换热器通道内反向旋转纵向涡间的干涉特性

doi:10.11949/j.issn.0438-1157.20150618

摘要/Abstract

摘要：

纵向涡能以较小的压力损失获得较大程度的传热强化,在换热器空气侧强化传热中得到了广泛应用。换热器通道内通常存在多个纵向涡,纵向涡之间的干涉会不可避免地影响纵向涡的强度和强化传热性能。建立了换热器通道中旋转方向相反的两个纵向涡之间的干涉模型,通过数值方法分析了不同涡产生器横向间距下纵向涡之间的干涉现象。通过纵向涡强度定量研究了涡间干涉对纵向涡强度、流动阻力以及强化换热的影响。结果表明:旋转方向相反的两个纵向涡之间的干涉随着涡产生器间距的减小而增大;在涡产生器间距为零时纵向涡间干涉程度最大,纵向涡强度Se、Nu以及阻力系数f的变化量均达到最小值;在本文计算参数范围内,纵向涡引起的Se和Nu的变化量最大差别达到45%和50%,f的变化达到38%;纵向涡干涉并非一定不利于换热,纵向涡干涉后的流动结构影响其强化传热性能。在涡产生器横向间距为涡产生器底边横向投影长度的2倍时,可以利用纵向涡干涉获得最佳传热性能。

关键词: 纵向涡, 强度, 干涉, 对流, 传热, 数值分析

Abstract:

Longitudinal vortices can enhance heat transfer with small pressure loss penalty and has been widely applied in heat transfer enhancement of tube bank fin heat exchangers. Setting winglet vortex generator (VG) that can generate longitudinal vortices on the fin surface is a promising technique to enhance the airside heat transfer. In order to obtain better heat transfer performance, lots of VGs are punched out of the fin surface, so several longitudinal vortices appear in the flow channel. The interaction of vortices affects the intensity of longitudinal vortices and their effect on heat transfer enhancement. In this paper, the interaction of counter rotating longitudinal vortices generated by winglet VGs is quantitatively analyzed under different transversal distances between VGs. The effects of interaction of vortices on the intensity of vortices, flow field structure and heat transfer are discussed in detail by using the longitudinal vortex intensity parameter Se. The results show that the interaction of counter rotating longitudinal vortices increases with the decrease of transversal distance between VGs. When the distance between VGs is zero, the interaction between counter rotating vortices is the most serious, while the values of ΔSe, ΔNu and Δf get the minimum values. The maximum decreasing percentage of ΔSe, ΔNu and Δf are 45%, 50% and 38%, respectively. The interaction between counter rotating vortices does not necessarily decrease the heat transfer of longitudinal vortices. The heat transfer performance depends on not only the intensity of vortices but also their structure. The common flow region formed between counter rotating longitudinal vortices is beneficial for heat transfer enhancement. Due to the interactions of counter rotating longitudinal vortices and their effect on heat transfer enhancement, an optimum arrangement of VGs exists for better heat transfer performance. The best heat transfer performance can be obtained when the transversal distance between the VGs is twice the projected length of the base of VGs.

Key words: longitudinal vortex, intensity, interaction, convective, heat transfer, numerical analysis

中图分类号:

TK121

宋克伟, 刘松, 王良璧. 换热器通道内反向旋转纵向涡间的干涉特性[J]. 化工学报, 2016, 67(4): 1233-1243.

SONG Kewei, LIU Song, WANG Liangbi. Interaction characteristics between longitudinal vortices with counter-rotating directions in heat exchanger channel[J]. CIESC Journal, 2016, 67(4): 1233-1243.

参考文献 28

[1]	FIEBIG M. Vortex generators for compact heat exchangers[J]. Enhanced Heat Transfer, 1995, 2: 43-61.
[2]	JACOBI A M, SHAH R K. Heat transfer surface enhancement through the use of longitudinal vortices: a review of recent progress[J]. Experimental Thermal and Fluid Science, 1995, 11: 295-309.
[3]	BISWAS G, DEB P, BISWAS S. Generation of longitudinal streamwise vortices— a device for improving heat exchanger design[J]. J. Heat Transfer, 1994, 116: 588-597.
[4]	FIEBIG M, MITRA N, DONG Y. Simultaneous heat transfer enhancement and flow loss reduction of fin tubes[J]. Ninth Int. Heat Transfer Conf. Jerusalem, Israel, 1990, 4: 51-56.
[5]	WANG C C, LO J. Flow visualization of annular and delta winglet vortex generators in fin-and-tube heat exchanger application[J]. International Journal of Heat and Mass Transfer, 2002, 45: 3803-3815.
[6]	CHU P, HE Y L, TAO W Q. Three-dimensional numerical study of flow and heat transfer enhancement using vortex generators in fin-and-tube heat exchangers[J]. ASME Journal of Heat Transfer, 2009, 131: 1-9.
[7]	WU J M, TAO W Q. Impact of delta winglet vortex generators on the performance of a novel fin-tube surfaces with two rows of tubes in different diameters[J]. Energy Conversion and Management, 2011, 52(8/9): 2895-2901.
[8]	LEI Y G, HE Y L. TIAN L T, et al. Hydrodynamics and heat transfer characteristics of a novel heat exchanger with delta-winglet vortex generators[J]. Chemical Engineering Science, 2010, 65: 1551-1562.
[9]	ZHANG Y H, WANG L B, SONG K W. Comparison of heat transfer performance of tube bank fin with mounted vortex generators to tube bank fin with punched vortex generators[J]. Experimental Thermal Fluid Science, 2008, 33: 58-66.
[10]	WANG L B, ZHANG Y H, SU Y X. Local and average heat/mass transfer over flat tube bank fin mounted in-line vortex generators with small longitudinal spacing[J]. Journal of Enhanced Heat Transfer, 2002, 9: 77-87.
[11]	何雅玲, 楚攀, 谢涛. 纵向涡发生器在管翅式换热器中的应用及优化[J]. 化工学报, 2012, 63(3): 746-760. DOI: 10.3969/j.issn. 0438-1157.2012.03.011. HE Y L, CHU P, XIE T. Application and optimization of fin-and-tube heat exchangers with longitudinal vortex generators[J]. CIESC Journal, 2012, 63(3): 746-760. DOI: 10.3969/j.issn. 0438-1157. 2012.03.011.
[12]	BISWAS G, CHATTOPADHYAY H. Heat transfer in a channel with built-in wing-type vortex generators[J]. International Journal of Heat and Mass Transfer, 1992, 35: 803-814.
[13]	WANG Q W, CHEN Q Y, WANG L. Experimental study of heat transfer enhancement in narrow rectangular channel with longitudinal vortex generators[J]. Nuclear Engineering and Design, 2007, 237: 686-693.
[14]	车翠翠, 田茂诚, 冷学礼, 等. 不同翼片扰流特性的PIV对比实验[J]. 化工学报, 2014, 65(S1): 11-16. DOI: 10.3969/j.issn.0438-1157. 2014.z1.003. CHE C C, TIAN M C, LENG X L, et al. PIV experiment on turbulence characteristic with different winglets inserted[J]. CIESC Journal, 2014, 65(S1): 11-16. DOI: 10.3969/j.issn.0438-1157. 2014.z1.003.
[15]	汉京晓, 周国兵. 平直和柱面小翼涡发生器诱发流动特性PIV实验研究[J]. 化工学报, 2013, 64(8): 2774-2780. DOI: 10.3969/j.issn. 0438-1157.2013.08.010. HAN J X, ZHOU G B. PIV investigation on induced flow characteristics in cylindrical winglet vortex generators[J]. CIESC Journal, 2013, 64(8): 2774-2780. DOI: 10.3969/j.issn. 0438-1157.2013.08.010.
[16]	GENTRY M C, JACOBI A M. Heat transfer enhancement by delta-wing vortex generators on a flat plate: vortex interactions with the boundary layer[J]. Experimental Thermal and Fluid Science, 1997, 14(3): 231-242.
[17]	EIBECK P A, EATON J K. Heat transfer effects of a longitudinal vortex embedded in a turbulent boundary layer[J]. Journal of Heat Transfer, 1987, 109: 16-24.
[18]	KIM W J, PATEL V C. Influence of streamwise curvature on longitudinal vortices embedded in turbulent boundary layers[J]. Journal of Computers Fluid, 1994, 23(5): 647-673.
[19]	PAULEY W R, EATON J K. The effect of embedded longitudinal vortex arrays on turbulent boundary layer heat transfer[J]. Journal of Heat Transfer, 1994, 116(4): 871-879.
[20]	YANG J S, SEO J K, LEE K B. A numerical analysis on flow field and heat transfer by interaction between a pair of vortices in rectangular channel flow[J]. Current Applied Physics, 2001, 1: 393-405.
[21]	宋克伟, 常立民, 王良璧. 涡干涉的流动显示与数值模拟[J]. 兰州交通大学学报, 2005, 24(6): 10-13. SONG K W, CHANG L M, WANG L B. Flow visualization and numerical simulation about the interactions of vortices[J]. Journal of Lanzhou Jiaotong University, 2005, 24(6): 10-13.
[22]	LIU S, WANG L B, FAN J F, et al. Tube transverse pitch effect on heat mass transfer characteristics of flat tube bank fin mounted with vortex generators[J]. Journal of Heat Transfer, 2008, 130: 064501.
[23]	ZHU C L, HUA L, SUN D L, et al. Numerical study of interactions of vortices generated by vortex generators and their effects on heat transfer enhancement[J]. Numerical Heat Transfer. Part A: Applications, 2006, 50(4): 353-368.
[24]	MANGLIK R M, BERGLES A E. Heat transfer and pressure drop correlations for twisted-tape inserts in isothermal tubes(Ⅰ): Laminar flows[J]. ASME Journal of Heat Transfer, 1993, 115: 881-889.
[25]	DEAN W R. Note on the motion of fluid in a curved pipe[J]. Philosophical Magazine, 1927, 20: 208-223.
[26]	SONG K W, WANG L B. Relationship between heat transfer intensity and absolute vorticity flux intensity in flat tube bank fin channels with vortex generators[J]. Progress in Computational Fluid Dynamics, 2008, 8 (7/8): 496-502.
[27]	CHANG L M, WANG L B, SONG K W, et al. Numerical study of the relationship between heat transfer enhancement and absolute vorticity flux along main flow direction in a channel formed by a flat tube bank fin with vortex generators[J]. International Journal of Heat and Mass Transfer, 2009, 52: 1794-1801.
[28]	SONG K W, WANG L B. The effectiveness of secondary flow produced by vortex generators mounted on both surfaces of the fin to enhance heat transfer in a flat tube bank fin heat exchanger[J]. ASME Journal of Heat Transfer, 2013, 135: 041902.