化工学报 ›› 2016, Vol. 67 ›› Issue (9): 3730-3737.DOI: 10.11949/j.issn.0438-1157.20160111

• 分离工程 • 上一篇    下一篇

无机杂化海藻酸钠渗透汽化膜的制备与分离性能对比

那沙沙, 李卫星, 邢卫红   

  1. 南京工业大学化工学院, 材料化学工程国家重点实验室, 国家特种分离膜工程技术研究中心, 江苏 南京 210009
  • 收稿日期:2016-01-25 修回日期:2016-04-28 出版日期:2016-09-05 发布日期:2016-09-05
  • 通讯作者: 李卫星
  • 基金资助:

    国家自然科学基金项目(21576132);国家科技支撑项目课题项目(2013BAE11B01);江苏省六大人才高峰项目(2013-XCL-027);江苏高校优势学科建设工程资助项目(PAPD)。

Development of inorganic nano particles modified sodium alginate hybrid membranes for pervaporation

NA Shasha, LI Weixing, XING Weihong   

  1. State Key Laboratory of Materials-Oriented Chemical Engineering, National Engineering Research Center for Special Separation Membranes, College of Chemical Engineering, Nanjing Tech University, Nanjing 210009, Jiangsu, China
  • Received:2016-01-25 Revised:2016-04-28 Online:2016-09-05 Published:2016-09-05
  • Supported by:

    supported by National Natural Science Foundation of China (21576132), the National Key Science and Technology Program of China (2013BAE11B01), the Jiangsu Province Foundation of China (2013-XCL-027) and the Priority Academic Program Development of Jiangsu Higher Education Institutions (PAPD).

摘要:

为提高海藻酸钠(SA)膜的渗透汽化分离性能,分别采用纳米氧化铝、纳米氧化锆和纳米氧化钛对SA膜进行改性,对比分析了3种不同杂化膜渗透汽化分离性能的差异,并将分离性能较好的杂化膜应用到乙酸与乙醇酯化反应脱水的体系中。系统考察了无机纳米粒子含量对SA膜渗透汽化分离性能的影响,对杂化膜进行了接触角、傅里叶红外(FTIR)、扫描电子显微镜(SEM)、热重/差示扫描量热(TG/DSC)、X射线衍射(XRD)和拉伸强度等表征与分析。结果表明,无机纳米粒子能提高SA膜的热稳定性、机械强度和渗透通量,当无机纳米粒子与SA质量比为0.3时,掺杂TiO2、ZrO2和Al2O3的杂化膜二碘甲烷的接触角依次升高,同时渗透通量也依次升高。SA-0.3Al2O3杂化膜亲水性较好,然而SA-0.3ZrO2杂化膜分离性能最优,50℃下分离水含量10%的乙醇-水溶液,膜渗透通量达到336 g·m-2·h-1,渗透侧水含量99.97%,分离因子29990。酯化反应脱水实验表明,在80℃时,酯化反应脱水实验乙酸转化率均高于无脱水实验乙酸转化率,平衡转化率不断被打破,反应12 h后,转化率由平衡时的79.3%提高到93.9%。

关键词: 海藻酸钠, 杂化膜, 纳米氧化铝, 纳米氧化锆, 纳米氧化钛, 渗透汽化, 酯化

Abstract:

In order to improve the pervaporation performance of SA, nano-alumina, nano-zirconia and nano-titania were incorporated into SA solution, respectively. The difference of pervaporatin performance was analyzed, and the membrane that had better separation performance was selected for pervaporation (PV)-assisted esterification of acetic acid and ethanol. The effect of nano-particles content on the separation performance was investigated. The obtained membranes were characterized by scanning electron microscope (SEM), Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), thermogravimetry (TG) and differential scanning calorimetry (DSC). The thermal stability, tensile strength and permeate flux of hybrid membranes were enhanced after incorporating nano-particles into SA. When the mass ratio of nanoparticles to SA was 0.3, the methylene iodide contact angle of incorporated TiO2, ZrO2 and Al2O3 hybrid membranes increased, respectively. Meanwhile, the permeate flux increased at the same time. The hydrophilic property of SA-0.3Al2O3 membrane was the best; however, the separation performance of SA-0.3ZrO2 membrane was better. The permeate flux of SA-0.3ZrO2 membrane was 336 g·m-2·h-1 with water content 99.97% in the permeate side and separation factor 29990 when the amount of water in feed was 10% at 50℃. The conversion of esterification enhanced by pervaporation reached 93.9% in 12 h at 80℃.

Key words: sodium alginate, hybrid membrane, nano-alumina, nano-zirconia, nano-titania, pervaporation, esterification

中图分类号: