CIESC Journal ›› 2025, Vol. 76 ›› Issue (4): 1711-1721.DOI: 10.11949/0438-1157.20240915

• Energy and environmental engineering • Previous Articles     Next Articles

Steady-state modeling on hydrogen production by anion exchange membrane water electrolysis

Zhineng TAO1(), Tong QIU1(), Baoguo WANG1,2   

  1. 1.Department of Chemical Engineering, Tsinghua University, Beijing 100084, China
    2.Beijing Key Laboratory of Membrane Materials and Engineering, Beijing 100084, China
  • Received:2024-08-12 Revised:2024-10-28 Online:2025-05-12 Published:2025-04-25
  • Contact: Tong QIU

阴离子交换膜电解水制氢稳态建模

陶智能1(), 邱彤1(), 王保国1,2   

  1. 1.清华大学化学工程系,北京 100084
    2.膜材料与工程北京市重点实验室,北京 100084

Abstract:

In recent years, the implementation of the “dual carbon” policy and advancements in related technologies has led to a significant increase in the proportion of wind and solar power generation in China. However, the intermittent and unstable nature of these renewable energy sources often results in the phenomenon of “curtailment” of wind and solar power. Hydrogen production through water electrolysis offers a solution by utilizing excess electricity and providing the advantage of zero emissions, thereby holding greater strategic significance compared to traditional hydrogen production methods. Anion exchange membrane water electrolysis (AEMWE), a technology developed over the past decade, integrates the benefits of alkaline water electrolysis (AWE) and proton exchange membrane water electrolysis (PEMWE), offering both high performance and economic advantages. Current domestic research on AEMWE predominantly focuses on the design and improvement of electrodes and membrane materials, with relatively limited studies on system simulation. Moreover, existing models often oversimplify the calculation of crucial parameters such as exchange current density and electrode resistance. To address these gaps, this paper integrates methodologies from other established electrochemical technologies (including AWE, PEMWE, and fuel cells) and relevant electrochemical principles. It introduces correction factors for effective exchange current density and bubble coverage, thereby enhancing the calculation methods for exchange current density. Additionally, a resistance network construction approach is employed to accurately represent electrode resistance. Building upon these methodologies, a more precise and broadly applicable semi-theoretical and semi-empirical steady-state electrochemical model for AEMWE is developed. The model's accuracy is validated using experimental data from existing literature. Finally, a sensitivity analysis is conducted to identify the key variables influencing the hydrogen production efficiency of AEMWE. The results show that membrane thickness, temperature and exchange current density are the main factors affecting the performance of the electrolyzer. Thinner membranes, higher operating temperatures and electrode materials with higher exchange current density are the development trends of electrolyzers.

Key words: simulation, renewable energy, hydrogen production, anion exchange membrane, water electrolysis

摘要:

阴离子交换膜电解水(AEMWE)作为一项新技术,融合了碱性电解水(AWE)和质子交换膜电解水(PEMWE)的优点,兼具高性能和经济效益。基于国内相关研究较少及现有模型存在不足的现状,结合其他成熟的电化学模型(如AWE、PEMWE和燃料电池)和电化学原理,引入有效交换电流密度、气泡覆盖率以及电阻网络构建的修正因素改进交换电流密度和电极电阻的计算方法,由此建立一个精确且适用性强的半理论半经验AEMWE模型,并利用文献实验数据验证模型的准确性,最后使用模型对制氢重要变量进行灵敏性分析。结果表明,膜厚度、温度和交换电流密度是影响电解槽性能的主要因素,更薄的膜、更高的工作温度以及更高交换电流密度的电极材料是电解槽的发展趋势。

关键词: 模拟, 再生能源, 制氢, 阴离子交换膜, 电解水

CLC Number: