一种新型受热面飞灰颗粒的沉积特性

doi:10.11949/j.issn.0438-1157.20160232

摘要/Abstract

摘要：

以一种余热锅炉中新型的受热面为研究对象，采用实验研究和数值模拟的方法研究其飞灰沉积特性。建立了菱形受热面飞灰颗粒的沉积模型，对飞灰颗粒的反弹、黏附及脱落过程进行预测，并与叉排管束和顺排管束的含灰烟气流的速度场、温度场和飞灰颗粒沉积率进行比较。结果表明，菱形受热面在换热和飞灰沉积方面优势明显。沉积主要集中于受热面左上部，颗粒由于惯性碰撞在迎风侧沉积。相同速度下，随颗粒粒径增加沉积率先增大后减小，在3 m·s^-1的烟气流速下颗粒直径为5 μm时飞灰颗粒沉积率最高，为9.49%。保持粒径不变，随速度增大沉积率逐渐降低。

关键词: 飞灰沉积, 受热面, 模型, 数值模拟, 实验验证

Abstract:

A novel structure with rhombus heat transfer surface used in the waste heat boiler was researched. Numerical simulation and experimental investigation were conducted to obtain characteristics of ash distribution and deposition. A deposition model was built to predict the stick, rebound and shedding of an ash particle, and the simulation results were compared with traditional staggered and aligned tubes arrangement. The results indicated that the rhombic surface showed obvious advantages in the heat transfer and ash deposition. The deposits were mainly concentrated on the upper left side. Particle deposited on windward side due to the inertial impaction and on leeward side because of pipe wall vortex. The deposition amount of windward side was higher than that of the leeward side. The deposition increased firstly and then decreased with the increase of the particle size under the same velocity. When the gas velocity was 3 m·s^-1 and particle diameter was 5 μm, the ash particle deposition rate was up to 9.49%. For particles of the same size, the deposition rate decreased gradually with increasing velocity.

Key words: ash deposition, heat transfer surface, model, numerical simulation, experimental validation

中图分类号:

TK124

李金波, 王沛丽, 程林. 一种新型受热面飞灰颗粒的沉积特性[J]. 化工学报, 2016, 67(9): 3598-3606.

LI Jinbo, WANG Peili, CHENG Lin. Characteristics of ash deposition on a novel heat transfer surface[J]. CIESC Journal, 2016, 67(9): 3598-3606.

参考文献 26

[1]	TSAI C J, LIN J S, AGGARWAL S G, et al. Thermophoretic deposition of particles in laminar and turbulent tube flows[J]. Aerosol Science & Technology, 2003, 38(2):131-139.
[2]	KONSTANDOPOULOS A G, ROSNER D E. Inertial effects on thermophoretic transport of small particles to walls with streamwise curvature(Ⅰ):Theory[J]. International Journal of Multiphase Flow, 1996, 22(12):2317-2327.
[3]	刘博, 李辉, 李娜, 等. 余热锅炉对流受热面积灰特性的实验研究[J]. 工程热物理学报, 2013, 34(2):209-293. LIU B, LI H, LI N, et al. Experimental study on ash deposition characteristic of convection heating surface in waste heat boiler[J]. Journal of Engineering Thermophysics, 2013, 34(2):209-293.
[4]	裴炜, 王树众, 佟振霞. 锅炉管内腐蚀结垢过程的实验研究[J]. 热能动力工程, 2011, 26(5):561-565. PEI W, WANG S Z, TONG Z X. Experimental study of boiler tube corrosion and scaling process[J]. Journal of Engineering for Thermal Energy and Power, 2011, 26(5):561-565.
[5]	MANICKAM M, SCHWARZ M P, PERRY J. CFD modelling of waste heat recovery boiler[J]. Applied Mathematical Modelling, 1998, 22(10):823-840.
[6]	周翼, 吴新, 韩继广. 飞灰颗粒撞击顺列光管管束的数值模拟研究[J]. 南京师范大学学报(工程技术版), 2011, 11(4):34-39. ZHOU Y, WU X, HAN J G. Simulation study on flue gas particle impacting the aligned bare tube bundles[J]. Journal of Nanjing Normal University (Engineering and Technology Edition), 2011, 11(4):34-39.
[7]	潘亚娣, 司风琪, 徐治皋. 电站锅炉受热面灰污沉积模型[J]. 中国电机工程学报, 2010, 30(8):63-67. PAN Y D, SI F Q, XU Z G. Deposition model of fouling on coal-fired utility boiler heating surfaces[J]. Proceedings of the CSEE, 2010, 30(8):63-67.
[8]	吕太, 王海. 75t/h秸杆锅炉过热器积灰数值模拟的研究实践[J]. 东北电力大学学报, 2011, 31(3):30-33. LÜ T, WANG H. Research and numerical simulation on ash deposition of 75t/h straw boiler superheater[J]. Journal of Northeast Dianli University, 2011, 31(3):30-33.
[9]	杜文静, 王红福, 袁晓豆, 等. 椭圆管连续螺旋折流板换热器壳侧性能评价及三场协同分析[J]. 化工学报, 2013, 64(4):1145-1150. DU W J, WANG H F, YUAN X D, et al. Evaluation of shell side performance and analysis on continuous helical baffled heat exchangers with elliptical tubes[J]. CIESC Journal, 2013, 64(4):1145-1150.
[10]	汲水, 杜文静, 王鹏, 等. 交错搭接螺旋折流板换热器壳程流动与传热的场协同分析[J]. 中国电机工程学报, 2011, 31(20):75-80. JI S, DU W J, WANG P, et al. Field synergy analysis on shell-side flow and heat transfer of heat exchanger with staggered overlap helical baffles[J]. Proceedings of the CSEE, 2011, 31(20):75-80.
[11]	董聪,陈亚平,吴嘉峰, 等. 三分螺旋折流板换热器水-水传热壳侧综合性能[J]. 化工学报, 2012, 63(3):721-727. DONG C, CHEN Y P, WU J F, et al. Water to water heat transfer on shell-side of trisection helical baffle heat exchangers[J]. CIESC Journal, 2012, 63(3):721-727.
[12]	倪建军, 梁钦锋, 代正华, 等. 撞击流气化炉内气固两相流动与颗粒附壁沉积数值模拟[J]. 中国电机工程学报, 2009, 29(2):69-74. NI J J, LIANG Q F, DAI Z H, et al. Numerical simulation of gas-solid two-phase flows and particle deposition in impinging streams gasifier[J]. Proceedings of the CSEE, 2009, 29(2):69-74.
[13]	穆林, 赵亮, 尹洪超. 废液焚烧余热锅炉内气固两相流动与飞灰沉积的数值模拟[J]. 中国电机工程学报, 2012, 32(29):30-37. MU L, ZHAO L, YIN H C. Numerical simulation of gas-solid two-phase flow and ash deposition in a wastewater incineration heat recovery steam generator[J]. Proceedings of the CSEE, 2012, 32(29):30-37.
[14]	LI A, AHMADI G. Dispersion and deposition of spherical particles from point sources in a turbulent channel flow[J]. Aerosol Science & Technology, 1992, 16(4):209-226.
[15]	HE C, AHMADI G. Particle deposition with thermophoresis in laminar and turbulent duct flows[J]. Aerosol Science & Technology, 1998, 29(29):525-546.
[16]	李岷, 刘永春, 何雅儒. 水泥回转窑余热锅炉的积灰特点及其防止[J]. 锅炉制造, 2000, 1(2):28-29. LI M, LIU Y C, HE Y R. Dust deposit characteristic and prevention method of waste heat boiler for cement rotary kiln[J]. Boiler Manufacturing, 2000, 1(2):28-29.
[17]	赵钦新, 周屈兰, 谭厚章, 等. 余热锅炉研究与设计[M]. 北京:中国标准出版社, 2010:474-475. ZHAO Q X, ZHOU Q L, TAN H Z, et al. HRSG Research and Design[M]. Beijing:Standards Press of China, 2010:474-475.
[18]	BRACH R M, DUNN P F. A mathematical model of the impact and adhesion of microspheres[J]. Aerosol Sciences & Technology, 1992, 16(1):51-64.
[19]	AI W, KUHLMAN J M. Simulation of coal ash particle deposition experiments[J]. Energy & Fuels, 2011, 25(2):708-718.
[20]	童自翔, 何雅玲, 李冬, 等. 应用格子Boltzmann方法研究颗粒横掠管束的沉积过程[J]. 工程热物理学报, 2014, 35(9):1802-1806. TONG Z X, HE Y L, LI D, et al. Lattice Boltzmann simulation for the particle flow and deposition on the tube bundles[J]. Journal of Engineering Thermophysics, 2014, 35(9):1802-1806.
[21]	WALSH P M, SAYRE A N, LOEHDEN D O, et al. Deposition of bituminous coal ash on an isolated heat exchanger tube:effects of coal properties on deposit growth[J]. Progress in Energy & Combustion Science, 1990, 16(4):327-345.
[22]	TOMECZEK J, WACLAWIAK K. Two-dimensional modelling of deposits formation on platen superheaters in pulverized coal boilers[J]. Fuel, 2009, 88(8):1466-1471.
[23]	HAN H, HE Y L, TAO W Q, et al. A parameter study of tube bundle heat exchangers for fouling rate reduction[J]. International Journal of Heat & Mass Transfer, 2014, 72(72):210-221.
[24]	BOURIS D, KONSTANTINIDIS E, BALABANI S, et al. Design of a novel, intensified heat exchanger for reduced fouling rates[J]. International Journal of Heat & Mass Transfer, 2005, 48(18):3817-3832.
[25]	杜文静, 王沛丽, 程林. 一种新型受热面传热和流动特性的数值模拟及实验研究[J]. 化工学报, 2015, 66(6):2070-2075. DU W J, WANG P L, CHENG L. Numerical simulation and experimental research on novel heat transfer surface[J]. CIESC Journal, 2015, 66(6):2070-2075.
[26]	PAN Y, SI F, XU Z, et al. An integrated theoretical fouling model for convective heating surfaces in coal-fired boilers[J]. Powder Technology, 2011, 210(2):150-156.