CIESC Journal ›› 2016, Vol. 67 ›› Issue (4): 1110-1116.DOI: 10.11949/j.issn.0438-1157.20150230

Previous Articles     Next Articles

Saturated vapor pressure, crystallization temperature and corrosivity of LiBr-[BMIM]Cl/H2O working pair

LUO Chunhuan1,2, ZHANG Yuan1, SU Qingquan1,2   

  1. 1. School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China;
    2. Beijing Engineering Research Center for Energy Saving and Environnental Protection, University of Science and Technology Beijing, Beijing 100083, China
  • Received:2015-02-13 Revised:2015-10-11 Online:2016-04-05 Published:2016-04-05
  • Supported by:

    supported by the Fundamental Research Funds for the Central Universities (FRF-TP-14-022A1) and the Key Project of the Ministry of Education and Guangdong Province (2009A090100032).

LiBr-[BMIM]Cl/H2O工质对的饱和蒸气压、结晶温度和腐蚀性

罗春欢1,2, 张渊1, 苏庆泉1,2   

  1. 1. 北京科技大学机械工程学院, 北京 100083;
    2. 北京科技大学北京市高校节能与环保工程研究中心, 北京 100083
  • 通讯作者: 苏庆泉
  • 基金资助:

    中央高校基本科研业务费专项资金项目(FRF-TP-14- 022A1);广东省教育部产学研结合项目(2009A090100032)。

Abstract:

In order to solve the problems of crystallization and corrosion for LiBr/H2O, LiBr-[BMIM]Cl/H2O and LiBr-[BMIM]Br/H2O were proposed as new working pairs. The influences of ionic liquids on crystallization temperatures and saturated vapor pressures of LiBr/H2O were investigated. The saturated vapor pressures, crystallization temperatures and corrosivity of LiBr-IL/H2O with a mass ratio of 2.5 were measured and compared with that of LiBr/H2O. The results showed that the saturated vapor pressures of [BMIM]Cl/H2O and [BMIM]Br/H2O were almost the same as that of LiBr/H2O with a 8%—9% lower concentration. In general operation concentration range, the crystallization temperatures of LiBr-[BMIM]Cl/H2O were about 30℃ lower than that of LiBr/H2O with the same absorption ability. Under the same corrosion conditions, the corrosion rate of carbon steel for LiBr-[BMIM]Cl/H2O was obviously smaller than that for LiBr/H2O, and the corrosion rate of copper for LiBr-[BMIM]Cl/H2O was nearly the same as that for LiBr/H2O. As an alternative working pair, LiBr-[BMIM]Cl/H2O has a great potential for absorption heat pump systems.

Key words: working pair, ionic liquids, saturated vapor pressure, crystallization temperature, corrosion

摘要:

为了解决LiBr/H2O工质对易结晶和腐蚀性强的问题,提出了LiBr-[BMIM]Cl/H2O和LiBr-[BMIM]Br/H2O新型工质对,研究了离子液体 [BMIM]Cl和[BMIM]Br对LiBr/H2O结晶温度和饱和蒸气压的影响。对质量比为2.5的LiBr-IL(ionic liquids)/H2O的饱和蒸气压、结晶温度和腐蚀性进行了测定并与LiBr/H2O的进行了比较,结果表明[BMIM]Cl/H2O和[BMIM]Br/H2O的饱和蒸气压与质量分数低8%~9%的LiBr/H2O的饱和蒸气压基本相同。在常用工作浓度范围内,LiBr-[BMIM]Cl/H2O的结晶温度比相同吸收能力的LiBr/H2O的低约30℃。在相同的腐蚀条件下,LiBr-[BMIM]Cl/H2O对碳钢的腐蚀性明显小于LiBr/H2O,对紫铜的腐蚀性与LiBr/H2O的基本相同。因此,采用LiBr-[BMIM]Cl/H2O作为替代工质对具有一定的应用潜力。

关键词: 工质对, 离子液体, 饱和蒸气压, 结晶温度, 腐蚀

CLC Number: