丙烷预冷混合制冷剂液化工艺原料气敏感性分析

doi:10.11949/j.issn.0438-1157.20150733

化工学报 ›› 2015, Vol. 66 ›› Issue (S2): 186-191.DOI: 10.11949/j.issn.0438-1157.20150733

丙烷预冷混合制冷剂液化工艺原料气敏感性分析

潘红宇, 李玉星, 朱建鲁

中国石油大学(华东)储建学院, 山东青岛 266580

收稿日期:2015-05-27 修回日期:2015-06-04 出版日期:2015-08-31 发布日期:2015-08-31
通讯作者: 潘红宇
基金资助:
国家科技重大专项项目(2011ZX05026-006-07)。

Sensibility analysis of feed gas in propane pre-cool mixed refrigerant liquefaction process feed gas

PAN Hongyu, LI Yuxing, ZHU Jianlu

College of Pipeline and Civil Engineering, China University of Petroleum, Qingdao 266580, Shandong, China

Received:2015-05-27 Revised:2015-06-04 Online:2015-08-31 Published:2015-08-31
Supported by:
supported by the National Science and Technology Major Project of China(2011ZX05026-006-07).

摘要/Abstract

摘要：

液化天然气液化后的体积仅为原体积的1/625,十分有利于运输和储存。丙烷预冷混合制冷剂液化工艺是目前最常用的天然气液化工艺,该工艺结合了级联式液化流程与混合制冷剂液化流程的优点,既高效又简单,目前世界上80%以上的基本负荷型天然气液化装置采用了此流程。由于实际情况中原料气的入口压力、温度、组分均存在变化的可能,需要针对工艺的原料气敏感性进行动态仿真分析。通过分别添加原料气压力、温度、组分的扰动,得到了各个工艺系统的动态响应。结果表明:当丙烷预冷混合制冷剂液化工艺分别存在原料气压力、温度、组分扰动时,各个系统均能在一段时间后重新恢复稳定,稳定时间为20~250 min。验证了丙烷预冷混合制冷剂液化工艺在原料气入口条件扰动时的稳定性和可靠性。

关键词: 丙烷预冷, 混合制冷剂, 天然气, 动态仿真, 稳定性, 敏感性分析

Abstract:

After liquefied at low temperature,the volume of the natural gas is only 1/625 of its original volume,greatly convenient for its conveyance and storage.Propane pre-cooled mixed refrigerant process is the most common gas liquefaction process by now,which is a combination of cascading liquefaction and mixed-refrigerant liquefaction process.Efficient as well as simple,more than 80 percent of the basic duty natural gas liquefaction plants are using this process in the world.Because of the actual situation that the pressure,temperature and component are likely to change in the inlet feed gas,it is necessary to do dynamic simulation analysis of the sensitivity of the feed gas.By adding the perturbation of pressure,temperature,component on feed gas separately,the dynamic response of the respective process system is obtained.The results show that:when the perturbation of pressure,temperature,component respectively react on propane pre-cooled mixed refrigerant liquefaction process,each system can regain stability after a period of time,and the stabilization time ranges from 20 to 250 minutes.In this way,the stability and reliability of propane pre-cooled mixed refrigerant liquefaction process are verified when the perturbation of feed gas exists.

Key words: propane pre-cooled, mixed refrigerant, natural gas, dynamic simulation, stability, sensitivity analysis

中图分类号:

TQ026.1

潘红宇, 李玉星, 朱建鲁. 丙烷预冷混合制冷剂液化工艺原料气敏感性分析[J]. 化工学报, 2015, 66(S2): 186-191.

PAN Hongyu, LI Yuxing, ZHU Jianlu. Sensibility analysis of feed gas in propane pre-cool mixed refrigerant liquefaction process feed gas[J]. CIESC Journal, 2015, 66(S2): 186-191.

参考文献 19

[1]	Vink K J.Comparison of baseload liquefaction process//Twelfth international Conference & Exhibition on Liquefied Natural Gas[C].1998.
[2]	Okasinski M J,Liu Y N.Dynamic simulation of C3-MR LNG plants with parallel compression strings//16th International Conference & Exhibition on Liquefied Natural Gas[C].2010.
[3]	Briend P,Deschildre C,Icart Y,Sequeira S E.Dynamic simulation of a large scale pulsed load helium refrigerator[J].AIP Conference Proceedings,2010,1218(1):1453-1459.
[4]	Cascone R.Advances in small scale LNG technology provide user options[J].Oil & Gas Journal,2005,103(2):15-21.
[5]	Foglietta J H.Consider dural independent expander refrigera-tion for LNG production[J].Hydrocarbon Processing,2004,83(1):39-44.
[6]	Kountz K,Kriha K,Liss K,et al.Development of a Small-scale Natural Gas Liquefier.GTI Report(Project 65943)for DOE[EB/OL],2003.
[7]	Jolinde M,van de Graaf.The shell PMR process for large capacity LNG trains//AICHE Spring Meeting[C].2005:1-71.
[8]	Goldfarb S,Oldhom J.Refrigeration loop dynamic analysis using PROTISS[J].Computers and Chemical Engineering,1996,20(S2):S811-S816.
[9]	Jorge Contreras,Jose Maria Ferrer.Dynamic simulation:a case study[J].Hydrocarbon Engineering,2005,10(5):1-4.
[10]	Rodriguez M,Diaz M S.Dynamic modeling and optimization of cryogenic systems[J].Applied Thermal Engineering,2007,27:1182-1190.
[11]	Singh A,Hovd M.Dynamic modeling and control structure design for a liquefied natural gas process//Proceedings of the 2007 American Control Conference[C].1347-1352.
[12]	Bezzoi F,Bernardi R.Using proves simulators for steady-state and dynamic plant analysis:an industrial case study[J].Chemical Engineering Research and Design,2004,82(A4):499-512.
[13]	Singh A,Hovd M.Dynamic modeling and control of the PRICO LNG process//American Institute of Chemical Engineers Annual Meeting[C].San Francisco,USA,2006:1-7.
[14]	Jensen J B,Skogestad S.Optimal operation of a simple LNG process//International Symposium on Advanced Control of Chemical Processes[C].2006:241-246.
[15]	Jensen J B,Skogestad S.Optimal operation of simple refrigeration cycles(Ⅰ):Degrees of freedom and optimality of sub-cooling[J].Computers and Chemical Engineering,2007,31:712-721.
[16]	Jensen J B,Skogestad S.Optimal operation of simple refrigeration cycles(Ⅱ):Selection of controlled variables[J].Computers and Chemical Engineering,2007,31:1590-1601.
[17]	Gu Anzhong(顾安忠).Handbook of LNG Technology(液化天然气技术手册)[M].Beijing:China Machine Press,2010:112-122.
[18]	Shi Yumei(石玉美),Wang Rongshun(汪荣顺),Gu Anzhong(顾安忠).Influence of parameters on C3/MRC process performance of natural gas liquefaction[J].Natural Gas Industry(天然气工业),2004,24(3):111-114.
[19]	Wang Kun(王坤),Xu Fengyu(徐风雨),Li Hongyan(李红艳),et al.Dynamic performance simulation of plate-fin heat exchangers in small scale MRC-LNG plant[J]. Cryogenics(低温工程),2007,(3):44-49.

丙烷预冷混合制冷剂液化工艺原料气敏感性分析

Sensibility analysis of feed gas in propane pre-cool mixed refrigerant liquefaction process feed gas

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 19

相关文章 15

编辑推荐

Metrics

本文评价

[1]	江河, 袁俊飞, 王林, 邢谷雨. 均流腔结构对微细通道内相变流动特性影响的实验研究[J]. 化工学报, 2023, 74(S1): 235-244.
[2]	杨欣, 王文, 徐凯, 马凡华. 高压氢气加注过程中温度特征仿真分析[J]. 化工学报, 2023, 74(S1): 280-286.
[3]	宋嘉豪, 王文. 斯特林发动机与高温热管耦合运行特性研究[J]. 化工学报, 2023, 74(S1): 287-294.
[4]	张思雨, 殷勇高, 贾鹏琦, 叶威. 双U型地埋管群跨季节蓄热特性研究[J]. 化工学报, 2023, 74(S1): 295-301.
[5]	郑玉圆, 葛志伟, 韩翔宇, 王亮, 陈海生. 中高温钙基材料热化学储热的研究进展与展望[J]. 化工学报, 2023, 74(8): 3171-3192.
[6]	张瑞航, 曹潘, 杨锋, 李昆, 肖朋, 邓春, 刘蓓, 孙长宇, 陈光进. ZIF-8纳米流体天然气乙烷回收工艺的产品纯度关键影响因素分析[J]. 化工学报, 2023, 74(8): 3386-3393.
[7]	孟令玎, 崇汝青, 孙菲雪, 孟子晖, 刘文芳. 改性聚乙烯膜和氧化硅固定化碳酸酐酶[J]. 化工学报, 2023, 74(8): 3472-3484.
[8]	蔡斌, 张效林, 罗倩, 党江涛, 左栗源, 刘欣梅. 导电薄膜材料的研究进展[J]. 化工学报, 2023, 74(6): 2308-2321.
[9]	毛磊, 刘冠章, 袁航, 张光亚. 可捕集CO₂的纳米碳酸酐酶粒子的高效制备及性能研究[J]. 化工学报, 2023, 74(6): 2589-2598.
[10]	徐文超, 孙志高, 李翠敏, 李娟, 黄海峰. 静态条件下表面活性剂E-1310对HCFC-141b水合物生成的影响[J]. 化工学报, 2023, 74(5): 2179-2185.
[11]	孙永尧, 高秋英, 曾文广, 王佳铭, 陈艺飞, 周永哲, 贺高红, 阮雪华. 面向含氮油田伴生气提质利用的膜耦合分离工艺设计优化[J]. 化工学报, 2023, 74(5): 2034-2045.
[12]	王子健, 柯明, 李佳涵, 李舒婷, 孙巾茹, 童燕兵, 赵治平, 刘加英, 任璐. 短b轴ZSM-5分子筛制备方法及应用研究进展[J]. 化工学报, 2023, 74(4): 1457-1473.
[13]	李明川, 樊栓狮, 徐赋海, 卢惠东, 李晓军. 水合物热分解Stefan相变模型解的存在性及Laplace变换求解[J]. 化工学报, 2023, 74(4): 1746-1754.
[14]	陈向上, 马振杰, 任希华, 贾悦, 吕晓龙, 陈华艳. 三维网络萃取膜的制备及传质效率研究[J]. 化工学报, 2023, 74(3): 1126-1133.
[15]	陈俊先, 姬忠礼, 赵瑜, 张倩, 周岩, 刘猛, 刘震. 基于微波技术的天然气管道内颗粒物在线检测方法研究[J]. 化工学报, 2023, 74(3): 1042-1053.