旋流强化中空纤维膜组件结构优化及壳程流动研究

doi:10.11949/j.issn.0438-1157.20180706

摘要/Abstract

摘要：

提出并优化了一种旋转流强化的膜组件水力学模型。Box-Behnken方法用于进口直径、进口长度、膜壳高度、进/出口端管长度、球突结构直径，进出口倾斜角度的多参数的实验设计，获得了响应变量最优的膜组件设计方案。通过雷诺应力RSM湍流模型与基于Euler-Lagrange算法的离散相DPM模型的耦合计算，模拟研究了三维模型内液固两相流的颗粒停留时间分布、流体力学特征。模拟结果显示，旋流强化的膜组件壳程的速度分布更加均匀，膜面剪切应力高；湍流耗散率、涡量分布不同于传统膜组件。实验结果证实，优化后的膜组件具有高产水量、低压力降，膜污染速率低的特点。

关键词: 计算流体力学, 优化, 过滤, Box-Behnken方法, 结垢

Abstract:

A hydrodynamic model of membrane assembly strengthened by rotating flow is proposed and optimized. The Box-Behnken method is used for multi-parameters experimental design with parameters of inlet diameter, inlet length, shell tube height, inlet/outlet and tube height, inlet-outlet tube horizontal inclined angle θ, inlet-outlet and ring protuberance radian, the membrane module design schematic is obtained by optimized response variants. By coupling the Reynolds stress turbulence model (RSM) with the discrete phase model based on the Euler-Lagrangian discrete phase model (DPM), the residence time distribution and the fluid mechanical properties of the liquid-solid two-phase flow in the three-dimensional model were simulated. The simulation results show that the shell-side velocity distribution of the optimized membrane module is more uniform, the turbulent flow dissipation rate is lower, and the shear stress distribution and vorticity distribution are different from the traditional membrane modules. The experimental results confirm that the optimized membrane module has higher water yield, lower pressure drop and lower membrane fouling rate.

Key words: computational fluid dynamics, optimization, filtration, Box-Behnken method, fouling

中图分类号:

TQ028.5

张婷, 李传玺, 郭凯, 张会书, 冯爱国, 刘春江. 旋流强化中空纤维膜组件结构优化及壳程流动研究[J]. 化工学报, 2018, 69(11): 4663-4674.

ZHANG Ting, LI Chuanxi, GUO Kai, ZHANG Huishu, FENG Aiguo, LIU Chunjiang. Swirling flow enhanced hollow fiber membrane module structure optimization and shell-side hydrodynamics investigation[J]. CIESC Journal, 2018, 69(11): 4663-4674.

参考文献 35

[1]	WANG L K, CHEN J P P, HUNG Y T, et al. Membrane and Desalination Technologies-Volume 13 Handbook of Environmental Engineering[M]. Springer Humana Press, 2011.
[2]	SIBANDA P, KHIDIR A A. Fouling in membrane filtration and remediation methods[M]//Mass Transfer-Advances in Sustainable Energy and Environment Oriented Numerical Modeling, In Tech, 2013:195-218.
[3]	CAI J J, HAWBOLDT K, ABDI M A. Analysis of the effect of module design on gas absorption in cross flow hollow membrane contactors via computational fluid dynamics (CFD) analysis[J]. J. Membr. Sci., 2016, 520:415-424.
[4]	熊长川, 李卫星, 刘业飞, 等. 柱式膜组件结构的CFD优化设计[J]. 化工学报, 2017, 68(11):4341-4350. XIONG C C, LI W X, LIU Y F, et al. Column membrane module CFD optimal design[J]. CIESC Journal, 2017, 68(11):4341-4350.
[5]	ZYDNEY A L, COLTO C K. A concentration polarization model for the filtrate flux in cross-flow microfiltration of particulate suspensions[J]. Chem. Eng. Commun., 1986, 47(a):1-21.
[6]	AKOUM O A, BONIN M M D, FONADE C, et al. Comparison of three different systems used for flux enhancement:application to crossflow filtration of yeast suspensions[J]. Desalination, 2002, 147:31-36.
[7]	庄黎伟, 戴干策. 中空纤维膜外压全量过滤动态过程的数值模拟[J]. 化工学报, 2016, 67(7):2841-2850. ZHUANG L W, DAI G C. Hollow fiber membrane out-in filtration dynamic processes simulation[J]. CIESC Journal, 2016, 67(7):2841-2850.
[8]	BAKER R J, FANE A G, FELL C J D, et al. Factors affecting flux in crossflow filtration[J]. Desalination, 1985, 53:81-93.
[9]	PAUL E, OCHOA J C, PECHAUD Y, LIU Y, et al. Effect of shear stress and growth conditions on detachment and physical properties of biofilm[J]. Water Research, 2012, 46:5499-5508.
[10]	JI P, MOTIN A, SHAN W, et al. Dynamic crossflow filtration with a rotating tubular membrane:using centripetal force to decrease fouling by buoyant particles[J]. Chemical Engineering Research and Design, 2016, 106:101-114.
[11]	HEATHER E W, ROBERT C A, PIERRE R B. Surface shear stress and membrane fouling when considering natural water matrices[J]. Desalination, 2013, 330:22-27.
[12]	CHAN C C, BERUBE P R, HALL E. Relationship between types of surface shear stress profiles and membrane fouling[J]. Water Research, 2011, 45:6403-6406.
[13]	李露, 徐国荣, 邵天宝, 等. 海水淡化纳滤工艺的性能模拟与优化[J]. 净水技术, 2017, 36(10):64-69. LI L, XU G R, SHAO T B, et al. Seawater desalination nano-filtration process simulation and optimization[J]. Water Purification Technology, 2017, 36(10):64-69.
[14]	钱伶琤, 雷晓玲, 何栋奎. 超滤膜系统内部结构对膜过滤性能的影响[J]. 净水技术, 2012, 31(5):42-45. QIAN L Z, LEI X L, HE D K. Ultra-filtration system configuration on filtration performance[J]. Water Purification Technology, 2012, 31(5):42-45.
[15]	庄黎伟. 中空纤维膜组件中流动均布模型与模拟[D]. 上海:华东理工大学, 2016. ZHUANG L W. Hollow fiber membrane module flow distribution model and simulation[D]. Shanghai:East China University of Science and Technology, 2016.
[16]	杨毅, 王保国, 彭勇. 中空纤维膜组件壳程流动的数值模拟[J]. 化工学报, 2008, 59(8):1979-1985. YANG Y, WANG B G, PENG Y. Hollow fiber membrane module shell-side flow dynamics simulation[J]. Journal of Chemical Industry and Engineering (China), 2008, 59(8):1979-1985.
[17]	李卜义, 王建友, 王济虎, 等. 中空纤维空气隙式膜蒸馏海水淡化过程的性能模拟与优化[J]. 化工学报, 2015, 66(2):597-604. LI B Y, WANG J Y, WANG J H, et al. Hollow fiber membrane distillation seawater desalination process simulation and optimization[J]. CIESC Journal, 2015, 66(2):597-604.
[18]	王伟生, 卢卫群, 纪烈勇, 等. 基于DPM模型的立磨局部流场数值模拟分析[J]. 机械设计, 2014, 11:68-72. WANG W S, LU W Q, JI L Y, et al. Simulation analysis of vertical mill flow fields based on DPM methodology[J]. Journal of Machine Design, 2014, 11:68-72.
[19]	LEBERRE O, DAUFIN G. Crossflow microfiltration performance versus permeation flux to wall shear stress ratio[J]. J. Membr. Sci., 1996, 117(1/2):261-270.
[20]	刘志华, 董文才, 夏飞. V型沟槽尖峰形状对减阻效果及流场特性影响的数值分析[J].水动力学研究与进展, 2006, 21(2):223-231. LIU Z H, DONG W C, XIA F. V shape drag reduction effects and flow fields characterization simulation[J]. Journal of Hydrodynamics, 2006, 21(2):223-231.
[21]	OCHOA J, COUFORT C, ESUDIE R, LINE A, et al. Influence of non-uniform distribution of shear stress on aerobic biofilms[J]. Chem. Eng. Sci., 2007, 62(14):3672-3684.
[22]	SARKAR A, MOULIK S, SARKAR D, et al. Performance characterization and CFD analysis of a novel shear enhanced membrane module in ultrafiltration of Bovine Serum Albumin (BSA)[J]. Desalination, 2012, 292:53-63.
[23]	OCHOA J C, COUFORT C, ESCUDIE R, et al. Influence of non-uniform distribution of shear stress on aerobic biofilms[J]. Chemical Engineering Science, 2007, 62:3672-3684.
[24]	BOX G E P, DRAPER N P. Empirical Model Building and Response Surfaces[M]. New York:John Wiley and Sons, 1987:477.
[25]	THOMAS O M, JAOUEN P, LEGENTILHOMME P. Modeling of fouling in three ultrafiltration cell configurations:swirl, plane and axial annular[J]. Chem. Eng. Technol., 2001, 24:1165-1172.
[26]	FOKEER S, LOWNDES I S, HARGREAVES D M. Numerical modelling of swirl flow induced by a three-lobed helical pipe[J]. Chem. Eng. Process., 2010, 49:536-546.
[27]	ARIYARATNE C, JONES T. Design and optimization of swirl pipe geometry for particle-laden liquids[J]. AIChE Journal, 2007, 53:757-768.
[28]	BUO B Y, TIM A G, LANGRISH D F F. CFD simulation of precession in sudden pipe expansion flows with low inlet swirl[J]. Appl. Math. Modelling, 2002, 26:1-15.
[29]	MITSUYA S, HIROKAZU M, NISHIYAMA K, et al. Swirl-flow membrane emulsification for high throughput of dispersed phase flux through Shirasu porous glass (SPG) membrane[J]. J. Chem. Eng. JPN, 2011, 44:1-6.
[30]	时均, 袁权, 高从堦. 膜技术手册[M]. 北京:化学工业出版社, 2001:807-815. SHI J, YUAN Q, GAO C J. Membrane Technology Manual[M]. Beijing:Chemical Industry Press, 2001:807-815.
[31]	刘为, 曾作祥, 薛为岚, 等. 错流超滤膜污染模型[J]. 华东理工大学学报, 2005, 31(5):589-592. LIU W, ZENG Z X, XUE W L, et al. Cross-flow ultr-filtration membrane fouling models[J]. Journal of East China University of Science and Technology, 2005, 31(5):589-592.
[32]	李俊, 奚旦立, 石勇. 动态膜处理污水时阻力分布及污染机理[J]. 化工学报, 2008, 59(9):2309-2315. LI J, XI D L, SHI Y. Dynamic membrane filtration resistance force distribution and fouling mechanism[J]. Journal of Chemical Industry and Engineering(China), 2008, 59(9):2309-2315.
[33]	杜敏. 进水口漩涡形成机理及缩尺效应[D]. 天津:天津大学, 2008. DU M. Entrance vortices formation mechanism and scale effects[D]. Tianjin:Tianjin University, 2008.
[34]	叶飞. 非稳态漩涡运动及其产生机理[D]. 天津:天津大学, 2010. YE F. Unsteady vortices motion and formation mechanism[D]. Tianjin:Tianjin University, 2010.
[35]	DELGADO S, VILARROEL R, GONZALEZ E. Effect of the shear intensity on fouling in submerged membrane bioreactor for wastewater treatment[J]. J. Membr. Sci., 2008, 311:173-181.