化工学报 ›› 2015, Vol. 66 ›› Issue (11): 4446-4451.DOI: 10.11949/j.issn.0438-1157.20150570

• 催化、动力学与反应器 • 上一篇    下一篇

MA/EG与TBPA/EG聚酯化反应动力学

孔明华, 伍联营, 徐显朕, 胡仰栋   

  1. 中国海洋大学化学化工学院, 山东 青岛 266100
  • 收稿日期:2015-05-06 修回日期:2015-06-15 出版日期:2015-11-05 发布日期:2015-11-05
  • 通讯作者: 胡仰栋
  • 基金资助:

    国家自然科学基金项目(21376231)。

Kinetics of polyesterification: ethylene glycol with maleic anhydride and tetrabromo phthalic anhydride

KONG Minghua, WU Lianying, XU Xianzhen, HU Yangdong   

  1. School of Chemistry and Chemical Engineering, Ocean University of China, Qingdao 266100, Shandong, China
  • Received:2015-05-06 Revised:2015-06-15 Online:2015-11-05 Published:2015-11-05
  • Supported by:

    supported by the National Natural Science Foundation of China (21376231).

摘要:

通过熔融缩聚反应对马来酸酐/乙二醇(MA/EG)和四溴邻苯二甲酸酐/乙二醇(TBPA/EG)两个聚酯化反应的动力学进行研究。考察了自催化条件下反应温度、原料配比对聚酯化反应速率的影响。在陈寿安模型的基础上,对反应级数的不同组合进行了比较研究。结果表明:1-1模型和实验结果吻合良好,且kh[H2O]为正值;温度越高,醇酸配比越大,则聚合反应程度越大。

关键词: 动力学模型, 聚合, 酯化, 四溴邻苯二甲酸酐, 马来酸酐

Abstract:

Polyesterifications of ethylene glycol (EG) with maleic anhydride (MA) and tetrabromo phthalic anhydride (TBPA) without foreign acid were carried out under constant reaction temperatures of 162—192℃ (rather than at the constant oil-bath temperature) and at different molar ratios of diol to diacid of 1.2—1.8 (MA/EG). The different combinations of the reaction order on the basis of Show-an Chen model were discussed. 1-1 model can describe experimental results very well, and kh[H2O] was greater than zero. The reaction rate constants for both systems were calculated. Besides, It was found that the final COOH conversion was increased with increasing reaction temperatures and molar ratios of diol to diacid.

Key words: kinetics modeling, polymerization, esterification, tetrabromo phthalic anhydride, maleic anhydride

中图分类号: