凹槽表面的流动与传热特性

doi:10.3969/j.issn.0438-1157.2013.06.008

化工学报 ›› 2013, Vol. 64 ›› Issue (6): 1948-1958.DOI: 10.3969/j.issn.0438-1157.2013.06.008

凹槽表面的流动与传热特性

高小明, 李惟毅, 汪健生

天津大学中低温热能高效利用教育部重点实验室,天津 300072

收稿日期:2012-10-15 修回日期:2012-12-10 出版日期:2013-06-05 发布日期:2013-06-05
通讯作者: 汪健生
作者简介:高小明(1981—),男,博士研究生。

Flow and heat transfer characteristics of groove surface

GAO Xiaoming, LI Weiyi, WANG Jiansheng

Key Laboratory of Medium-Low Temperature Energy Efficient Utilization of Ministry of Education, Tianjin University, Tianjin 300072, China

Received:2012-10-15 Revised:2012-12-10 Online:2013-06-05 Published:2013-06-05

摘要/Abstract

摘要： 采用大涡模拟对底面为凹槽的矩形通道内湍流流动与传热特性进行了研究,为验证所采用数值方法的准确性与可靠性,将平直矩形通道内模拟结果与文献中的直接数值模拟结果进行了比较,换热面Nusselt数与采用Dittus-Boelter公式计算所得Nu进行了比较,计算误差小于5%。以凹槽表面为底面的矩形通道的数值模拟结果表明:通道底面的凹槽结构改变了凹槽表面处流动结构,不同的凹槽高度和长度对流动阻力和换热效果的影响不同,在特定的几何参数下,与平直矩形通道相比,凹槽表面时均Nusselt数提高了近50.5%,时均摩擦阻力系数减小了近35.17%,综合系数增加了73.89%。通道内的流动结构显示:凹槽表面附近存在流体垂直流向壁面区域,在垂直流动区域内流体出现前、后分流,分流位置处Nusselt数增加明显,摩擦阻力系数没有明显增加,其综合流动特性最好。

关键词: 数值模拟, 凹槽表面, 流动减阻, 强化换热

Abstract: The turbulent flow and heat transfer characteristics of rectangular channel with groove bottom surface are investigated by use of large eddy simulation.To validate the accuracy and reliability of the simulation method, the simulation results for plate channel are compared with the direct numerical simulation results of reference. The heat transfer surface Nusselt number is compared to that calculated by Dittus-Boelter equation.The differences are less than 5%.From the simulation results for rectangular channel with groove bottom surface, it is found that the groove structure of the channel bottom surface changes the flow structure near the groove surface.Groove heights and lengths influence the flow resistance and heat transfer effect.Compared with the plate rectangular channel with specific geometric parameters, the time-averaged Nusselt number of groove surface is increased nearly by 50.5%, and the time-averaged friction drag coefficient decreases by 35.17%, and the comprehensive coefficient is increased by 73.89%.The flow structure in the channel shows that there is a region near the groove surface, in which the flow is perpendicular to the wall.The fluid flows forward and backward in the vertical flow region.Since the friction drag coefficient does not increase significantly and the Nusselt number is obviously enhanced, the comprehensive flow characteristic is the best.

Key words: numerical simulation, groove surface, drag reduction, heat transfer enhancement

中图分类号:

TK124

高小明, 李惟毅, 汪健生. 凹槽表面的流动与传热特性[J]. 化工学报, 2013, 64(6): 1948-1958.

GAO Xiaoming, LI Weiyi, WANG Jiansheng. Flow and heat transfer characteristics of groove surface[J]. CIESC Journal, 2013, 64(6): 1948-1958.

参考文献 18

[1]	Lee J H, Sung H J.Direct numerical simulation of a turbulent boundary layer up to Reθ=2500[J].Int. J. Heat Fluid Flow,2011,32(1):1-10
[2]	Lee J H, Lee S H, Kim K, Sung J.Structure of the turbulent boundary layer over a rod-roughened wall[J].Int. J. Heat Fluid Flow, 2009,30(6):1087-1098
[3]	Brillant G, Husson S, Bataille F, Ducros F.Study of the blowing impact on a hot turbulent boundary layer using thermal large eddy simulation[J].Int.J.Heat Fluid Flow, 2008,29(6):1670-1678
[4]	Lu Changgen, Qi Qinjuan.Research into a theoretical mode of coherent structures in the wall region of a turbulent boundary layer induced by a wall local disturbance[J].Prog.Nat.Sci., 2009,19(9):1119-1124
[5]	Babenko V V,Chun H H, Lee Inwon.Coherent vertical structures and methods of their control for drag reduction of bodies[J].J.Hydrodyn., 2010,22(5):45-50
[6]	Choi H S, Suzuki K.Large eddy simulation of turbulent flow and heat transfer in a channel with one wavy wall[J].Int.J.Heat Fluid Flow, 2005,26(5):681-694
[7]	Yao Yan, Lu Chuan-jing, Si Ting, Zhu Kun.Experimental investigation on the drag reduction characteristics of traveling wavy wall at high reynolds number in wind tunnel[J].J.Hydrodyn., 2010,22(5):719-724
[8]	Stalio E, Nobile E.Direct numerical simulation of heat transfer over riblets[J].Int.J.Heat Fluid Flow, 2003,24(3):356-371
[9]	Chen Yu, Chew Y T, Khoo B C.Enhancement of heat transfer in turbulent channel flow over dimpled surface[J].Int.J.heat Mass Tran., 2012,55(25/26):8100-8121
[10]	Wang Ling(王令), Chen Qiuyang(陈秋炀), Zeng Min(曾敏), Huang Yanping(黄彦平), Xiao Zejun(肖泽军).Heat transfer enhancement in rectangular narrow channel with longitudinal vortex generators[J].Journal of Chemical Industry and Engineering(China)(化工学报), 2006,57(11):2549-2553
[11]	He Yaling(何雅玲), Chu Pan(楚攀), Xie Tao(谢涛).Application and optimization of fin-and-tube heat exchangers with longitudinal vortex generators[J].CIESC Journal(化工学报), 2012,63(3):746-760
[12]	Monokrousos A, Brandt L, Schlatter P, Henningson D S.DNS and LES of estimation and control of transition in boundary layers subject to free-stream turbulence[J].Int.J.Heat Fluid Flow, 2008,29(3):841-855
[13]	Kim J, Moin P, Moser R.Turbulence statistics in fully developed channel flow at low Reynolds number[J].J.Fluid Mech., 1987,177, 133
[14]	Pantano C, Pullin D I, Dimotakis P E, Matheou G.LES approach for high Reynolds number wall-bounded flows with application to turbulent channel flow[J].J. Comput. Phys., 2008,227(21):9271-9291
[15]	Yang Shiming(杨世铭), Tao Wenquan(陶文铨).Heat Transfer Theory(传热学)[M].Beijing:Higher Education Press,1998:164
[16]	Mansour N N,Kim J, Moin P.Reynolds-stress and dissipation-rate budgets in a turbulent channel flow[J].J.Fluid Mech., 1988,194:15
[17]	Deck S, Weiss P E, Pamies M, Garnier E.Zonal detached eddy simulation of a spatially developing flat plate turbulent boundary layer[J].Comput.Fluids,2011,48(1):1-15
[18]	Zhou Jue, Zhong Shan.Coherent structures produced by the interaction between synthetic jets and a laminar boundary layer and their surface shear stress patterns[J].Comput.Fluids,2010,39(8):1296-1313

凹槽表面的流动与传热特性

Flow and heat transfer characteristics of groove surface

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 18

相关文章 15

编辑推荐

Metrics

本文评价

[1]	宋嘉豪, 王文. 斯特林发动机与高温热管耦合运行特性研究[J]. 化工学报, 2023, 74(S1): 287-294.
[2]	张思雨, 殷勇高, 贾鹏琦, 叶威. 双U型地埋管群跨季节蓄热特性研究[J]. 化工学报, 2023, 74(S1): 295-301.
[3]	叶展羽, 山訸, 徐震原. 用于太阳能蒸发的折纸式蒸发器性能仿真[J]. 化工学报, 2023, 74(S1): 132-140.
[4]	张义飞, 刘舫辰, 张双星, 杜文静. 超临界二氧化碳用印刷电路板式换热器性能分析[J]. 化工学报, 2023, 74(S1): 183-190.
[5]	王志国, 薛孟, 董芋双, 张田震, 秦晓凯, 韩强. 基于裂隙粗糙性表征方法的地热岩体热流耦合数值模拟与分析[J]. 化工学报, 2023, 74(S1): 223-234.
[6]	何松, 刘乔迈, 谢广烁, 王斯民, 肖娟. 高浓度水煤浆管道气膜减阻两相流模拟及代理辅助优化[J]. 化工学报, 2023, 74(9): 3766-3774.
[7]	邢雷, 苗春雨, 蒋明虎, 赵立新, 李新亚. 井下微型气液旋流分离器优化设计与性能分析[J]. 化工学报, 2023, 74(8): 3394-3406.
[8]	韩晨, 司徒友珉, 朱斌, 许建良, 郭晓镭, 刘海峰. 协同处理废液的多喷嘴粉煤气化炉内反应流动研究[J]. 化工学报, 2023, 74(8): 3266-3278.
[9]	程小松, 殷勇高, 车春文. 不同工质在溶液除湿真空再生系统中的性能对比[J]. 化工学报, 2023, 74(8): 3494-3501.
[10]	刘文竹, 云和明, 王宝雪, 胡明哲, 仲崇龙. 基于场协同和耗散的微通道拓扑优化研究[J]. 化工学报, 2023, 74(8): 3329-3341.
[11]	洪瑞, 袁宝强, 杜文静. 垂直上升管内超临界二氧化碳传热恶化机理分析[J]. 化工学报, 2023, 74(8): 3309-3319.
[12]	黄可欣, 李彤, 李桉琦, 林梅. 加装旋转叶轮T型通道流场的模态分解[J]. 化工学报, 2023, 74(7): 2848-2857.
[13]	史方哲, 甘云华. 超薄热管启动特性和传热性能数值模拟[J]. 化工学报, 2023, 74(7): 2814-2823.
[14]	江锦波, 彭新, 许文烜, 门日秀, 刘畅, 彭旭东. 泵出型螺旋槽油气密封泄漏特性及参数影响研究[J]. 化工学报, 2023, 74(6): 2538-2554.
[15]	朱兴驰, 郭志远, 纪志永, 汪婧, 张盼盼, 刘杰, 赵颖颖, 袁俊生. 选择性电渗析镁锂分离过程模拟优化[J]. 化工学报, 2023, 74(6): 2477-2485.