蒸汽在扁平管内逆流流动凝结实验与理论分析

doi:10.11949/j.issn.0438-1157.20150623

化工学报 ›› 2015, Vol. 66 ›› Issue (12): 4806-4814.DOI: 10.11949/j.issn.0438-1157.20150623

蒸汽在扁平管内逆流流动凝结实验与理论分析

程通锐, 杜小泽, 杨立军

华北电力大学电站设备状态监测与控制教育部重点实验室, 北京 102206

收稿日期:2015-05-18 修回日期:2015-08-26 出版日期:2015-12-05 发布日期:2015-12-05
通讯作者: 杜小泽
基金资助:
国家重点基础研究发展计划项目(2015CB251503)。

Experimental and theoretical analysis on reflux flow condensation of vapor inside flat tube

CHENG Tongrui, DU Xiaoze, YANG Lijun

Key Laboratory of Condition Monitoring and Control for Power Plant Equipment of Ministry of Education, North China Electric Power University, Beijing 102206, China

Received:2015-05-18 Revised:2015-08-26 Online:2015-12-05 Published:2015-12-05
Supported by:
supported by the National Basic Research Program of China(2015CB251503).

摘要/Abstract

摘要：

针对火电机组直接空冷凝汽器扁平管内蒸汽凝结换热过程,设计并搭建了水冷扁平管内可视化流动凝结实验台,开展管内凝结换热研究。建立涵盖壁面薄液膜和圆弧段液池的流动凝结分析模型,得到凝结液膜发展相关方程。特别对于壁面液膜双曲型发展方程,考虑其对流特征和物理守恒特性,提出共轭梯度法-牛顿法-模拟退火相结合的稳态求解算法,避免传统非稳态方法的复杂性。可视化实验结果表明,管内汽液两相分层流动,扁平管圆弧底部形成了液池。对应的理论分析结果更加细致地表明,管内凝结换热为分层流型,液池液膜厚度为1 mm量级,壁面液膜相比液池液膜薄很多,因而具有较高的凝结传热系数。分析结果为判断冬季低温环境运行时管内冻结起始位置提供了依据。

关键词: 空冷凝汽器, 扁平管, 实验, 凝结, 液膜, 冻结风险

Abstract:

For investigating condensation heat transfer characteristic inside flat tubes widely applied in air-cooled condenser in large power plant, a water cooled visualization condensation test system is designed and built for an indirect study on the flow regime of condensation process in a condenser. Base on the observed stratified flow regime, a theoretical model is built for condensation flow and heat transfer process including condensate water bath development on the arc wall and condensate film development on the other wall. Especially, for condensate film on the wall, a hyperbolic equation is proposed. Considering the convection and conservation characteristic in the equation, a solution algorithm for steady conservation equation is produced by combination of the conjugate gradient method, the Newton method and simulated annealing method, which can avoid the complex of traditional non-steady method. The visualization results indicate that the flow regime of condensation process is stratified flow regime and the corresponding theoretical calculation results indicate that the condensate film thickness on the wall is far less than condensate bath height, which is in the 1 mm order of magnitude, and leads to high condensation heat transfer coefficient. The results supply grounds for judging the onset position of freezing in flat tube under air cooling condition in power plant in winter.

Key words: air-cooled condenser, flat tube, experiment, condensation, liquid film, freezing risk

中图分类号:

TK124

程通锐, 杜小泽, 杨立军. 蒸汽在扁平管内逆流流动凝结实验与理论分析[J]. 化工学报, 2015, 66(12): 4806-4814.

CHENG Tongrui, DU Xiaoze, YANG Lijun. Experimental and theoretical analysis on reflux flow condensation of vapor inside flat tube[J]. CIESC Journal, 2015, 66(12): 4806-4814.

参考文献 18

[1]	Feng Lili(冯丽丽), Du Xiaoze(杜小泽), Yang Yongping(杨勇平). Study on heat transfer enhancement of discontinuous short wave finned flat tube [J]. Science China Technological Sciences(中国科学), 2011, 54(12): 3281-3288.
[2]	Zhang Kaifeng(张凯峰), Yang Lijun(杨立军), Du Xiaoze(杜小泽). Flow and heat transfer characteristics of cooling air outside the flat wave-finned tube banks of air-cooled condensers [J]. Proceedings of the CSEE(中国电机工程学报), 2008, 26: 6.
[3]	Zeng Shiming(曾时明). Numerical investigation of the heat transfer and fluid flow of finned-tube and the flow characteristics of a condenser unit in direct air-cooled power plant[D]. Beijing: Beijing Jiaotong University, 2007.
[4]	Almmer A, Bakran B, Hoxtermann L. VGB guideline acceptance test measurements and operation monitoring of air-cooled condensers under vacuum [S]: VGB-R 131 Me. VGB Technische Vereinigung Der Grosskraftwerksbetreiber EV, 1997.
[5]	Bortolin S, Da Riva E, Del Col D. Condensation in a square minichannel: application of the VOF method [J]. Heat Transfer Engineering, 2014, 35(2): 193-203.
[6]	Das S, Gada V H, Sharma A. Analytical and level set method-based numerical study for two-phase stratified flow in a pipe [J]. Numerical Heat Transfer, Part A: Applications, 2015, 67(11): 1253-1281.
[7]	Wang H S, Honda H, Nozu S. Modified theoretical models of film condensation in horizontal microfintubes [J]. International Journal of Heat and Mass Transfer, 2002, 45(7): 1513-1523.
[8]	Wang H S, Rose J W. Theory of heat transfer during condensation in microchannels [J]. International Journal of Heat and Mass Transfer, 2011, 54(11): 2525-2534.
[9]	Liang Q, Wang X, Barve A S, et al. Effects of gravity and surface tension and interfacial-waves and heat-transfer rates in internal condensing flows// ASME 2003 Heat Transfer Summer Conference [C]. ASME, 2003: 676-686.
[10]	Narain A, Liang Q, Yu G, et al. Direct computational simulations for internal condensing flows and results on attainability/stability of steady solutions, their intrinsic waviness, and their noise sensitivity [J]. Transactions-American Society of Mechanical Engineers Journal of Applied Mechanics, 2004, 71(1): 69-88.
[11]	Fiedler S, Thonon B, Auracher H. Flooding in small-scale passages [J]. Experimental Thermal and Fluid Science, 2002, 26(5): 525-533.
[12]	Fiedler S, Auracher H, Winkelmann D. Effect of inclination on flooding and heat transfer during reflux condensation in a small diameter tube [J]. International Communications in Heat and Mass Transfer, 2002, 29(3): 289-302.
[13]	Fiedler S, Auracher H. Pressure drop during reflux condensation of R134A in a small diameter tube [J]. Experimental Thermal and Fluid Science, 2004, 28(2): 139-144.
[14]	Guo Z, Anand N K. An analytical model to predict condensation of R-410A in a horizontal rectangular channel [J]. Journal of Heat Transfer, 2000, 122(3): 613-620.
[15]	Rosson H F, Meyers J A. Point values of condensing film coefficients inside a horizontal tube//Chemical Engineering Progress Symposium Series[C],1965: 190-199.
[16]	Guo Z. Condensation of R-410a in a horizontal rectangular channel [D]. Texas: Texas A&M University, 1998: 25-37
[17]	Wang B X, Du X Z. Study on laminar film-wise condensation for vapor flow in an inclined small/mini-diameter tube [J]. International Journal of Heat and Mass Transfer, 2000, 43(10): 1859-1868.
[18]	Liao Y, Guentay D, Suckow D, Dehbi A. Reflux condensation of flowing vapor and non-condensable gases counter-current to laminar liquid film in a vertical tube [J]. Nuclear Engineering and Design, 2009, 239: 2409-2416.

蒸汽在扁平管内逆流流动凝结实验与理论分析

Experimental and theoretical analysis on reflux flow condensation of vapor inside flat tube

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 18

相关文章 15

编辑推荐

Metrics

本文评价

[1]	周绍华, 詹飞龙, 丁国良, 张浩, 邵艳坡, 刘艳涛, 郜哲明. 短管节流阀内流动噪声的实验研究及降噪措施[J]. 化工学报, 2023, 74(S1): 113-121.
[2]	苏伟, 马东旭, 金旭, 刘忠彦, 张小松. 表面润湿性对霜层传递特性影响可视化实验研究[J]. 化工学报, 2023, 74(S1): 122-131.
[3]	闫琳琦, 王振雷. 基于STA-BiLSTM-LightGBM组合模型的多步预测软测量建模[J]. 化工学报, 2023, 74(8): 3407-3418.
[4]	张贲, 王松柏, 魏子亚, 郝婷婷, 马学虎, 温荣福. 超亲水多孔金属结构驱动的毛细液膜冷凝及传热强化[J]. 化工学报, 2023, 74(7): 2824-2835.
[5]	袁子涵, 王淑彦, 邵宝力, 谢磊, 陈曦, 马一玫. 基于幂律液固曳力模型流化床内湿颗粒流动特性的研究[J]. 化工学报, 2023, 74(5): 2000-2012.
[6]	罗来明, 张劲, 郭志斌, 王海宁, 卢善富, 相艳. 1~5 kW高温聚合物电解质膜燃料电池堆的理论模拟与组装测试[J]. 化工学报, 2023, 74(4): 1724-1734.
[7]	时国华, 何林珅, 赵玺灵, 张世钢. 余热回收喷淋塔的烟气颗粒物脱除特性研究[J]. 化工学报, 2023, 74(4): 1735-1745.
[8]	许文烜, 江锦波, 彭新, 门日秀, 刘畅, 彭旭东. 宽速域三种典型型槽油气密封泄漏与成膜特性对比研究[J]. 化工学报, 2023, 74(4): 1660-1679.
[9]	王永倩, 王平, 程康, 毛晨林, 刘文锋, 尹智成, Ferrante Antonio. 氨气/甲烷贫预混旋转湍流火焰稳定性及NO生成[J]. 化工学报, 2022, 73(9): 4087-4094.
[10]	刘潜, 张香兰, 李志平, 李玉龙, 韩梦醒. 油酚分离过程低共熔溶剂的筛选及萃取性能研究[J]. 化工学报, 2022, 73(9): 3915-3928.
[11]	鲁军辉, 李俊明. H₂O-CO₂、H₂O-N₂、H₂O-He水平管外自然对流凝结换热特性研究[J]. 化工学报, 2022, 73(9): 3870-3879.
[12]	罗佳, 吴双应, 肖兰, 周世耀, 陈志莉. 撞击速度对连续液滴撞击热圆柱壁面局部传热特性影响的实验[J]. 化工学报, 2022, 73(7): 2944-2951.
[13]	解文潇, 贾胜坤, 张会书, 罗祎青, 袁希钢. 受限空间内浮升气泡与液体间传质行为实验研究[J]. 化工学报, 2022, 73(7): 2902-2911.
[14]	黄陆月, 刘畅, 许勇毅, 邢浩若, 王峰, 马双忱. CDI二维浓度传质模型的建立以及实验验证[J]. 化工学报, 2022, 73(7): 2933-2943.
[15]	李雯, 兰忠, 强伟丽, 任文芝, 杜宾港, 马学虎. 蒸汽冷凝近壁过渡区团簇演化特性[J]. 化工学报, 2022, 73(7): 2865-2873.