阳极进气湿度对质子交换膜水含量及电流密度分布影响

doi:10.11949/j.issn.0438-1157.20151254

化工学报 ›› 2015, Vol. 66 ›› Issue (S2): 342-348.DOI: 10.11949/j.issn.0438-1157.20151254

阳极进气湿度对质子交换膜水含量及电流密度分布影响

王学科^1,2, 王树博², 潘元¹, 谢晓峰^2,3, 黄海燕³, 朱彤¹

1. 东北大学机械工程与自动化学院, 辽宁沈阳 110819;
2. 清华大学核能与新能源技术研究院, 北京 100084;
3. 清华大学汽车安全与节能国家重点实验室, 北京 100084

收稿日期:2015-07-03 修回日期:2015-07-08 出版日期:2015-08-31 发布日期:2015-08-31
通讯作者: 谢晓峰, 朱彤
基金资助:
国家高技术研究发展计划项目(2012AA053401);国家重点基础研究发展计划项目(2012CB215500);汽车安全与节能国家重点实验室(KF14162)。

Effect of anode inlet gas humidification on PEM water contents and current density distribution

WANG Xueke^1,2, WANG Shubo², PAN Yuan¹, XIE Xiaofeng^2,3, HUANG Haiyan³, ZHU Tong¹

1. School of Mechanical Engineering and Automation, Northeastern University, Shenyang 110819, Liaoning, China;
2. Institute of Nuclear and New Energy Technology, Tsinghua University, Beijing 100084, China;
3. State Key Laboratory of Automotive Safety and Energy, Tsinghua University, Beijing 100084, China

Received:2015-07-03 Revised:2015-07-08 Online:2015-08-31 Published:2015-08-31
Supported by:
supported by the National High Technology Research and Development Program of China(2012AA053401),the National Basic Research Program of China(2012CB215500)and State Key Laboratory of Automotive Safety and Energy(KF14162).

摘要/Abstract

摘要：

针对质子交换膜中水分布不均匀造成燃料电池性能降低的问题,将膜和催化层中水传递方程进行耦合实现水在膜和催化层之间连续传递,建立了质子交换膜燃料电池三维稳态模型。利用有限元分析软件COMSOL进行模拟计算,研究了阳极气体在不同湿度下膜电流密度分布并组装单电池进行了验证,分析实验模拟结果表明:模拟极化曲线与实验极化曲线吻合良好。湿度对电流密度分布影响很大,低湿度条件下,脊背下方电流密度大于气体流道下方;高湿度条件下,电流密度分布比较均匀;采用Nafion117较厚膜时,高电流密度下,即使阳极加湿,阳极侧也有脱水的可能。

关键词: 质子交换膜, 燃料电池, 增湿, 电流密度分布, 数值模拟

Abstract:

A three dimensional model was proposed to study water transport phenomena in the membrane as well as the performance of PEMFC under various relative humidity(RH)of anode inlet gas.This model couples the conservation equations of the water concentration in membrane and the catalyst layer using a set of internal boundary conditions at the interface.The model was realized based on the COMSOL software and the simulated polarization curves are found in good agreement with the experiments thus confirming the validity of the model.The numerical results show that the humidification strongly influences the current density so as to affect the cell efficiency.Under low humidification conditions of anode inlet gas,the membrane current density below rib is greater than the gas flow channel,however,under the high humidity conditions,membrane current density distribution is uniform.Using thicker film,such as Nafion 117,the membrane of anode side has the potential of dehydration under high current density even if anode inlet gas be humidified.

Key words: PEM, fuel cell, humidification, current density distribution, numerical simulation

中图分类号:

TK91

王学科, 王树博, 潘元, 谢晓峰, 黄海燕, 朱彤. 阳极进气湿度对质子交换膜水含量及电流密度分布影响[J]. 化工学报, 2015, 66(S2): 342-348.

WANG Xueke, WANG Shubo, PAN Yuan, XIE Xiaofeng, HUANG Haiyan, ZHU Tong. Effect of anode inlet gas humidification on PEM water contents and current density distribution[J]. CIESC Journal, 2015, 66(S2): 342-348.

参考文献 15

[1]	Springer T E,Zawodzinski T A,Gottesfeld S.Polymer electrolyte fuel cell model[J].Journal of the Electrochemical Society,1991,138(8):2334-2342.
[2]	Falcão D S,Oliveira V B,Rangel C M,Pintoa A M F R. Water transport through a PEM fuel cell:a one dimensional model with heat transfer effects[J].Chemical Engineering Science,2009,64(9):2216-2225.
[3]	Karpenko-jereb L,Innerwinkler P,Kelterer A M,Sterning C,Fink C,Prenninger P,Tatschl R.A novel membrane transport model for polymer electrolyte fuel cell simulations[J].International Journal of Hydrogen Energy,2014,39(13):7077-7088.
[4]	Singh D,Lu D M,Djilali N.A two-dimensional analysis of mass transport in porton exchange membrane fuel cells[J].International Journal of Engineering Science,1999,37(4):431-452.
[5]	Sahraoui Bichioui.Three-dimensional modeling of water transport in PEMFC[J].International Journal of Hydrogen Energy,2013,38(20):8524-8531.
[6]	Wu Xi(吴曦),Zhang Dongyun(张冬云),Jiang Qizhong(蒋淇忠),Ma Zifeng(马紫峰).Application of spherical agglomerate model in PEMFC process simulation[J].CIESC Journal(化工学报),2010,61(10):2694-2702.
[7]	Shen Jun(沈俊),Zhou Bing(周兵),Qiu Zizhao(邱子朝),Tu Zhengkai(涂正凯),Liu Zhichun(刘志春),Liu Wei(刘伟).Mass transfer enhancement of porton exchange membrane fuel cell[J].CIESC Journal(化工学报),2014,65(S1):421-425.
[8]	Matamoros L,Brggemann D.Concentration and ohmic losses in free-breathing PEMFC[J].Journal of Power Sources,2007,173(1):367-374.
[9]	Melik Sahraoui,Youssef Bichioui,Kamel Halouani.Three-dimensional modeling of water transport in PEMFC[J].International Journal of Hydrogen Energy,2012,38(20):8524-8531.
[10]	Al-Baghdadi M A R S,Al-Janabi H A K S.Parametric and optimization study of a PEM fuel cell performance using three-dimensional computational fluid dynamics model.[J].Renewable Energy,2007,32(7):1077-1101.
[11]	Meng Hua.A three-dimensional PEM fuel cell model with consistent treatment of water transport in MEA[J].Journal of Power Sources,2006,162:426-435.
[12]	Adam Z Weber,Tohn Newman.Transport in polymer-electrolyte membranes(I):Physical model[J].Journal of the Electrochemical Society,2003,150(7):1008-1015.
[13]	Motupally S,Becker A J,Weidner J W.Diffusion of water in Nafion 115 membranes[J].Electrochem.Soc.,2003,147(9):3171.
[14]	Zawodzinki T A,Springer T E,Ubribe F,Gottesfeld S.Characterization of polymer electrolytes for fuel cell applications[J].Solid State Ionics,1993,60:199-211.
[15]	Zhuge Weilin(诸葛伟林),Zhang Yangjun(张杨军),Ming Pingwen(明平文),Lao Xingsheng(劳星胜),Chen Xiao(陈潇).Numerical simulation of three dimensional gas/liquid two phase flow in a proton exchange membrane fuel cell[J].J.Tsinghua Univ.:Sci.&Tech.(清华大学学报:自然科学版),2006,46(2):252-256.

阳极进气湿度对质子交换膜水含量及电流密度分布影响

Effect of anode inlet gas humidification on PEM water contents and current density distribution

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 15

相关文章 15

编辑推荐

Metrics

本文评价

[1]	宋嘉豪, 王文. 斯特林发动机与高温热管耦合运行特性研究[J]. 化工学报, 2023, 74(S1): 287-294.
[2]	张思雨, 殷勇高, 贾鹏琦, 叶威. 双U型地埋管群跨季节蓄热特性研究[J]. 化工学报, 2023, 74(S1): 295-301.
[3]	叶展羽, 山訸, 徐震原. 用于太阳能蒸发的折纸式蒸发器性能仿真[J]. 化工学报, 2023, 74(S1): 132-140.
[4]	张义飞, 刘舫辰, 张双星, 杜文静. 超临界二氧化碳用印刷电路板式换热器性能分析[J]. 化工学报, 2023, 74(S1): 183-190.
[5]	王志国, 薛孟, 董芋双, 张田震, 秦晓凯, 韩强. 基于裂隙粗糙性表征方法的地热岩体热流耦合数值模拟与分析[J]. 化工学报, 2023, 74(S1): 223-234.
[6]	何松, 刘乔迈, 谢广烁, 王斯民, 肖娟. 高浓度水煤浆管道气膜减阻两相流模拟及代理辅助优化[J]. 化工学报, 2023, 74(9): 3766-3774.
[7]	陈哲文, 魏俊杰, 张玉明. 超临界水煤气化耦合SOFC发电系统集成及其能量转化机制[J]. 化工学报, 2023, 74(9): 3888-3902.
[8]	李艺彤, 郭航, 陈浩, 叶芳. 催化剂非均匀分布的质子交换膜燃料电池操作条件研究[J]. 化工学报, 2023, 74(9): 3831-3840.
[9]	韩晨, 司徒友珉, 朱斌, 许建良, 郭晓镭, 刘海峰. 协同处理废液的多喷嘴粉煤气化炉内反应流动研究[J]. 化工学报, 2023, 74(8): 3266-3278.
[10]	程小松, 殷勇高, 车春文. 不同工质在溶液除湿真空再生系统中的性能对比[J]. 化工学报, 2023, 74(8): 3494-3501.
[11]	刘文竹, 云和明, 王宝雪, 胡明哲, 仲崇龙. 基于场协同和耗散的微通道拓扑优化研究[J]. 化工学报, 2023, 74(8): 3329-3341.
[12]	洪瑞, 袁宝强, 杜文静. 垂直上升管内超临界二氧化碳传热恶化机理分析[J]. 化工学报, 2023, 74(8): 3309-3319.
[13]	邢雷, 苗春雨, 蒋明虎, 赵立新, 李新亚. 井下微型气液旋流分离器优化设计与性能分析[J]. 化工学报, 2023, 74(8): 3394-3406.
[14]	黄可欣, 李彤, 李桉琦, 林梅. 加装旋转叶轮T型通道流场的模态分解[J]. 化工学报, 2023, 74(7): 2848-2857.
[15]	史方哲, 甘云华. 超薄热管启动特性和传热性能数值模拟[J]. 化工学报, 2023, 74(7): 2814-2823.