R134a/R125混合工质水平管外凝结换热

doi:10.3969/j.issn.0438-1157.2014.z1.019

化工学报 ›› 2014, Vol. 65 ›› Issue (S1): 119-124.DOI: 10.3969/j.issn.0438-1157.2014.z1.019

R134a/R125混合工质水平管外凝结换热

张定才¹, 杜佳迪¹, 冀文涛², 张振¹, 朱春洁¹, 何雅玲², 陶文铨²

1. 中原工学院能源与环境学院, 河南省高等学校供热空调重点学科开放实验室, 河南郑州 450007;
2. 西安交通大学能源与动力工程学院, 热流科学与工程教育部重点实验室, 陕西西安 710049

收稿日期:2014-01-22 修回日期:2014-01-29 出版日期:2014-05-30 发布日期:2014-05-30
通讯作者: 张定才
基金资助:
河南省高等学校青年骨干教师资助计划项目；热流科学与工程教育部重点实验室开放基金项目。

Condensation heat transfer of mixed R134a/R125 outside horizontal tubes

ZHANG Dingcai¹, DU Jiadi¹, JI Wentao², ZHANG Zhen¹, ZHU Chunjie¹, HE Yaling², TAO Wenquan²

1. Key Discipline Laboratory of Heating and Air Conditioning of Henan Universities, School of Energy and Environment, Zhongyuan University of Technology, Zhengzhou 450007, Henan, China;
2. Key Laboratory of Thermo-Fluid Science and Engineering of MOE, School of Energy and Power Engineering, Xi'an Jiaotong University, Xi'an 710049, Shaanxi, China

Received:2014-01-22 Revised:2014-01-29 Online:2014-05-30 Published:2014-05-30
Supported by:
supported by Henan Institutions of the Subsidy Scheme for Key Teachers, Key Laboratory of Thermo-Fluid Science and Engineering of MOE.

摘要/Abstract

摘要： 对纯工质R134a以及R134a/R125在三种不同组成比例下的混合工质，在光管和相同肋密度的二维及三维强化管外进行凝结换热试验研究。结果表明：R134a在光管外凝结表面传热系数与Nusselt数理论值的相对偏差均在±10%以内，R134a在光管及强化管外凝结表面传热系数变化趋势与Nusselt数理论解相一致。与纯R134a相比，含R125的混合工质管外凝结表面传热系数均所有下降；对于光管，含R125的混合工质管外凝结表面传热系数随壁面温差的增大而下降，但对于强化管，含6%及以上的R125混合工质，其凝结表面传热系数随壁面温差的增大而增大，有接近纯R134a凝结表面传热系数的趋势，表明混合工质凝结换热热阻分布与纯工质有较大差异。相同组分的工质，三维强化管凝结表面传热系数均高于二维强化管，二维强化管亦明显高于光管，在壁面温差为8 K时，强化管HT-3D、HT-2D相对于光管的传热强化倍率分别为9.83和7.85。

关键词: 双侧强化管, R134a/R125, 混合物, 凝结, 传热

Abstract: Experimental studies of film condensation of R134a and mixed R134a/R125 at three different concentrations have been conducted on three tubes, one is smooth tube, the others are two-dimensional and three-dimensional enhanced tubes at the same fin density. The results indicate that the predicted condensation heat transfer coefficients of R134a on smooth tube from Nusselt theory agree with the experimental data within ±10 percent. The condensation heat transfer coefficients of pure R134a are consistent with Nusselt theoretical trend for smooth and enhanced tubes. Compared with pure R134a, the condensation heat transfer coefficients of mixed R134a/R125 are all decreased. For smooth tube, condensation heat transfer coefficient of mixed refrigerants decreased with the increase of temperature difference. But for enhanced tubes, condensation heat transfer coefficients increased with the increase of temperature difference, which is close to pure R134a at high temperature difference, the mixed refrigerant including 6 percent and more R125. Indicating that condensation heat transfer of mixed refrigerants is quite different with pure refrigerants. Condensation heat transfer coefficient of three-dimensional enhanced tube is higher than that of the two-dimensional tubes, and two-dimensional tube is significantly higher than that of smooth tube at the same working fluid. The condensation heat transfer enhancement factor of HT-3D, HT-2D are 9.83 and 7.85, respectively, which compared with smooth tube at the temperature difference 8 K.

Key words: doubly-enhanced tube, R134a/R125, mixtures, condensation, heat transfer

中图分类号:

TK124

张定才, 杜佳迪, 冀文涛, 张振, 朱春洁, 何雅玲, 陶文铨. R134a/R125混合工质水平管外凝结换热[J]. 化工学报, 2014, 65(S1): 119-124.

ZHANG Dingcai, DU Jiadi, JI Wentao, ZHANG Zhen, ZHU Chunjie, HE Yaling, TAO Wenquan. Condensation heat transfer of mixed R134a/R125 outside horizontal tubes[J]. CIESC Journal, 2014, 65(S1): 119-124.

参考文献 12

[1]	Park Ki-Jung, Jung Dongsoo. Condensation heat transfer coefficient of HCFC22, R410A, R407C and HFC134a at various temperatures on a plain horizontal tube [J]. Journal of Mechanical Science and Technology, 2007, 21: 804-813
[2]	Jung Dongsoo, Chae Soonam, Bae Dongsoo, et al. Condensation heat transfer coefficient of binary HFC mixtures on low-fin tubes and Turbo-C tubes [J]. Int. J. of Refrigeration, 2005, 28: 212-217
[3]	Park Ki-Jung, Jung Dongsoo. External condensation heat transfer coefficients of R22 alternative refrigerants on enhanced tubes at three saturation temperatures [J]. Journal of Mechanical Engineering Science, 2008, 222: 987-994
[4]	Cheng Changrui(成昌锐),Wang Qiuwang(王秋旺),Liu Xing(刘星),Tao Wenquan(陶文铨). Experimental investigation on condensation heat transfer of R407C outside single horizontal tubes[J]. Journal of Engineering Thermophysics(工程热物理学报), 2001, 22(suppl.): 50-52
[5]	Jia Chuanlin(贾传林), Ouyang Xinping(欧阳新萍), Chen Jianhong(陈建红). Experimental investigation on condensation heat transfer of R22 and R417A outside horizontal enhanced tubes[J]. Journal of Refrigeration(制冷学报), 2009, 30(4): 31-35
[6]	Aprea C, Renno C. Experimental comparison of R22 with R417A performance in a vapour compression refrigeration plant subjected to a cold store [J]. Energy Conversion and Management, 2004, 11(45): 1807-1819
[7]	Jose Fernandez-Seara, Francisco J Uhia, Ruben Diz, et al. Vapour condensation of R22 retrofit substitutes R417A, R422A and R422D on Cu/Ni turbo C tubes [J]. Int. J. of Refrigeration, 2010, 33: 148-157
[8]	Zhang Dingcai(张定才), Zhao Anli(赵安利), Tian Songna(田松娜), Fan Xiaowei(范晓伟), Du Jiadi(杜佳迪). Characteristic comparison of condensation heat transfers outside the smooth and enhanced tubes when using R417A and R22[J]. Journal of Chemical Engineering of Chinese Universities(高校化学工程学报), 2012, 26(4): 587-592
[9]	Gnielinski V. New equations for heat and mass transfer in turbulent pipe and channel flow[J]. Int. Chem. Eng., 1976, 16 (2): 359-368
[10]	Yang Shiming(杨世铭), Tao Wenquan(陶文铨). Heat Transfer(传热学)[M]. Beijing: Higher Education Press, 2006: 505-506
[11]	Cheng B, Tao W Q. Experimental study of R152a film condensation on single horizontal smooth tube and enhanced tubes [J]. ASME J. Heat Transfer, 1994, 116(2): 266-270
[12]	Karlsson T, Vamling L. Reasons for drop in shell-and-tube condenser performance when replacing R22 with zeotropic mixtures (Ⅱ): Investigation of mass transfer resistance effects[J]. Int. J. of Refrigeration, 2004, 27: 561-566

[1]	晁京伟, 许嘉兴, 李廷贤. 基于无管束蒸发换热强化策略的吸附热池的供热性能研究[J]. 化工学报, 2023, 74(S1): 302-310.
[2]	程成, 段钟弟, 孙浩然, 胡海涛, 薛鸿祥. 表面微结构对析晶沉积特性影响的格子Boltzmann模拟[J]. 化工学报, 2023, 74(S1): 74-86.
[3]	苏伟, 马东旭, 金旭, 刘忠彦, 张小松. 表面润湿性对霜层传递特性影响可视化实验研究[J]. 化工学报, 2023, 74(S1): 122-131.
[4]	张双星, 刘舫辰, 张义飞, 杜文静. R-134a脉动热管相变蓄放热实验研究[J]. 化工学报, 2023, 74(S1): 165-171.
[5]	张义飞, 刘舫辰, 张双星, 杜文静. 超临界二氧化碳用印刷电路板式换热器性能分析[J]. 化工学报, 2023, 74(S1): 183-190.
[6]	陈爱强, 代艳奇, 刘悦, 刘斌, 吴翰铭. 基板温度对HFE7100液滴蒸发过程的影响研究[J]. 化工学报, 2023, 74(S1): 191-197.
[7]	刘明栖, 吴延鹏. 导光管直径和长度对传热影响的模拟分析[J]. 化工学报, 2023, 74(S1): 206-212.
[8]	王志国, 薛孟, 董芋双, 张田震, 秦晓凯, 韩强. 基于裂隙粗糙性表征方法的地热岩体热流耦合数值模拟与分析[J]. 化工学报, 2023, 74(S1): 223-234.
[9]	李艺彤, 郭航, 陈浩, 叶芳. 催化剂非均匀分布的质子交换膜燃料电池操作条件研究[J]. 化工学报, 2023, 74(9): 3831-3840.
[10]	王玉兵, 李杰, 詹宏波, 朱光亚, 张大林. R134a在菱形离散肋微小通道内的流动沸腾换热实验研究[J]. 化工学报, 2023, 74(9): 3797-3806.
[11]	齐聪, 丁子, 余杰, 汤茂清, 梁林. 基于选择吸收纳米薄膜的太阳能温差发电特性研究[J]. 化工学报, 2023, 74(9): 3921-3930.
[12]	李科, 文键, 忻碧平. 耦合蒸气冷却屏的真空多层绝热结构对液氢储罐自增压过程的影响机制研究[J]. 化工学报, 2023, 74(9): 3786-3796.
[13]	陈天华, 刘兆轩, 韩群, 张程宾, 李文明. 喷雾冷却换热强化研究进展及影响因素[J]. 化工学报, 2023, 74(8): 3149-3170.
[14]	杨越, 张丹, 郑巨淦, 涂茂萍, 杨庆忠. NaCl水溶液喷射闪蒸-掺混蒸发的实验研究[J]. 化工学报, 2023, 74(8): 3279-3291.
[15]	汪尔奇, 彭书舟, 杨震, 段远源. 含HFO混合体系气液相平衡的理论模型评价[J]. 化工学报, 2023, 74(8): 3216-3225.

R134a/R125混合工质水平管外凝结换热

Condensation heat transfer of mixed R134a/R125 outside horizontal tubes

PDF (PC)

可视化

被引次数

摘要/Abstract

引用本文

使用本文

参考文献 12

相关文章 15

编辑推荐

Metrics

本文评价