过程化学反应机理和物料平衡的焙砂添加量模型;考虑到沉铁过程机理复杂及离子浓度检测滞后影响焙砂的准确添加,引入了氧化还原电位(oxidation-reduction potential,ORP),并提出一种基于ORP和pH变化量的焙砂模糊修正模型。仿真结果证明了该方法的有效性,为针铁矿法沉铁过程的稳定运行创造了条件。

关键词: 沉铁过程, 焙砂, ORP, pH设定值, 模糊规则, 过程系统, 优化, 控制

CLC Number: