端面变形对液体动压型机械密封液膜瞬态特性的影响

doi:10.11949/j.issn.0438-1157.20161387

摘要/Abstract

摘要：

建立动环-液膜-静环动压型机械密封双向流固耦合模型，针对逆流泵送状态，对密封环及液膜流场进行非定常耦合计算，分析了密封环变形和液膜压力的瞬态特性，并通过流固耦合前后流场对比，分析了密封环端面变形对液膜压力脉动的影响。研究结果表明：与未考虑变形时相比，双向流固耦合计算结果更加符合实际；静环端面变形随时间呈周期性变化，且越靠近内径出口处，变形量的波动程度越大；密封环端面变形对外径处压力脉动影响较小，但会明显增强内径处压力脉动，且转速越大，压力脉动增强的程度越大，介质压力在压力较低的工况下对变形后液膜压力脉动程度的影响不明显；密封环端面的变形只影响压力脉动的程度，不改变压力脉动的频率。

关键词: 动压型机械密封, 双向流固耦合, 瞬态特性, 端面变形, 压力脉动, 稳定性, 微尺度

Abstract:

The two-way fluid-solid interaction model of rotating ring-fluid film-stationary ring was established in hydrodynamic mechanical seal. Unsteady simulations were carried on at the upstream pumping state. The transient characteristics of the deformation of sealing ring and the pressure of the fluid film were studied, and the influence of the end face deformation on the pressure fluctuation was discussed by comparing the results before and after fluid-solid interaction. The results show that comparing the simulation without the deformation, the results obtained by fluid-solid-interaction are more realistic. The end face deformations of stationary ring is fluctuating like pressure fluctuation with same period, and the closer to the outlet at the inner diameter, the greater degree of the deformation fluctuation. The degree of pressure fluctuation is from big to small from inner diameter to outer. The end face deformation of sealing ring affects the pressure fluctuation slightly at the outer diameter, while enhances the pressure fluctuation at the inner diameter obviously, and the degree of the enhancement is greater with the increase of rotational speed, the influence of the sealing medium pressure is not obvious under the low pressure condition after fluid-solid interaction. The end face deformation of the sealing ring only affects the degree of the pressure fluctuation without changing the frequency of the pressure fluctuation.

Key words: hydrodynamic mechanical seal, two-way fluid-solid interaction, transient characteristics, end face deformation, pressure fluctuation, stability, microscale

中图分类号:

TH136

陈汇龙, 李同, 任坤腾, 王彬, 赵斌娟. 端面变形对液体动压型机械密封液膜瞬态特性的影响[J]. 化工学报, 2017, 68(4): 1533-1541.

CHEN Huilong, LI Tong, REN Kunteng, WANG Bin, ZHAO Binjuan. Influence of end face deformation on transient characteristics of fluid film in hydrodynamic mechanical seal[J]. CIESC Journal, 2017, 68(4): 1533-1541.

参考文献 30

[1]	白军昌. 流体动压型机械密封研究进展[J]. 四川化工, 2012, 15(2):22-25.BAI J C. Progress in the study of the mechanical seals with hydrodynamic pressure[J]. Sichuan Chemical Industry, 2012, 15(2):22-25.
[2]	MILLER B A, WOODRUFF G W. Numerical formulation for the dynamic analysis of spiral-grooved gas face seals[J]. Journal of Tribology, 2001, 123(2):395-403.
[3]	MILLER B A, GREEN I. Semi-analytical dynamic analysis of spiral-grooved mechanical gas face seals[J]. Journal of Tribology, 2003, 125(2):403-413.
[4]	GREEN I. A transient dynamic analysis of mechanical seals including asperity contact and face deformation[J]. Tribology Transactions, 2002, 45(3):284-293.
[5]	GREEN I, BARNSBY R M. A parametric analysis of the transient forced response of noncontacting coned-face gas seals[J]. Journal of Tribology, 2002, 124(1):11-17.
[6]	SALANT R F, CAO B. Unsteady analysis of a mechanical seal using Duhamel's method[J]. Journal of Tribology, 2005, 127(3):1017-1023.
[7]	PFAU A, SCHLIENGER J, RUSCH D, et al. Unsteady flow interactions within the inlet cavity of a turbine rotor tip labyrinth seal[J]. Journal of Turbomachinery, 2005, 127(4):187-199.
[8]	SUAMANIAN S, SEKHAR A S, PRASAD B V S S S. Rotordynamic characteristics of rotating labyrinth gas turbine seal with centrifugal growth[J]. Tribology International, 2016, 97:349-359.
[9]	YAN X, HE K, LI J, et al. Rotordynamic performance prediction for surface-roughened seal using transient computational fluid dynamics and elliptical orbit model[J]. Proceedings of the Institution of Mechanical Engineers Part A. Journal of Power & Energy, 2012, 226(8):975-988.
[10]	孟祥铠, 彭旭东, 王乐勤. 瞬态启停机械密封轴对称动力学模型与密封行为分析[J]. 化工学报, 2011, 62(6):1620-1625.MENG X K, PENG X D, WANG L Q. Axisymmetric dynamic model and seal behavior analysis of mechanical seals during startup and shutdown operation[J]. CIESC Journal, 2011, 62(6):1620-1625.
[11]	方艳峰, 彭旭东, 孟祥铠, 等. 介质温升条件下流体静压型机械密封的瞬态响应研究[J]. 润滑与密封, 2010, 35(12):32-35.FANG Y F, PENG X D, MENG X K, et al. Research on transient response of a hydrostatic mechanical seal during sealed medium temperature rise[J]. Lubrication Engineering, 2010, 35(12):32-35.
[12]	GAO B C, MENG X K, SHEN M X, et al. Transient thermal-mechanical coupling behavior analysis of mechanical seals during start-up operation[J]. Materials Science and Engineering, 2016, 129(1):12025-12035.
[13]	严国平, 刘正林. 交变载荷作用下端面密封瞬态耦合特性分析[J]. 计算力学学报, 2012, 29(4):551-555.YAN G P, LIU Z L. Transient coupled characteristics study on mechanical seals end faces under the alternative load function[J]. Chinese Journal of Computational Mechanics, 2012, 29(4):551-555.
[14]	王技德, 张国渊. 非接触机械密封的非线性动特性系数及瞬态振动响应分析[J]. 中国机械工程, 2012, 23(6):642-646.WANG J D, ZHANG G Y. Study on nonlinear dynamic coefficients and transient vibration response for a non-contact mechanical seal[J]. China Mechanical Engineering, 2012, 23(6):642-646.
[15]	ZHANG H, ZHENG Q, YUE G, et al. Unsteady numerical analysis of a whole ring of finger seal with grooves on finger pads[C]//ASME Turbo Expo 2013:Turbine Technical Conference and Exposition. 2013:V03AT15A008-V03AT15A008.
[16]	HU S T, HUANG W F, LIU X F, et al. Influence analysis of secondary O-ring seals in dynamic behavior of spiral groove gas face seals[J]. Chinese Journal of Mechanical Engineering, 2016, 29(3):507-514.
[17]	CHEN H L, XU C, WU Q B, et al. The fluid-structure interaction study of spiral groove upstream pumping mechanical seal[C]//ISFMFE-6th, International Symposium on Fluid Machinery and Fluid Engineering. IET, 2014.
[18]	李宁, 穆塔里夫·阿赫迈德, 王广朋. 螺旋槽机械密封液膜流场的动力特性分析[J]. 机床与液压, 2016, 44(1):10-13.LI N, MUTELLIP A, WANG G P. Analysis of the flow field dynamic characteristics of fluid-film for spring groove mechanical seal[J]. Machine Tool & Hydraulics, 2016, 44(1):10-13.
[19]	陈汇龙, 刘玉辉, 赵斌娟, 等. 基于流固耦合上游泵送机械密封的变形分析[J]. 江苏大学学报(自然科学版), 2014, 35(1):25-28.CHEN H L, LIU Y H, ZHAO B J, et al. Deformation analysis of upstream pumping mechanical seals based on one-way fluid-solid coupling[J]. Journal of Jiangsu University (Natural Science Edition), 2014, 35(1):25-28.
[20]	杨丹丹, 郝木明, 张元, 等. 高温泵用液膜密封流热固耦合分析[J]. 应用数学和力学, 2015, 36(3):274-284.YANG D D, HAO M M, ZHANG Y, et al. Fluid-solid-heat coupling study on liquid film seal for high temperature oil pumps[J]. Applied Mathematics and Mechanics, 2015, 36(3):274-284.
[21]	CHEN H L, ZUO M Z, WU Q B, et al. The thermal and mechanical deformation study of up-stream pumping mechanical seal[C]//IOP Conference Series Materials Science and Engineering. London, 2015:042032.
[22]	SASSO M, CHIAPPINI G, ROSSI M, et al. Structural analysis of an elastomeric bellow seal in unsteady conditions:simulations and experiments[J]. International Journal of Mechanics & Materials in Design, 2016:1-16.
[23]	陈汇龙, 付杰, 李述林, 等. 螺旋槽上游泵送机械密封端面间液膜压力脉动特性[J]. 排灌机械工程学报, 2015, 33(6):504-509.CHEN H L, FU J, LI S L, et al. Pressure fluctuation characteristic of mechanical face sealing clearance of spiral groove in upstream pumping[J]. Journal of Drainage and Irrigation Machinery Engineering, 2015, 33(6):504-509.
[24]	陈汇龙, 王强, 李雯瑜, 等. 基于Fluent的螺旋槽上游泵送机械密封三维微间隙流场数值模拟[J]. 润滑与密封, 2012, 37(2):16-19,28,33.CHEN H L, WANG Q, LI W Y, et al. Numerical simulation of 3-D flow in upstream pumping mechanical seals with spiral grooves based on Fluent[J]. Lubrication Engineering, 2012, 37(2):16-19,28,33.
[25]	陈汇龙, 王彬, 任坤腾, 等. 空化热效应对上游泵送机械密封润滑性能的影响[J]. 化工学报, 2016, 67(10):4334-4343.CHEN H L, WANG B, REN K T, et al. Influence of cavitation thermal effect on lubrication properties of upstream pumping mechanical seal[J]. CIESC Journal, 2016, 67(10):4334-4343.
[26]	陈汇龙, 刘玉辉, 刘彤, 等. 基于动网格的上游泵送机械密封性能参数分析[J]. 排灌机械工程学报, 2012, 30(5):583-587.CHEN H L, LIU Y H, LIU T, et al. Analyzing performance parameters of upstream pumping mechanical seals based on dynamic mesh technique[J]. Journal of Drainage and Irrigation Machinery Engineering, 2012, 30(5):583-587.
[27]	CHEN H L, WU Q B, XU C, et al. Research on cavitation regions of upstream pumping mechanical seal based on dynamic mesh technique[J]. Advances in Mechanical Engineering, 2014, 2014(11):1-8.
[28]	刘玉辉. 上游泵送机械密封的性能及流固耦合研究[D]. 镇江:江苏大学, 2013.LIU Y H. Study on performance and fluid-solid coupling with the upstream pumping mechanical seal[D]. Zhenjiang:Jiangsu University, 2013.
[29]	郑源, 陈宇杰, 毛秀丽, 等. 混流泵压力脉动特性及其对流动诱导噪声的影响[J]. 农业工程学报, 2015, 31(23):67-73.ZHENG Y, CHEN Y J, MAO X L, et al. Pressure pulsation characteristics and its impact on flow-induced noise in mixed-flow pump[J]. Transactions of the Chinese Society of Agricultural Engineering, 2015, 31(23):67-73.
[30]	吴强波. 液膜润滑动压型机械密封空化特性研究[D]. 镇江:江苏大学, 2015.WU Q B. Research on cavitation characteristics of liquid film lubricated hydrodynamic mechanical seal[D]. Zhenjiang:Jiangsu University, 2015.