碳氢燃料热裂解与引发裂解换热对比实验

doi:10.3969/j.issn.0438-1157.2014.z1.022

化工学报 ›› 2014, Vol. 65 ›› Issue (S1): 138-143.DOI: 10.3969/j.issn.0438-1157.2014.z1.022

碳氢燃料热裂解与引发裂解换热对比实验

贾贞健¹, 周伟星², 黄洪雁¹, 于文力¹

1. 哈尔滨工业大学能源科学与工程学院, 黑龙江哈尔滨 150001;
2. 哈尔滨工业大学基础与交叉科学研究院, 黑龙江哈尔滨 150001

收稿日期:2014-01-23 修回日期:2014-01-31 出版日期:2014-05-30 发布日期:2014-05-30
通讯作者: 周伟星
基金资助:
国家自然科学基金项目（11079017）。

Heat transfer of thermal cracking and initiated cracking of aviation kerosene

JIA Zhenjian¹, ZHOU Weixing², HUANG Hongyan¹, YU Wenli¹

1. School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, Heilongjiang, China;
2. Academy of Fundamental and Interdisciplinary Sciences, Harbin Institute of Technology, Harbin 150001, Heilongjiang, China

Received:2014-01-23 Revised:2014-01-31 Online:2014-05-30 Published:2014-05-30
Supported by:
supported by the National Natural Science Foundation of China (11079017).

摘要/Abstract

摘要： 通过流动管反应器对碳氢燃料RP-3在超临界条件下的热裂解及引发裂解进行了实验，对两种条件下的燃料吸热能力及传热特性进行了对比分析，并对裂解产物进行了采样分析。结果表明，引发裂解降低了燃料的裂解起始温度，在一定温度区间内提高了燃料的裂解率，从而有效提高了燃料热沉，在相同热通量条件下，降低了燃料温度，并降低了加热段壁面温度。对流换热受化学反应及物性变化的影响，燃料裂解吸热可增强换热，而大量气态产物的生成会降低换热，因此，裂解反应的增强不一定增强换热。

关键词: 热裂解, 引发裂解, RP-3, 换热, 热沉, 超临界

Abstract: Nitro-propane (NP) was employed as the initiator to investigate the effect of initiated cracking on heat transfer of aviation fuel RP-3 with a one-stage and cracking system operating under supercritical pressure. The pyrolysis products are analyzed using a chromatograph/mass spectrometry (GC-MS). The heat sink, conversion rate and heat transfer coefficient were calculated based on the experimental results. Experimental results indicate that the heat transfer characteristics are influenced by the pyrolysis rate and physical property change caused by products distribution. NP accelerates the pyrolysis and increases the heat sink of fuel in temperature range of 800 K to 900 K. Under the same heat flux conditions, the effects of NP are reflected in the reduction of fuel and wall temperature. The reductions of fuel and wall temperature increase first and decrease along the flow direction, and the maximum decrease is more than 10 K. However, the Reynolds numbers decrease because of large amount gaseous products generated by pyrolysis reaction, which has negative effect on the convective heat transfer. So the influence of initiated cracking on the heat transfer of RP-3 is not a simple effect of promotion or inhibition, the regularity is different in different temperature ranges.

Key words: thermal cracking, initiated cracking, RP-3, heat transfer, heat sink, supercritical

中图分类号:

TQ028.8

贾贞健, 周伟星, 黄洪雁, 于文力. 碳氢燃料热裂解与引发裂解换热对比实验[J]. 化工学报, 2014, 65(S1): 138-143.

JIA Zhenjian, ZHOU Weixing, HUANG Hongyan, YU Wenli. Heat transfer of thermal cracking and initiated cracking of aviation kerosene[J]. CIESC Journal, 2014, 65(S1): 138-143.

参考文献 20

[1]	Wagner W R, Shoji J M. Advanced regenerative cooling techniques for future space transportation systems[R]. AIAA-1975-1247. 1975
[2]	Lander H, Nixon A C. Endothermic fuels for hypersonic vehicles[J]. Journal of Aircraft, 1971, 8(4): 200-207
[3]	Sobel D R, Spadaccini L J. Hydrocarbon fuel cooling technologies for advanced propulsion[J]. Journal of Engineering for Gas Turbines and Power, 1997, 119(2): 344-351.
[4]	Zhou P, Crynes B L. Thermolytic reactions of dodecane[J]. Industrial & Engineering Chemistry Process Design and Development, 1986, 25(2): 508-514
[5]	Ianovski L S, Clifford M. AGARD conference proceeding 536//the Propulsion and Energetics Panel 81st Symposium[C]. Italy, 1993
[6]	Wickham D T, Engel J R, Hitch B D, et al. Initiators for endothermic fuels[J]. Journal of Propulsion and Power, 2001, 17(6): 1253-1257
[7]	Wickham D T, Engel J R, Rooney S, et al. Additives to improve fuel heat sink capacity in air/fuel heat exchangers[J]. Journal of Propulsion and Power, 2008, 24(1): 55-63
[8]	Wang Z, Lin R, Fang W, et al. Triethylamine as an initiator for cracking of heptane[J]. Energy, 2006, 31(14): 2773-2790
[9]	Liu G, Han Y, Wang L, et al. Supercritical thermal cracking of n-dodecane in presence of several initiative additives: products distribution and kinetics[J]. Energy & Fuels, 2008, 22(6): 3960-3969
[10]	Guan Y, Yang B, Qi S, et al. Kinetic modeling of the free-radical process during the initiated thermal cracking of normal alkanes with 1-nitropropane as an initiator[J]. Industrial & Engineering Chemistry Research, 2011, 50(15): 9054-9062
[11]	Chakraborty J P, Kunzru D. High-pressure pyrolysis of n-heptane: effect of initiators[J]. Journal of Analytical and Applied Pyrolysis, 2012, 95: 48-55
[12]	Wang Q D, Hua X X, Cheng X M, et al. Effects of fuel additives on the thermal cracking of n-decane from reactive molecular dynamics[J]. The Journal of Physical Chemistry A, 2012, 116(15): 3794-3801
[13]	Zhong F, Fan X, Yu G, et al. Heat transfer of aviation kerosene at supercritical conditions[J]. Journal of Thermophysics and Heat Transfer, 2009, 23(3): 543-550
[14]	Zhang C, Xu G, Gao L, et al. Experimental investigation on heat transfer of a specific fuel (RP-3) flows through downward tubes at supercritical pressure[J]. The Journal of Supercritical Fluids, 2012
[15]	Hou Lingyun, Dong Ning, Sun Dapeng. Heat transfer and thermal cracking behavior of hydrocarbon fuel[J]. Fuel, 2013, 103: 1132-1137
[16]	Jiang R, Liu G, Zhang X. Thermal cracking of hydrocarbon aviation fuels in regenerative cooling microchannels[J]. Energy & Fuels, 2013, 27(5): 2563-2577
[17]	Song K D, Choi S H, Scotti S J. Transportation cooling experiment for scram jet engine combustion chamber by high heat fluxes[J]. Journal of Propulsion and Power, 2006, 22(1): 96-102
[18]	Chung T H, Ajlan M, Lee L L, Starling K E. Generalized multiparameter correlation for nonpolar and polar fluid transport-properties[J]. Industrial & Engineering Chemistry Research, 1988, 27(4): 671-679
[19]	Kim S, Choi H, Kim Y. Thermodynamic modeling based on a generalized cubic equation of state for kerosene/LOem>x rocket combustion[J]. Combustion and Flame, 2012, 159: 1351-1365
[20]	Meng H, Yang V. A unified treatment of general fluid thermodynamics and its application to a preconditioning scheme[J]. Journal of Computational Physics, 2003, 189: 277-304

碳氢燃料热裂解与引发裂解换热对比实验

Heat transfer of thermal cracking and initiated cracking of aviation kerosene

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 20

相关文章 15

编辑推荐

Metrics

本文评价

[1]	宋瑞涛, 王派, 王云鹏, 李敏霞, 党超镔, 陈振国, 童欢, 周佳琦. 二氧化碳直接蒸发冰场排管内流动沸腾换热数值模拟分析[J]. 化工学报, 2023, 74(S1): 96-103.
[2]	张龙, 宋孟杰, 邵苛苛, 张旋, 沈俊, 高润淼, 甄泽康, 江正勇. 管翅式换热器迎风侧翅片末端霜层生长模拟研究[J]. 化工学报, 2023, 74(S1): 179-182.
[3]	张义飞, 刘舫辰, 张双星, 杜文静. 超临界二氧化碳用印刷电路板式换热器性能分析[J]. 化工学报, 2023, 74(S1): 183-190.
[4]	邹启宏, 李乾, 葛天舒. 基于多目标下的两级并联除湿热泵系统实验研究[J]. 化工学报, 2023, 74(S1): 265-271.
[5]	陈哲文, 魏俊杰, 张玉明. 超临界水煤气化耦合SOFC发电系统集成及其能量转化机制[J]. 化工学报, 2023, 74(9): 3888-3902.
[6]	洪瑞, 袁宝强, 杜文静. 垂直上升管内超临界二氧化碳传热恶化机理分析[J]. 化工学报, 2023, 74(8): 3309-3319.
[7]	董明, 徐进良, 刘广林. 超临界水非均质特性分子动力学研究[J]. 化工学报, 2023, 74(7): 2836-2847.
[8]	李艳辉, 丁邵明, 白周央, 张一楠, 于智红, 邢利梅, 高鹏飞, 王永贞. 非常规服役超临界锅炉的微纳尺度腐蚀动力学模型建立及应用[J]. 化工学报, 2023, 74(6): 2436-2446.
[9]	姚晓宇, 沈俊, 李健, 李振兴, 康慧芳, 唐博, 董学强, 公茂琼. 流体气液临界参数测量方法研究进展[J]. 化工学报, 2023, 74(5): 1847-1861.
[10]	潘煜, 王子航, 王佳韵, 王如竹, 张华. 基于可得然-氯化锂复合吸附剂的除湿换热器热湿性能研究[J]. 化工学报, 2023, 74(3): 1352-1359.
[11]	朱兵国, 何吉祥, 徐进良, 彭斌. 冷却条件下渐扩/渐缩管内超临界压力二氧化碳的传热特性[J]. 化工学报, 2023, 74(3): 1062-1072.
[12]	袁海鸥, 叶方俊, 张硕, 罗祎青, 袁希钢. 考虑中间换热器的能量集成精馏序列合成[J]. 化工学报, 2023, 74(2): 796-806.
[13]	鲁军辉, 李俊明. H₂O-CO₂、H₂O-N₂、H₂O-He水平管外自然对流凝结换热特性研究[J]. 化工学报, 2022, 73(9): 3870-3879.
[14]	戚新刚, 路利波, 陈渝楠, 葛志伟, 郭烈锦. 造纸黑液超临界水气化制氢与高附加值化学品回收研究进展[J]. 化工学报, 2022, 73(8): 3338-3354.
[15]	陆威, 苗冉, 吴志根, 吴长春, 谢伟. 非牛顿流体在波节套管换热器中流动与换热的实验研究[J]. 化工学报, 2022, 73(7): 2924-2932.