CIESC Journal ›› 2014, Vol. 65 ›› Issue (2): 679-683.DOI: 10.3969/j.issn.0438-1157.2014.02.044

Previous Articles     Next Articles

Experimental research and process simulation on biomass fast pyrolysis for production of bio-oil

WANG Chao1,2, CHEN Guanyi1, LAN Weijuan1, MA Wenchao1   

  1. 1 Faculty of Environment Science and Engineering, Tianjin University, Tianjin 300072, China;
    2 Sinopec Engineering Incorporation, Beijing 100101, China
  • Received:2013-05-01 Revised:2013-06-03 Online:2014-02-05 Published:2014-02-05
  • Supported by:

    supported by the National Natural Science Foundation of China (51036006, 51076158).

生物质快速热解制油试验及流程模拟

王超1,2, 陈冠益1, 兰维娟1, 马文超1   

  1. 1 天津大学环境科学与工程学院, 天津 300072;
    2 中国石化工程建设有限公司, 北京 100101
  • 通讯作者: 陈冠益
  • 基金资助:

    国家自然科学基金项目(51036006,51076158)。

Abstract: The experimental research of biomass pyrolysis for production of bio-oil is performed with a fluidized bed reactor designed by ourselves. By analysis of desired products collected at different temperature 450, 500, 525, 550, 580, 610℃, influence of reaction temperature on the yield of bio-oil is investigated in this paper. The results show that the highest yield of bio-oil is 42.5%(mass) received around 550℃, while gas yield is 37.7%(mass), gas components are mainly CO, CO2, CH4, H2. On the basis of the experiment, using Aspen Plus software for process simulation a biomass fast pyrolysis model for production of bio-oil is set up, the effects of temperature on bio-oil yield is simulatedly analyzed. The results show that the pyrolysis process is simulated exactly, the model is proved applicable and reliable.

Key words: biomass, pyrolysis, bio-oil, process simulation

摘要: 使用自主研发的流化床热解反应器对生物质热解制油进行实验研究,通过对不同实验温度450、500、525、550、580、610℃下得到的目标产物进行分析,得到了反应温度对生物油产率的影响规律。实验表明:550℃时,最大液体产率为42.5%(质量);实验得到的不可冷凝气体的组分以CO、CO2、CH4和H2为主,气相产物产率约为37.7%(质量)。在实验基础上,利用Aspen Plus流程模拟软件,建立了生物质热解制油工艺模拟流程,模拟分析了热解温度对生物油产率的影响,结果表明该模型能准确模拟实际热解过程,具有较好的适用性和可靠性。

关键词: 生物质, 热解, 生物油, 流程模拟

CLC Number: