螺旋槽干气密封微尺度气膜的温度场计算

doi:10.3969/j.issn.0438-1157.2014.04.027

化工学报 ›› 2014, Vol. 65 ›› Issue (4): 1353-1358.DOI: 10.3969/j.issn.0438-1157.2014.04.027

螺旋槽干气密封微尺度气膜的温度场计算

丁雪兴, 刘勇, 张伟政, 张英杰

兰州理工大学石油化工学院, 甘肃兰州 730050

收稿日期:2013-07-09 修回日期:2013-10-29 出版日期:2014-04-05 发布日期:2013-11-11
通讯作者: 刘勇
作者简介:丁雪兴（1964—），男，教授。
基金资助:
国家自然科学基金项目（51165020）。

Calculation of temperature field of micro-scale gas film in spiral groove dry gas seal

DING Xuexing, LIU Yong, ZHANG Weizheng, ZHANG Yingjie

College of Petrochemical Engineering, Lanzhou University of Technology, Lanzhou 730050, Gansu, China

Received:2013-07-09 Revised:2013-10-29 Online:2014-04-05 Published:2013-11-11
Supported by:
supported by the National Natural Science Foundation of China (51165020).

摘要/Abstract

摘要： 螺旋槽干气密封在高压、高速旋转时内部会产生一定量的热，导致密封环发生热弹变形，从而使运行不稳定和泄漏量增大。首先在速度滑移边界条件下，求出气膜压力和气膜速度；然后推导出气膜的能量微分方程，同时引入温度阶跃边界条件，进而利用气膜的压力、速度和能量方程，通过Matlab软件数值计算得到气膜的温度分布。结果表明，随着气体从外径流入内径，气膜速度的分布规律是先降低后升高，槽根部周围速度较低；随着气体从外径流入内径，气膜温度的分布规律是先升高后降低，槽根部周围温度较高；考虑温度阶跃下的温度分布与不考虑温度阶跃下的温度分布相差较小，可以不予考虑温度阶跃对干气密封气膜温度的影响。

关键词: 干气密封, 微尺度, 气膜, 流体力学, 数值模拟

Abstract: The spiral groove dry gas seal generates a certain amount of heat when running at high speed and pressure, which will lead to the thermo-elastic deformation of the sealing ring. Consequently, unstable operation and leakage increase will appear. The gas film pressure and velocity can be obtained based on the boundary condition of velocity-slip and the energy equation for the gas film is derived in this paper with the boundary condition of temperature-jump. The temperature distribution in the gas film can be solved by using the film pressure, velocity and energy equation with the numerical calculation of the software Matlab. The results show that the gas film velocity decreases first and then increases as the gas flows from the external into the interior and the velocity is smaller near the groove root, while the film temperature increases first and then decreases and the temperature is higher near the groove root. The film temperature distribution has little difference with and without considering the temperature-jump. The effect of the temperature-jump on the gas film temperature could be ignored.

Key words: dry gas seal, microscale, gas film, fluid mechanics, numerical simulation

中图分类号:

TB42
TQ051

丁雪兴, 刘勇, 张伟政, 张英杰. 螺旋槽干气密封微尺度气膜的温度场计算[J]. 化工学报, 2014, 65(4): 1353-1358.

DING Xuexing, LIU Yong, ZHANG Weizheng, ZHANG Yingjie. Calculation of temperature field of micro-scale gas film in spiral groove dry gas seal[J]. CIESC Journal, 2014, 65(4): 1353-1358.

参考文献

[1] Gad-el-Hak M. The fluid mechanics of micro devices—the Freeman scholar lecture [J]. Transactions of the ASME, Journal of Fluids Engineering, 1999, 121: 5-33
[2] Gad-el-Hak M. Review: flow physics in MEMS [J]. Mecanique and Industries, 2001, 2: 313-341
[3] Kassner M E, Nemat-Nasser S, Suo Z. New directions in mechanics [J]. Mechanics of Materials, 2005, 37: 231-259
[4] Jiang Xiaowen(蒋小文), Gu Boqin(顾伯勤). Characteristic of gas film between spiral groove dry gas seal faces [J]. Journal of Chemical Industry and Engineering (China) (化工学报), 2005, 56(8): 1419-1452
[5] Beskok A, Karniadakis G E, Trimmer W. Rarefaction and compressibility effects in gas micro flows [J]. Journal of Fluids Engineering, 1996, 118(5): 448-456
[6] Ma Zheshu(马哲树), Yao Shouguang(姚寿广), Ming Xiao(明晓). Microscale heat transfer and its investigation progress [J]. Nature Magazine (自然杂志), 2003, 25(2): 76-79
[7] Sparrow E M, Lin S H. Laminar heat transfer in tubes under slip-flow conditions [J]. Journal of Heat Transfer,1962, 84( 4): 363-369
[8] Jiang Peixue(姜培学), Wang Buxuan(王补宣), Ren Zepei(任泽霈). Micro heat exchanger and relevant problems [J]. Journal of Engineering Thermophysics (工程热物理学报), 1996, 17(3): 328-332
[9] Pecht G G, Netzel J P. Design and application of non-contacting gas lubricated seals for slow-speed service [J]. Lubrication Engineering, 1999, 55(7): 20-25
[10] Ruan B. Finite element analysis of the spiral groove gas face at the slow speed and the low pressure condition-slip flow consideration [J]. Tribology Trans., 2000, 43(3): 411-418
[11] Xu Pengxian(许鹏先), Pan Qi(潘琦), Shen Gaizhang(申改章). Simulation of the dry gas seal with slip boundary [J]. Lubrication Engineering (润滑与密封), 2007, 32(5): 98-101
[12] Yin Xiaoni(尹晓妮), Peng Xudong(彭旭东). Finite element analysis of a dry gas seal under slip flow conditions [J]. Lubrication Engineering (润滑与密封), 2006, 31(4): 55-57
[13] Offermann S, Beaudoin J L, Bissieux C, Frick H. Thermoelastic stress analysis under nonadiabatic conditions [J]. Experimental Mechanics, 1997, 37(4): 409-413
[14] Li Dongyang(李东阳), Li Jiyun(李纪云), Bai Shaoxian(白少先), Meng Xiangkai(孟祥凯). State-of-the-art of non-contacting dry gas face seals [J]. Lubrication Engineering (润滑与密封), 2009, 34(8): 105-110
[15] Ding Xuexing(丁雪兴), Pu Junjun(蒲军军), Han Mingjun(韩明君), Zhang Weizheng(张伟政), Yu Shurong(俞树荣). Calculation and analysis of gas film stiffness in the spiral groove gas seal based on the second order slip boundary [J]. Journal of Mechanical Engineering (机械工程学报), 2011, 47(23): 119-124
[16] Ding Xuexing(丁雪兴), Chen Delin(陈德林), Zhang Weizheng(张伟政), Yu Shurong(俞树荣), Du Zhaonian(杜兆年). Approximate calculation and parameters optimization for micro-scale flow field in spiral grooved gas seals [J]. Chinese Journal of Applied Mechanics (应用力学学报), 2007, 24(3): 425-428
[17] Ding Xuexing(丁雪兴), Su Hong(苏虹), Pu Junjun(蒲军军), Zhang Haizhou(张海舟), Zhang Weizheng(张伟政). Leakage calculation and analysis for the spiral groove dry gas seal based on the second-order slip boundary [J]. Chinese Journal of Applied Mechanics (应用力学学报), 2013, 30(1): 49-54
[18] Zhang Jingzhou(张靖周), Chang Haiping(常海萍). Heat Transfer (传热学) [M]. Beijing: Science Press, 2009: 98-100
[19] Sun Hongwei(孙宏伟), Gu Weizao(顾维藻), Liu Wenyan(刘文艳). Effects of slip-flow and temperature-jump on momentum and heat transport in micro-channels [J]. Journal of Engineering Thermophysics (工程热物理学报), 1998, 19(1): 94-97
[20] Zhu Xun(朱恂). Flow and heat transfer characteristics in microchannel in velocity-slip and temperature-jump regime [D]. Chongqing: Chongqing University, 2002

螺旋槽干气密封微尺度气膜的温度场计算

Calculation of temperature field of micro-scale gas film in spiral groove dry gas seal

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价

[1]	宋嘉豪, 王文. 斯特林发动机与高温热管耦合运行特性研究[J]. 化工学报, 2023, 74(S1): 287-294.
[2]	张思雨, 殷勇高, 贾鹏琦, 叶威. 双U型地埋管群跨季节蓄热特性研究[J]. 化工学报, 2023, 74(S1): 295-301.
[3]	肖明堃, 杨光, 黄永华, 吴静怡. 浸没孔液氧气泡动力学数值研究[J]. 化工学报, 2023, 74(S1): 87-95.
[4]	苏伟, 马东旭, 金旭, 刘忠彦, 张小松. 表面润湿性对霜层传递特性影响可视化实验研究[J]. 化工学报, 2023, 74(S1): 122-131.
[5]	叶展羽, 山訸, 徐震原. 用于太阳能蒸发的折纸式蒸发器性能仿真[J]. 化工学报, 2023, 74(S1): 132-140.
[6]	张义飞, 刘舫辰, 张双星, 杜文静. 超临界二氧化碳用印刷电路板式换热器性能分析[J]. 化工学报, 2023, 74(S1): 183-190.
[7]	王志国, 薛孟, 董芋双, 张田震, 秦晓凯, 韩强. 基于裂隙粗糙性表征方法的地热岩体热流耦合数值模拟与分析[J]. 化工学报, 2023, 74(S1): 223-234.
[8]	温凯杰, 郭力, 夏诏杰, 陈建华. 一种耦合CFD与深度学习的气固快速模拟方法[J]. 化工学报, 2023, 74(9): 3775-3785.
[9]	王玉兵, 李杰, 詹宏波, 朱光亚, 张大林. R134a在菱形离散肋微小通道内的流动沸腾换热实验研究[J]. 化工学报, 2023, 74(9): 3797-3806.
[10]	何松, 刘乔迈, 谢广烁, 王斯民, 肖娟. 高浓度水煤浆管道气膜减阻两相流模拟及代理辅助优化[J]. 化工学报, 2023, 74(9): 3766-3774.
[11]	陈美思, 陈威达, 李鑫垚, 李尚予, 吴有庭, 张锋, 张志炳. 硅基离子液体微颗粒强化气体捕集与转化的研究进展[J]. 化工学报, 2023, 74(9): 3628-3639.
[12]	程小松, 殷勇高, 车春文. 不同工质在溶液除湿真空再生系统中的性能对比[J]. 化工学报, 2023, 74(8): 3494-3501.
[13]	刘文竹, 云和明, 王宝雪, 胡明哲, 仲崇龙. 基于场协同和耗散的微通道拓扑优化研究[J]. 化工学报, 2023, 74(8): 3329-3341.
[14]	洪瑞, 袁宝强, 杜文静. 垂直上升管内超临界二氧化碳传热恶化机理分析[J]. 化工学报, 2023, 74(8): 3309-3319.
[15]	岳林静, 廖艺涵, 薛源, 李雪洁, 李玉星, 刘翠伟. 凹坑缺陷对厚孔板喉部空化流动特性影响研究[J]. 化工学报, 2023, 74(8): 3292-3308.